Resources
A ball is pressed against a horizontal spring with spring constant , compressing the spring by from its equilibrium position. When released from rest, the spring expands, launching the ball along a frictionless horizontal platform that terminates at the edge of a cliff of height above flat ground. The ball leaves the edge horizontally, entering projectile motion. Take . Determine: (a) the work done by the spring on the ball, (b) the horizontal launch speed as the ball leaves the cliff, and (c) the total kinetic energy of the ball right before it strikes the ground.
Answer and steps
Final answer
(a) ; (b) ; (c)
Steps
Part (a): Work Done by the Spring on the Ball
The work done by an ideal spring as it expands from a compression back to its equilibrium position is equal to the elastic potential energy initially stored in the spring:
Substitute the given values and :
Part (b): Horizontal Launch Speed
Because the horizontal surface is frictionless, the work done by the spring is entirely converted into the ball's kinetic energy as it leaves the spring:
Solve for the launch speed :
Substitute and :
Pitfall: Do not round intermediate values excessively before finding ; retaining prevents rounding error.
Part (c): Total Kinetic Energy Right Before Ground Impact
After leaving the platform, the ball falls under gravity with no air resistance. By the work-energy theorem, the change in kinetic energy equals the work done by gravity:
Since :
- Calculate the gravitational work (or loss in gravitational potential energy):
- Sum the initial kinetic energy and the work done by gravity:
Alternative method: One could compute the vertical impact velocity and find the final speed , then evaluate . Applying energy conservation directly bypasses finding vector components.
Typical errors
01 The student forgets to square the compression distance in the elastic potential energy formula, calculating W = (1/2)k(Δx) instead of (1/2)k(Δx)².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You forgot to square the displacement in the spring work formula. The work done by an ideal spring expanding from compression is , not .
- Step 2Correct
Your algebraic setup and conversion from work to kinetic energy were completely correct, but substituting your earlier value of instead of led to an incorrect speed.
- Step 3Correct
Your application of the work-energy theorem for the falling projectile and your evaluation of the gravitational potential energy change were accurate, but the result inherited the incorrect spring work from part (a).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly related the work done on the horizontal surface directly to the ball's kinetic energy.
You accurately solved for the launch velocity by isolating .
You correctly applied energy conservation during the projectile phase by adding the gravitational work to the initial kinetic energy.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote without the square on , which represents half the restoring force rather than the stored elastic energy.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing Hooke's law for force, , with the integral of force over displacement for work and potential energy, . Checking units is a helpful safeguard: gives force, whereas energy requires .
REASONING PATH
Your ACEpath teacher’s suggested approach- Spring Energy vs. Spring Force
Hooke's law gives the restoring force magnitude as (units of ), whereas elastic potential energy is (units of ).
Always verify that the displacement is squared whenever you calculate work or stored energy for an elastic spring.
- Dimensional Unit Check
Work and energy must have dimensions of force times distance: .
If you multiply by alone, you get , which tells you immediately that an extra meter unit is missing.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the work done by the spring with displacement squared: .
Substitute into the launch speed equation: .
Add the gravitational work to : .
(a) ; (b) ; (c)
02 The student confuses total kinetic energy before impact with only the kinetic energy gained from the vertical fall, omitting the initial horizontal kinetic energy.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You calculated the change in gravitational potential energy , but you set that equal to the total final kinetic energy rather than adding it to the initial kinetic energy .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the elastic energy formula to calculate the work done by the spring.
You correctly set up the work-energy relation on the horizontal track to find the launch speed.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated the final kinetic energy directly to the gravitational potential energy lost during the fall () instead of applying .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the change in kinetic energy () with the total final kinetic energy (). Because the ball is already moving horizontally when it leaves the cliff, it carries non-zero initial kinetic energy into the fall.
REASONING PATH
Your ACEpath teacher’s suggested approach- Conservation of Mechanical Energy
Always write out the full energy balance between the launch point and the impact point, including both initial kinetic and potential energies.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the work-energy theorem for the flight phase: .
Substitute the values: .
Sum the two energy contributions to find total kinetic energy: .
(a) ; (b) ; (c)
03 The student omits the factor of 1/2 in the kinetic energy formula when solving for the horizontal launch velocity, writing m*v₀² = W.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You equated the work to instead of the standard kinetic energy expression , missing the factor of inside the square root.
- Step 3Correct
Your energy conservation relation is conceptually correct, but substituting your erroneous value caused the final kinetic energy to be calculated as instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the formula for elastic potential energy to find the spring work.
You recognized that the work done by the spring converts into kinetic energy at launch.
You correctly set up the gravitational potential energy transfer using to find total kinetic energy at ground impact.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of , omitting the coefficient .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing kinetic energy with momentum squared over mass () or forgetting the standard fractional coefficient when equating work to kinetic energy.
REASONING PATH
Your ACEpath teacher’s suggested approach- Kinetic Energy Definition
Translational kinetic energy is always defined as .
Always write down the full expression before rearranging for velocity.
- Direct Energy Substitution
By conservation of energy, the horizontal kinetic energy leaving the spring is identically equal to the work done by the spring: .
When finding , substitute directly for rather than recalculating from a rounded velocity.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the work-energy theorem: .
Solve for : .
Apply energy conservation for part (c): .
(a) ; (b) ; (c)
Lock it in
What is the correct formula for the elastic potential energy stored in an ideal spring compressed by ?
. Remember that displacement must be squared to yield units of energy (Joules).
Similar question
A toy car is pushed against a horizontal spring with spring constant , compressing it by . Assuming a frictionless track, find (a) the work done by the spring when released and (b) the car's speed after leaving the spring.
Answer
(a) ; (b) . Key steps: . Then, .
A block is launched horizontally off a high frictionless table by a spring () compressed by . Taking , find the total kinetic energy of the block immediately before it hits the floor.
Answer
. Key steps: . Work done by gravity is . Total kinetic energy is .
A horizontal spring with launches a object across a rough horizontal table of length with coefficient of kinetic friction . If the spring was initially compressed by , find the speed of the object as it flies off the edge of the table. (Take )
Answer
. Key steps: Stored spring energy is . Thermal energy lost to friction is . Kinetic energy at the edge is . Launch speed is .