Resources
A projectile is launched horizontally with an initial speed from a height above horizontal ground. (a) Derive an expression for the impact angle (measured below the horizontal) in terms of , , and . (b) Evaluate the asymptotic limits and , identifying the physical trajectory corresponding to each limit. (c) Taking , compute the numerical value of for a low-speed launch of and for a high-speed asymptotic limit of .
Answer and steps
Final answer
(a) ; (b) (completely horizontal grazing trajectory) and (pure vertical free fall); (c) For , ; for ,
Steps
Part (a): Derivation of the Impact Angle
In horizontal projectile motion, motion in the horizontal and vertical directions are independent:
- Horizontal Motion: With negligible air resistance, the horizontal velocity component remains constant throughout the flight:
- Vertical Motion: The object starts with zero initial vertical velocity () and accelerates downward under constant gravitational acceleration . Applying the kinematic relation relating velocity to displacement : (taking the downward direction as positive for the magnitude of vertical velocity).
-
Impact Angle: The impact angle , defined below the horizontal, is determined by the ratio of the perpendicular velocity components at ground level:
Solving for :
Part (b): Asymptotic Limits and Physical Interpretations
- High-Speed Limit (): Physical interpretation: As horizontal velocity becomes arbitrarily large compared to the vertical velocity acquired during the fall, the path flattens out, approaching a completely horizontal grazing trajectory.
- Low-Speed Limit (): Physical interpretation: As initial forward speed approaches zero, the horizontal displacement vanishes, and the motion approaches pure vertical free fall.
Part (c): Numerical Calculations
Given and :
- For :
- For :
Typical errors
01 The student inverts the ratio of velocity components in the definition of the impact angle below horizontal, writing tan(θ) = v_x / v_y instead of v_y / v_x.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
When an angle is measured below the horizontal, the horizontal component is adjacent to and the downward vertical component is opposite. Therefore, the tangent ratio is , not .
- Step 3Correct
Your mathematical limit evaluation was consistent with your formula, but because the fraction was inverted, the physical interpretations and limit values were swapped.
- Step 4Correct
You calculated accurately, but substituting into the inverted tangent expression yielded complementary angles () rather than the angles below the horizontal.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly treated the horizontal velocity as constant with .
You applied the free-fall kinematic equation correctly to find the vertical impact speed.
You correctly evaluated trigonometric limits and computed numerical arctangent values matching your written expression.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the orientation of the reference axis when setting up the right triangle for the velocity vector. Measuring an angle 'below the horizontal' means the horizontal axis is the adjacent side and the vertical axis is the opposite side, requiring . Setting defines the angle with respect to the vertical instead.
REASONING PATH
Your ACEpath teacher’s suggested approach- Reference Axis Check
For an angle measured relative to axis , the component along axis is the adjacent side: .
Always sketch the velocity vector triangle at the impact point, label the horizontal line as the reference, and place between the vector and the horizontal.
- Extreme Case Sanity Check
A projectile launched at near-infinite horizontal speed should barely bend downward before impact, meaning its impact angle below horizontal must approach .
Test : verify that your formula yields , not .
CORRECTED PATH
ACEpath Teacher's DemonstrationSketch the velocity vector at ground level: points rightward and points downward.
The angle is below the horizontal line, so and .
Write .
Evaluate limits: and .
Substitute numerical values with : for , ; for , .
(a) ; (b) (horizontal grazing) and (vertical free fall); (c) and
02 The student forgets to take the square root when finding the vertical speed from v_y² = 2gh, using v_y = 2gh instead.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
and
You correctly identified that the horizontal velocity remains constant at . However, the kinematic equation for an object falling from rest is , which requires taking the square root to get . Notice also that has dimensions of velocity squared ().
- Step 2Correct
You correctly defined the impact angle using , but this expression inherited the missing square root from your vertical velocity.
- Step 3
, representing a horizontal trajectory , representing vertical free fall
- Step 4
For : For :
Correct; for , ; for ,
You followed the correct calculation steps, but computing rather than caused the resulting angles to be larger than their true values.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that horizontal velocity remains constant throughout the trajectory.
You set up the trigonometric relation correctly for the impact angle.
You accurately analyzed both mathematical limits and matched them to their real-world trajectories.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of taking the square root of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the quadratic power in the time-independent kinematic relation , compounded by not checking units to verify that has units of rather than .
REASONING PATH
Your ACEpath teacher’s suggested approach- Kinematic Formula Power Check
The kinematic relation relating speed and height is , not .
Always write down the formula with the exponent first before isolating .
- Dimensional Analysis Sanity Check
Every velocity component must have units of .
Check the units of : , confirming that a square root is required.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply .
Form the impact angle ratio: , so .
For : .
For : .
(a) ; (b) (horizontal grazing trajectory) and (vertical free fall); (c) for , and for .
03 The student confuses the impact velocity formula by omitting the factor of 2 in Torricelli's formula, writing v_y = √(gh) instead of √(2gh).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You correctly recognized that horizontal velocity remains constant, but you missed the factor of in the constant-acceleration kinematic relation , leading to instead of .
- Step 2Correct
You applied the correct trigonometric ratio to relate the velocity components to the impact angle, but your expression inherits the missing factor of from your vertical velocity.
- Step 3
, representing horizontal trajectory , representing straight vertical fall
- Step 4Correct
Your numerical substitutions and inverse tangent evaluations were performed cleanly, but your results were affected by starting from rather than .
WHAT YOU DID WELL
Compliments from Your TeacherYou decomposed the two-dimensional projectile motion into independent horizontal and vertical components correctly.
You used the tangent definition correctly to relate the impact angle to the perpendicular velocity components.
You analyzed the asymptotic mathematical limits and interpreted the physical trajectories accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou recalled the vertical velocity expression as instead of , omitting the kinematic coefficient .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou likely confused the free-fall velocity formula (derived from work-energy or ) with characteristic scale combinations like often seen in wave speed formulas.
REASONING PATH
Your ACEpath teacher’s suggested approach- Kinematic Relation Check
For constant acceleration starting from rest over displacement , the final speed is given by .
Always verify free-fall speed using work-energy conservation: .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the kinematic relation for the vertical motion with : .
Substitute and into to obtain .
Evaluate .
Compute for : .
Compute for : .
(a) ; (b) and ; (c) for , and for
Lock it in
For a velocity vector , how is the direction angle defined if measured below the horizontal?
. The horizontal component is the adjacent side and the vertical component is the opposite side.
Similar question
A stone is thrown horizontally from a cliff of height with an initial speed . Taking , find the impact angle measured below the horizontal.
Answer
. Key steps: , , .
An aircraft flying horizontally at an altitude of drops an emergency supply package. At what release speed will the package strike the flat ground at an impact angle of exactly below the horizontal? Take .
Answer
. Key steps: For , . Since , we have .
A projectile is launched horizontally from height . Express the ratio (where is the total impact speed) purely in terms of the impact angle measured below the horizontal, and determine how this ratio behaves in the limits and .
Answer
. In the limit (high-speed launch), (all kinetic energy remains horizontal). In the limit (zero initial horizontal speed), (motion is purely vertical).