Resources
A laser beam propagating inside an unknown transparent liquid strikes the flat planar boundary with water () at an angle of incidence of measured relative to the interface normal. The beam refracts into the water at an angle of refraction of . Determine the index of refraction of the unknown liquid.
Answer and steps
Final answer
Steps
Identify the given parameters
To find the index of refraction of the unknown liquid, apply Snell's Law of Refraction, which relates the refractive indices of two media to the angles of incidence and refraction:
- Medium 1 (unknown liquid):
- Refractive index:
- Angle of incidence:
- Medium 2 (water):
- Refractive index:
- Angle of refraction:
(Note: Both angles are already defined relative to the normal to the interface, which is the standard definition used in Snell's Law. A common pitfall is using the grazing angle between the beam and the interface surface itself, which would require subtracting from .)
Rearrange Snell's Law for
Isolate :
Calculate the values
Evaluate the sine of each angle:
Substitute these values into the equation:
Thus, the index of refraction of the unknown liquid is .
Typical errors
01 The student inverts Snell's law by cross-matching the refractive indices and angles as n_liquid * sin(θ_2) = n_water * sin(θ_1), resulting in n_liquid ≈ 1.09.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Snell's Law pairs the refractive index of a medium directly with the angle of the light ray inside that same medium: . You paired with and with .
- Step 2Correct
Your algebraic rearrangement and calculation of the sine values were carried out correctly, but the fraction is inverted due to the swapped pairing in Step 1.
- Step 3Correct
This result follows directly from the earlier inverted ratio.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the relevant values for the angles and the refractive index of water.
You evaluated and accurately to four decimal places.
You carried out clean algebraic isolation of the unknown variable.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou paired each medium's refractive index with the angle from the opposing medium () instead of pairing the index with the ray angle in the same medium ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Pairing rule for Snell's Law
Each side of Snell's Law represents a single medium: .
Always label medium 1 with and medium 2 with before substituting into .
- Qualitative sanity check
When a ray bends away from the normal (), light is entering an optically less dense medium ().
Check that since , the liquid must be optically denser than water, meaning .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Snell's Law matching index and angle within each medium:
Isolate :
Compute the final value:
02 The student incorrectly uses the ratio of angles directly instead of the ratio of the sines of the angles in Snell's law, obtaining n_liquid ≈ 1.69.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Snell's Law relates the refractive indices to the sines of the angles, , not directly to the angles themselves.
- Step 2Correct
Your algebra and calculation were carried out consistently from your formula, but the result is affected by omitting the sine functions in the first step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly paired each refractive index with its corresponding angle measured from the normal.
You solved for the unknown index of refraction algebraically with clean arithmetic.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the law of refraction as a direct linear proportionality between indices and angles rather than using the trigonometric relationship defined by wave boundary conditions in Snell's Law. While holds as a small-angle approximation (in radians) for paraxial rays, standard refraction problems require taking the sine of each angle.
REASONING PATH
Your ACEpath teacher’s suggested approach- Snell's Law Formula
Refraction across an interface obeys , where both angles are measured from the surface normal.
Always verify that the sine function is applied to both the incident and refracted angles before solving.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Snell's Law:
Evaluate the trigonometric values: and
Isolate :
03 The student evaluates the trigonometric functions with a calculator set to radian mode instead of degree mode, yielding a negative index of refraction of approximately 1.25.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You calculated the trigonometric values in radians rather than degrees: and . Because the angles are given in degrees, evaluating in degree mode gives and .
- Step 3Correct
Your final calculation followed algebraically from your intermediate values, but the result is incorrect due to the angle-mode error in Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied Snell's Law of Refraction.
You properly matched each refractive index to its corresponding angle of incidence and refraction relative to the normal.
You correctly rearranged the linear equation algebraically to solve for the unknown.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou evaluated trigonometric functions with your calculator in radian mode instead of degree mode.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking calculator angular unit mode when solving geometric optics problems where angles are provided in degrees, resulting in unintended negative sine values.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Angle Mode
Whenever angles are specified with the degree symbol (), your calculator must be in DEG mode.
Verify before calculating: . If you get , your calculator is in RAD mode.
- Sanity Check Sine Values
For any acute angle , must be strictly positive.
If you obtain a negative sine value for an angle between and , switch your calculator mode immediately.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet the calculator to Degree mode (DEG).
Compute and .
Substitute these values into Snell's Law: .
Lock it in
What is the standard algebraic form of Snell's Law across an interface between medium 1 and medium 2?
. Memory cue: Each side of the equation belongs entirely to one medium.
Similar question
A light ray in crown glass () strikes an interface with air () at an angle of incidence of relative to the normal. Find the angle of refraction in air.
Answer
. Using Snell's Law: .
A beam of light traveling through an unknown oil strikes a flat boundary with flint glass () at an angle of incidence of . The angle of refraction inside the glass is . Calculate the refractive index of the oil.
Answer
. Setting up Snell's Law: .
A ray of light originates in ethanol () and refracts into diamond (). If the angle inside the diamond is measured to be from the normal, determine the angle of incidence in ethanol and verify whether the ray bent toward or away from the normal.
Answer
; the ray bent toward the normal upon entering diamond. Using .