Resources
A laboratory sound sensor detects a pure acoustic tone emitted by a tuning fork. The acoustic pressure variation is governed by simple harmonic oscillation. The tone completes exactly complete cycles in a measured time duration of , and the maximum pressure deviation from atmospheric pressure is recorded as . Calculate: (a) the fundamental period of the sound wave, and (b) the cyclic frequency of the tuning fork.
Answer and steps
Final answer
(a) (or ); (b)
Steps
Part (a): Calculate the Fundamental Period
-
Understand the definition of period: The period of an oscillation is the time taken to complete one full cycle: where:
- is the total elapsed time,
- is the number of complete cycles.
-
Substitute the given values:
Rounding to three significant figures gives:
Part (b): Calculate the Cyclic Frequency
- Understand the definition of frequency: The frequency represents the number of complete cycles per unit of time (in seconds, or Hertz, ): Alternatively, frequency is the reciprocal of the period:
-
Substitute the given values:
Checking with the reciprocal relation:
Common Pitfalls to Avoid
- Distractor Information: The maximum pressure deviation of represents the wave's amplitude (). While important for understanding the sound wave's intensity or loudness, amplitude is independent of the wave's period and frequency in simple harmonic motion.
- Inverting Period and Frequency: Always verify units. Period is measured in time ( per cycle), so time is in the numerator (). Frequency is measured in or (cycles per second), so the number of cycles is in the numerator ().
Typical errors
01 The student inverts the relationship between period and total time by dividing total cycles by duration instead of duration by cycles.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The period represents the time required for one single cycle, so elapsed time must be in the numerator and cycle count in the denominator: .
- Step 2Correct
You correctly set up the reciprocal relationship , but your numerical result was affected by the inverted period calculated in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that frequency and period are exact reciprocals of one another ().
You correctly ignored the wave amplitude () as extraneous information for finding period and frequency.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou swapped the numerator and denominator when defining the period , writing instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating period (seconds per cycle) with frequency (cycles per second), leading to the formula for frequency being labeled as period.
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Checking for Period and Frequency
Period has units of seconds (time per cycle); frequency has units of or (cycles per unit time).
Before calculating, check that the unit of the numerator matches the quantity: time on top gives seconds (), while count on top gives cycles per second ().
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the definition of period as time per cycle: .
Calculate frequency as cycles per second or the reciprocal of period: .
(a) (or ); (b)
02 The student confuses cyclic frequency with angular frequency by multiplying cyclic frequency by 2π in part (b).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Cyclic frequency is defined simply as the number of cycles per unit time, . Multiplying by yields the angular frequency in radians per second, rather than the cyclic frequency in Hertz.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recalled and applied the ratio of total time to number of cycles to find the period.
You recognized that amplitude () is an unneeded distractor for finding period and frequency.
You correctly evaluated the quotient .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou introduced a factor of into the formula for cyclic frequency .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated cyclic (ordinary) frequency (measured in cycles per second or ) with angular frequency (measured in radians per second, , where ).
REASONING PATH
Your ACEpath teacher’s suggested approach- Check the units and physical meaning of frequency
Cyclic frequency counts full cycles per second (). Angular frequency tracks phase angle swept in radians per second ().
When asked for cyclic frequency , do not multiply by ; use directly.
CORRECTED PATH
ACEpath Teacher's Demonstration(a) (or ); (b)
03 The student incorporates the irrelevant pressure amplitude into the frequency calculation, assuming frequency depends on pressure.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
In simple harmonic motion, cyclic frequency depends only on the number of cycles per unit time ( or ). The pressure amplitude reflects the wave's strength or loudness, not its frequency, so multiplying by makes the formula and units incorrect.
WHAT YOU DID WELL
Compliments from Your TeacherYou used the correct relationship between time and number of cycles to calculate the period in part (a).
You correctly calculated the ratio during your work for part (b).
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the pressure amplitude as a necessary factor in the frequency formula rather than recognizing it as an independent distractor representing the wave's amplitude.
REASONING PATH
Your ACEpath teacher’s suggested approach- Independence of Amplitude and Frequency
In simple harmonic motion, frequency () and period () describe temporal repetition and are completely independent of amplitude ( or ).
Separate given values into temporal quantities (time, cycle count) and magnitude quantities (amplitude, intensity) before selecting your formulas.
- Unit Dimensional Consistency
The unit of frequency is Hertz ().
Check whether multiplying by yields the proper unit: .
CORRECTED PATH
ACEpath Teacher's DemonstrationRecall the definition of frequency: or .
Substitute the cycle count and elapsed time: .
Verify that the amplitude is not part of the temporal rate definition.
(a) (or ); (b)
Lock it in
What is the fundamental difference in definition between period () and frequency ()?
is the time per single cycle (units: ), whereas is the number of cycles per unit time (units: or ).
Similar question
A guitar string vibrates times in . Calculate: (a) the period of vibration, and (b) the frequency .
Answer
(a) ().\n(b) .
An ultrasound transducer emits pressure cycles over an operational window of . The peak acoustic overpressure is . Determine the frequency and period of the ultrasound wave.
Answer
The peak overpressure is the amplitude, which does not affect or .\n.\n.
A child on a playground swing oscillates back and forth. A stopwatch starts at when the child is at the highest forward point. The child returns to this exact maximum forward position for the 8th time at . Find: (a) the period of the swing, and (b) the angular frequency in radians per second.
Answer
(a) Returning to the same maximum position 8 times means complete cycles occurred in . Therefore, .\n(b) Cyclic frequency is . Angular frequency is .