Resources
A stationary acoustic monitoring station on a training field detects sound emitted from a drone moving directly away from it along a straight horizontal trajectory. The drone emits an audio tone at a constant frequency of , but the station measures an apparent frequency of . Given that the speed of sound in air is , calculate the speed of the receding drone.
Answer and steps
Final answer
Steps
Identify the Known Quantities and the Governing Principle
The scenario involves the Doppler effect for sound, where relative motion between a sound source and an observer changes the observed frequency.
- Emitted source frequency:
- Observed apparent frequency:
- Speed of sound in air:
- Observer speed (stationary station):
- Source speed (drone moving away):
Set Up the Doppler Effect Formula
When an observer is stationary and the sound source is moving directly away, the sound waves are stretched out over a larger distance behind the source. This increases the wavelength and decreases the received frequency.
The relationship is given by:
Common Pitfall: Using a minus sign in the denominator () applies when the source is approaching the observer, which would result in a higher frequency (). Because the drone is moving away, the frequency decreases, which requires a plus sign in the denominator to increase the denominator.
Solve for the Source Speed
Rearrange the equation algebraically to isolate :
Invert both sides:
Subtract from both sides:
Multiply by the speed of sound :
Calculate the Numerical Value
Substitute the known values into the expression:
Typical errors
01 The student uses the Doppler formula for an approaching source rather than a receding source, resulting in a minus sign in the denominator and an incorrect speed of 21.5 m/s.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because the drone is moving directly away from the stationary station, the observed frequency must decrease (). A decreased frequency requires a larger denominator, which means the denominator must be , not .
- Step 2Correct
Your algebraic manipulation followed from the minus sign chosen in Step 1. Notice also that , and solving would have yielded a negative speed , which is a clue that the initial sign was reversed.
- Step 3Correct
Because the initial formula contained a sign error, your final calculated speed differs from the true receding speed of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly extracted all known values from the problem statement: , , and .
You recognized that this physical scenario is governed by the Doppler effect for a moving source and stationary observer.
You carried out clear algebraic isolation of the unknown speed term from the denominator.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou selected a minus sign in the denominator instead of a plus sign for a receding source.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou may be relying on memorizing a single formula template without applying the physical sanity check: relative recession stretches out the wave crests, which lowers the perceived pitch and requires an increased denominator ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Receding vs. Approaching Frequency Check
For a source moving away from a stationary observer, .
Always compare to before choosing the sign. Since , the ratio must be less than , requiring in the denominator.
- Denominator Sign Rule for a Moving Source
, where the upper sign () corresponds to approaching and the lower sign () corresponds to receding.
Associate 'away' with '+' (longer wavelength, lower pitch) and 'towards' with '−' (shorter wavelength, higher pitch).
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the Doppler formula with the correct sign for a receding source: .
Substitute the known numerical values: .
Isolate the denominator term: .
Subtract to find the source speed: .
02 The student confuses the roles of moving source and moving observer, placing the speed of the drone in the numerator instead of the denominator.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You placed the drone's speed in the numerator as if the observer were moving away. Because the sound source (the drone) is moving away from a stationary observer, the wave is stretched in space, which places the source speed term in the denominator.
- Step 2Correct
Your algebraic isolation and arithmetic were carried out correctly, but they inherited the incorrect formula setup from Step 1.
- Step 3Correct
The final value differs from the correct speed due to the formula error introduced in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that a receding motion leads to an observed frequency that is lower than the emitted frequency.
You performed accurate algebraic manipulation and division steps to isolate the unknown variable.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou swapped the numerator and denominator roles in the Doppler effect equation, treating a moving source as though it were an observer moving through stationary wave fronts.
REASONING PATH
Your ACEpath teacher’s suggested approach- Observer vs. Source Position
In the general Doppler equation , the observer speed always belongs in the numerator, while the source speed always belongs in the denominator.
Always check who is moving before writing the fraction: observer motion changes the rate of encountering wave fronts (numerator), whereas source motion changes the physical wavelength in air (denominator).
- Sign Convention for Receding Source
When a source moves directly away, wavelength increases and observed frequency must decrease ().
Ensure the denominator is greater than by choosing , which ensures the fraction .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the stationary observer, moving source formula: .
Substitute the given values: .
Cross-multiply or invert: .
Solve for : .
03 The student swaps the emitted source frequency and the measured observed frequency when substituting values into the formula.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You swapped the values for the emitted frequency and the observed frequency . The drone emits , while the monitoring station detects .
- Step 3Correct
Your algebraic isolation was logically sound, but it yielded an unphysical negative speed because the swapped frequency values forced the denominator to be smaller than the speed of sound.
- Step 4Correct
This final numerical answer is incorrect due to the frequency substitution error in Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou identified the correct Doppler shift formula for a source moving away from a stationary observer.
You maintained consistent algebraic steps to isolate the variable from the denominator.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou assigned the emitted source frequency to and the measured observer frequency to .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the source frequency (the pitch emitted at the source) with the observed frequency (the pitch detected after the wave propagates).
REASONING PATH
Your ACEpath teacher’s suggested approach- Physical Reality Check
When a sound source moves away, wave crests stretch out, so the detected frequency must always be lower than the source frequency ().
Always explicitly write out and next to their physical definitions before substituting into the Doppler formula.
- Sign of Source Speed
If the setup already accounts for receding motion with , the solved value for should come out positive.
If evaluates to a negative value, recheck whether and were swapped or if an incorrect sign convention was chosen.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the correct values: .
Rearrange to solve for the denominator: .
Subtract from both sides: .
Lock it in
When a sound source moves directly away from a stationary listener, does the detected frequency increase or decrease, and why?
It decreases () because wave crests are emitted farther apart in space, stretching the observed wavelength.
Similar question
An emergency vehicle emits a siren at while driving directly away from a stationary pedestrian at . If the speed of sound is , calculate the frequency heard by the pedestrian.
Answer
. Using .
A stationary roadside speed radar detects audio emitted by a car moving along a straight road. The car's engine tone is known to be , but the radar records . Taking the speed of sound to be , determine whether the car is approaching or receding, and calculate its speed.
Answer
Approaching at . Since , the car is approaching: .
A whistle emitting an tone is attached to a motorized cart moving directly away from a wall and directly toward a stationary observer at . Sound reflects perfectly off the wall. Given sound speed , find (a) the frequency the observer hears directly from the cart, and (b) the frequency of the echo reaching the observer from the wall.
Answer
(a) ; (b) . For direct sound, the cart approaches the observer: . For the echo, the wall acts as an observer for which the cart is receding: .