Resources
A dust particle collects a static surface charge density over its effective surface area, yielding a total excess charge of . Calculate the electric-field strength at a location away from the center of the particle, expressing the answer in SI units of kilovolts per meter (). Use .
Answer and steps
Final answer
Steps
Convert Given Quantities to Standard SI Units
The dust particle carries an excess charge and can be treated as a point charge for locations outside the particle. First, express all values in base SI units:
- Total charge:
- Distance from the center:
- Electrostatic constant:
Apply the Electric Field Formula
The magnitude of the electric field created by a point-like charge at a radial distance is given by Coulomb's law:
Calculate the Field Strength
Substitute the converted values into the equation:
Evaluate the numerator and denominator:
- Numerator:
- Denominator:
Divide the two values:
Convert to Kilovolts per Meter ()
Since :
Common Pitfall: Ensure that unit prefixes are converted before performing calculations. Forgetting to convert to before squaring will throw off the result by a factor of .
Typical errors
01 The student forgets to square the distance r in Coulomb's law for the electric field, calculating E = k * q / r instead.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You omitted the exponent on the radial distance . The electric field of a point charge obeys an inverse-square law (), whereas gives the electric potential .
- Step 3Correct
Because you divided by rather than , the resulting field strength is off by a factor of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the metric prefixes for charge () and distance ().
You correctly substituted the electrostatic constant and your converted values into your algebraic expression.
You correctly converted your calculated value to .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided by instead of when writing Coulomb's law for the electric field.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating the electric field magnitude formula with the electric potential formula .
REASONING PATH
Your ACEpath teacher’s suggested approach- Inverse-Square Law for Electric Field
The magnitude of the electric field from a point charge is , with units of or .
Always verify dimensional units: multiplying () by () yields , which requires dividing by to produce .
CORRECTED PATH
ACEpath Teacher's DemonstrationSquare the distance in the denominator: .
Evaluate the electric-field strength: .
Convert to kilovolts per meter: .
02 The student confuses the metric prefix pico- with nano-, using 10⁻⁹ C instead of 10⁻¹² C for the charge.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
,
Correct,
You correctly converted millimeters to meters as , but the prefix pico- () corresponds to , whereas is nano- ().
- Step 2Correct
You selected the correct electric field formula and substituted the values properly, but this step inherited the incorrect exponent for charge .
- Step 3Correct
Your arithmetic and conversion from to were mathematically consistent with your substituted numbers, but the result is off by a factor of due to the earlier prefix error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the electric field formula for a point-like charge: .
You correctly converted the distance from millimeters to meters before squaring it.
You correctly converted your final field strength from to by dividing by .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated as instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the SI prefix pico- (symbol , factor ) with nano- (symbol , factor ).
REASONING PATH
Your ACEpath teacher’s suggested approach- SI Submultiple Prefixes
Milli- is , micro- is , nano- is , and pico- is .
Before calculating, pause and write down the prefix multiplier explicitly: .
CORRECTED PATH
ACEpath Teacher's DemonstrationReplace with .
Evaluate the numerator: .
Divide by : .
Convert to : .
03 The student fails to convert the distance r from millimeters to meters before squaring, using r in mm in the calculation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
, ,
- Step 2Correct
You substituted the distance as directly instead of converting millimeters to meters (). Because distance is squared in the denominator, this causes an error of a factor of .
- Step 3Correct
Your arithmetic and unit conversion from to were executed correctly based on your substitution, but the value is off by a factor of due to the unconverted distance in the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recalled and wrote down the formula for the electric field of a point-like charge, .
You correctly converted the charge from picocoulombs to coulombs using .
You correctly converted your calculated value to by dividing by .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou entered without including the factor for millimeters.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisPlugging values into formulas before ensuring every given quantity has been translated into base SI units (meters, kilograms, seconds, coulombs).
REASONING PATH
Your ACEpath teacher’s suggested approach- Standard SI Base Units Check
Coulomb's constant has units of , which requires distance in meters () and charge in coulombs ().
Always write down every given quantity converted into base SI units with scientific notation before substituting into any formula.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the distance: .
Substitute base SI values: .
Evaluate the denominator: .
Divide numerator by denominator: .
Convert to : .
Lock it in
What is the formula for the electric field magnitude produced by a point charge at distance ?
. Remember: electric field follows an inverse-square law with distance.
Similar question
A small metal sphere carries a net charge of . Calculate the electric-field strength at a distance of from the sphere's center. Use .
Answer
(or ). Key steps: , ; .
An alpha particle has a charge of . At what distance from the particle does the electric-field strength equal ? Use .
Answer
. Key steps: Rearrange to .
Two observation points and lie along a radial line from a point charge . Point is at and has field strength . Find the electric-field strength at point , located at .
Answer
. Key steps: Since , the ratio is . Thus, .