Resources
A thermodynamic cycle operates between a heat source at and a sink at . The engine extracts from the hot source per cycle. According to the Clausius inequality and the Second Law of Thermodynamics: (a) determine the exact threshold minimum amount of heat that must be exhausted to the cold sink for the process to be reversible, (b) evaluate the condition on that defines the boundary between physically realizable irreversible processes and strictly forbidden impossible processes, and (c) calculate the total entropy change when .
Answer and steps
Final answer
(a) ; (b) For physical irreversibility, ; any engine exhausting yields , violating the Second Law; (c)
Steps
Part (a): Minimum Heat Exhausted for a Reversible Process
For any complete thermodynamic cycle, the state of the working substance returns to its initial condition, meaning the entropy change of the system over one cycle is zero:
According to the Clausius theorem, a cycle is reversible if and only if the cyclic integral of entropy transfer is zero:
Solving for the minimum heat rejected, :
Substitute the given numerical values:
Part (b): Boundary Condition for Physical Realizability
The Clausius inequality governs cyclic heat engines operating between two thermal reservoirs:
Rearranging this expression gives the required condition on :
- Physically Realizable Irreversible Process: When real internal or external dissipations (irreversibilities) occur, entropy is generated inside the universe (). This requires:
- Impossible Process: If an engine were to exhaust , the cyclic integral would be strictly positive: This would decrease the entropy of an isolated system, which directly violates the Second Law of Thermodynamics. Therefore, serves as the sharp threshold boundary.
Part (c): Total Entropy Change of the Universe
The universe consists of the cyclic engine and the two reservoirs (hot source and cold sink):
Because the engine executes a closed thermodynamic cycle, . The reservoirs are assumed to be sufficiently large that heat exchange occurs reversibly at constant temperatures:
Summing these contributions yields the total entropy change:
Since , the process is confirmed to be an irreversible and physically realizable real-world process.
Typical errors
01 The student inverts the temperature ratio when solving for the minimum rejected heat, leading to an impossible threshold greater than the heat absorbed.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
When isolating by multiplying both sides by , the ratio should be , not . Because , a heat engine exhausts less heat than it absorbs (), so violates conservation of energy for an engine delivering work.
- Step 3Correct
Your qualitative reasoning about the Clausius inequality and the Second Law boundary is correct, but your threshold value was affected by the algebraic inversion from the previous step.
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that a reversible cycle requires zero net entropy change.
You correctly applied the Clausius inequality criteria to distinguish realizable and impossible processes.
You accurately calculated the entropy change of the universe in part (c).
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally multiplied by the reciprocal temperature ratio instead of when clearing the denominator.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisLosing track of physical sanity checks during algebraic manipulation. In a heat engine, thermal efficiency requires whenever . An answer where indicates an immediate physical impossibility for an engine absorbing only .
REASONING PATH
Your ACEpath teacher’s suggested approach- Clear Denominators Carefully
If , then multiplying both sides by gives .
Always circle the variable being isolated and verify which factor moves to the numerator.
- Heat Engine Sanity Check
For a heat engine producing positive work, conservation of energy requires , meaning .
Check whether your calculated rejected heat is strictly smaller than the input heat before moving to the next part.
CORRECTED PATH
ACEpath Teacher's DemonstrationStart from your correct reversible relation: .
Multiply both sides by : .
Substitute the numerical values: .
Apply this threshold to part (b): is the boundary; yields (realizable irreversible), while yields (impossible).
(a) ; (b) Boundary is , with for irreversible processes and impossible; (c)
02 The student reverses the sign of entropy changes by treating heat extraction from the hot reservoir as positive entropy change, resulting in a negative total entropy change.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
for realizable processes, so the boundary is ; is irreversible, and is impossible
- Step 3Correct
You confused the cyclic integral of the working fluid with the entropy change of the universe. Because heat leaves the hot reservoir, , and because heat enters the cold reservoir, . Adding them gives .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly derived the minimum reversible heat rejection .
You accurately established the boundary conditions separating irreversible and impossible cycles using the Clausius inequality.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou equated with the cyclic engine integral , inadvertently inverting the signs of heat transfer from the reservoirs' perspective. Heat leaving a reservoir reduces its entropy (), while heat entering increases its entropy ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Reservoir Perspective Sign Convention
For a thermal reservoir exchanging heat , .
Assign a negative sign when heat leaves the source () and a positive sign when heat enters the sink ().
- Total Entropy of the Universe
For a cyclic engine, , so for any spontaneous or real process.
Check that your computed is strictly positive for any real irreversible cycle.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the universe entropy balance:
Substitute for the complete cycle:
Evaluate numerically:
(a) ; (b) is irreversible, while is impossible; (c)
03 The student confuses the direction of the inequality, concluding that physically realizable processes require less heat rejection than the reversible threshold.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
Realizable processes must have . The boundary is , where is irreversible and is impossible.
Correct, where is physically realizable (irreversible), is reversible, and is impossible.
By the Clausius inequality, , which rearranges to , or . An engine exhausting would produce an efficiency greater than Carnot efficiency and cause , which is strictly forbidden by the Second Law of Thermodynamics.
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the reversible threshold .
You accurately set up and evaluated the reservoir entropy balance to determine .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou likely associated higher real-world energy loss or dissipation with smaller heat rejection instead of realizing that real irreversible engines are less efficient and therefore must dump more waste heat () into the cold reservoir to guarantee .
REASONING PATH
Your ACEpath teacher’s suggested approach- Clausius Inequality Sign Convention
For any cyclic heat engine receiving at and dumping at , the Clausius inequality states .
Always isolate the unknown quantity by keeping track of the negative sign on rejected heat: implies .
- Carnot Efficiency Bound
A reversible engine achieves maximum possible efficiency . An irreversible engine has .
Check your inequality against efficiency: higher work / lower rejected heat () corresponds to , which is impossible.
CORRECTED PATH
ACEpath Teacher's DemonstrationState the Clausius inequality for a two-reservoir heat engine: .
Add to both sides: .
Multiply both sides by : .
Classify the regimes: is reversible, generates entropy (irreversible and physically realizable), and destroys entropy (impossible).
(a) ; (b) Realizable irreversible processes require , with as the reversible boundary; is impossible; (c)
Lock it in
For a Carnot heat engine operating between and (), what is the relationship between and ?
. Because , the heat exhausted must always be strictly less than the heat absorbed .
Similar question
A reversible heat engine absorbs from a reservoir at and exhausts heat to a reservoir at . Calculate the minimum heat rejected and the net work produced per cycle.
Answer
, . Key steps: ; .
A cyclic heat engine operates between and , absorbing of heat from the hot reservoir. An inventor claims the engine produces of mechanical work per cycle. Using the Clausius inequality and the Second Law, determine if this claim is physically possible.
Answer
Impossible. Key steps: By energy conservation, rejected heat is . The minimum heat rejection for a reversible engine is . Since (), the net entropy change of the universe would be , violating the Second Law.
A real heat engine absorbs from a source at and rejects to a sink at . (a) Calculate the entropy change of the universe . (b) Determine the maximum theoretical work this engine could have produced, and calculate the lost work due to irreversibility ().
Answer
(a) ; (b) , . Key steps: . Reversible heat rejection is , giving . Actual work is . Lost work is , which exactly matches .