Resources
In a ballistic pendulum apparatus, a lead pellet of mass is fired horizontally into a wooden pendulum block of mass initially suspended at rest. The pellet embeds completely into the block in an inelastic collision. The block and embedded pellet then swing upward through a vertical height of before momentarily coming to rest. Assuming and air resistance is negligible, reverse-engineer the initial launch speed of the pellet just prior to impact.
Answer and steps
Final answer
Steps
Convert units to SI
The operation of a ballistic pendulum consists of two distinct stages:
- The Collision (Stage 1): The pellet embeds into the block. This is a completely inelastic collision where linear momentum is conserved, but mechanical energy is not conserved due to deformation and thermal dissipation.
- The Swing (Stage 2): The combined mass swings upward to a maximum height . During this stage, only gravity does work, so mechanical energy is conserved. To determine the initial launch speed , we analyze the motion in reverse order.
- Mass of the pellet:
- Mass of the block:
- Total combined mass:
- Vertical rise:
Find the post-collision speed using Conservation of Mechanical Energy
Immediately after the collision, the combined mass moves horizontally with an initial swing speed . As it swings upward to its maximum height , all of its kinetic energy converts into gravitational potential energy:
Dividing both sides by and solving for :
Substitute the given values:
Find the launch speed using Conservation of Linear Momentum
During the brief horizontal impact, external forces in the horizontal direction are negligible. Therefore, horizontal momentum is conserved:
Solving for the initial speed :
Substitute the numerical values:
Rounded to three significant figures, we obtain:
Key Pitfall to Avoid
- Do not apply energy conservation to the collision: Setting is incorrect. A completely inelastic collision permanently deforms the materials and generates heat, dissipating a large fraction of the initial kinetic energy. Energy is conserved only during the swing after the collision is complete.
Typical errors
01 The student mistakenly assumes kinetic energy is conserved during the inelastic collision and equates initial kinetic energy directly to gravitational potential energy, resulting in v₀ ≈ 21.5 m/s.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Stage 1 (Collision): ; Stage 2 (Swing):
You equated the pellet's initial kinetic energy directly to the final gravitational potential energy. A collision where an object embeds is completely inelastic, which means kinetic energy is lost to deformation and thermal energy. Mechanical energy is conserved only after the collision as the combined mass swings upward.
- Step 2
,
- Step 3Correct
Your arithmetic follows your derived formula accurately, but the numerical answer is incorrect due to the invalid energy-conservation premise in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted centimeters to meters and grams to kilograms before calculating.
You accurately calculated the total mass of the combined system.
You manipulated and solved your algebraic equation cleanly.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the collision as conserving mechanical energy, omitting the conservation of linear momentum stage required for completely inelastic collisions.
REASONING PATH
Your ACEpath teacher’s suggested approach- Two-Stage Motion Rule
In a ballistic pendulum, split the problem at the moment impact finishes: use Conservation of Momentum across the collision ( to ) and Conservation of Mechanical Energy across the upward swing ( to apex).
Never equate pre-collision kinetic energy directly to peak gravitational potential energy when objects stick together or deform.
CORRECTED PATH
ACEpath Teacher's DemonstrationUse conservation of mechanical energy for the swing to find post-collision speed :
Substitute and :
Apply conservation of linear momentum to the collision:
Substitute the masses and :
02 The student forgets to convert the pellet's mass from grams to kilograms when setting up conservation of momentum, resulting in an initial speed of v₀ ≈ 0.215 m/s.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You added the pellet mass directly to the pendulum mass without converting grams to kilograms. Before adding physical quantities or evaluating ratios, ensure all masses share identical units.
- Step 4Correct
Your final calculation reflects the unit mismatch from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly split the problem into the swing phase (energy conservation) and the collision phase (momentum conservation).
You calculated the post-collision speed accurately from the rise height .
You stated the correct algebraic equation for conservation of linear momentum during an inelastic collision.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the pellet mass as and the block mass as into , directly summing grams and kilograms.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisInattention to dimensional consistency when substituting given numbers into algebraic expressions, specifically failing to convert all mass quantities to SI units (kilograms) before performing addition.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Mass Units Before Summing
Quantities cannot be added unless they are expressed in the exact same units: .
Convert all given values to base SI units at the start of your solution: .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the mass of the pellet to kilograms: .
Calculate the combined mass: .
Substitute into the momentum formula: .
03 The student omits the pellet's mass from the combined post-collision mass in the momentum conservation equation, writing m v₀ = M V, which gives v₀ ≈ 214 m/s.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Because the pellet embeds completely inside the wooden block, the collision is completely inelastic. The moving mass immediately after impact is the combined mass , not just the block's mass .
- Step 3Correct
Your algebraic rearrangement and arithmetic are correct based on your previous formula, but using instead of slightly underestimated the initial launch speed.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used conservation of mechanical energy to calculate the speed of the pendulum right after the collision.
You correctly converted the pellet mass from grams to kilograms () and handled units consistently.
You recognized that linear momentum is conserved during the brief horizontal collision.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set the post-collision momentum to instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn a completely inelastic collision where a projectile embeds into a target, both objects move together as a single combined body of mass . Writing forgets that the projectile is still moving with the block at speed immediately after impact.
REASONING PATH
Your ACEpath teacher’s suggested approach- Account for all masses in the final state
For a completely inelastic collision where mass embeds in mass , the total post-collision mass is always .
Whenever two bodies stick together or embed, write for the combined momentum immediately after impact.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up horizontal momentum conservation with the combined mass: .
Substitute the total mass .
Solve for the initial speed: .
Lock it in
Is kinetic energy conserved when a bullet embeds into a wooden block?
No. It is a completely inelastic collision, so kinetic energy is lost to heat and deformation; only linear momentum is conserved during impact.
Similar question
A dart of mass is shot horizontally into a stationary block of mass hanging from strings. The dart embeds in the block, and the combination swings up to a maximum height of . Find the initial speed of the dart. ()
Answer
. Key steps: . Total mass . Momentum conservation: .
In a ballistic pendulum experiment, a bullet embeds in a suspended block, causing it to swing upward to a height . Calculate both the initial launch speed of the bullet and the percentage of the initial mechanical energy lost during the collision. ()
Answer
; energy lost. Key steps: . . Initial ; post-collision . Fraction remaining = , so is lost.
A wooden block of mass rests on a frictionless horizontal floor against a horizontal spring (). A bullet of mass embeds into the block, and the spring subsequently compresses by a maximum distance . Find the bullet's initial velocity .
Answer
. Key steps: Post-collision kinetic energy equals peak elastic potential energy: . Conservation of momentum: .