Resources
An isolated spherical conductor of radius is charged via contact with a high-voltage supply until it reaches the dielectric breakdown threshold of surrounding dry air (). The electrostatic constant is . (a) Determine the maximum charge in microcoulombs that the sphere can support without sparking into the air. (b) If this fully charged sphere is momentarily touched to an identical, uncharged, isolated conducting sphere at a distance where mutual induction is negligible during contact, will the resulting charge transfer cause dielectric breakdown on either sphere once separated to infinity? State the final charge on each sphere.
Answer and steps
Final answer
(a) (or ); (b) Final charge on each sphere is , which corresponds to a surface field of , so dielectric breakdown does not occur.
Steps
Part (a): Maximum Charge on the Conductor
- Relate the surface electric field to the total charge: For a spherical conductor carrying a net charge , the excess charge distributes uniformly over its outer surface. By Gauss's Law, the electric field outside and at the surface of the sphere () behaves as if all the charge were concentrated at the center:
-
Calculate the maximum permissible charge : To avoid dielectric breakdown (sparking), the electric field at the surface must not exceed the dielectric strength of air, :
Substitute the given values into the formula with :
Converting to microcoulombs ():
Part (b): Charge Sharing and Dielectric Breakdown
-
Apply charge conservation and symmetry: The two spheres are identical in size and shape. When brought into contact, charge flows between them until both spheres reach electrostatic equilibrium at the same electric potential.
By symmetry, the initial total charge divides equally between the two identical spheres: Each sphere holds a final charge of .
-
Evaluate the electric field after separation: Once the spheres are separated far apart, the electric field at the surface of each sphere is determined solely by its own charge:
Since , the electric field is strictly below the breakdown threshold. Therefore, dielectric breakdown does not occur on either sphere.
Typical errors
01 The student misuses the electric potential formula V = k_e * Q / R instead of the electric field formula E = k_e * Q / R², leading to an incorrect maximum charge.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The electric field outside and at the surface of a spherical conductor follows an inverse-square relationship with distance (), not a linear relationship ().
- Step 2Correct
Because was not squared in your formula, your computed charge was too large by a factor of .
- Step 3Correct
Your reasoning that charge distributes equally by symmetry is entirely correct, but the numerical answer inherits the earlier calculation error.
- Step 4Correct
Your proportional reasoning that and your qualitative conclusion are correct, though the written field formula repeated the missing square.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied charge conservation and symmetry to share charge equally between two identical conducting spheres.
You correctly reasoned that halving the charge halves the surface electric field, keeping it well below the breakdown threshold.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou wrote instead of , confusing the electric field formula with the electric potential formula.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check the power of distance
Electric field scales as , whereas electric potential scales as .
Check units: , which requires an denominator when multiplying () by ().
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the surface field formula: .
Solve for : .
Divide by for equal sharing: .
(a) ; (b) , and no dielectric breakdown occurs.
02 The student forgets to convert the radius from centimeters to meters, resulting in a maximum charge that is off by a factor of 10⁴.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted the radius as instead of converting to SI base units (). Because radius is squared, this caused an error factor of .
- Step 3Correct
Your charge sharing method between identical spheres is conceptually correct, but the numerical answer inherits the missing unit conversion from step 2.
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly formulated the surface electric field formula for a charged sphere.
You correctly shared the charge equally between the two identical spheres by symmetry.
You correctly reasoned that halving the charge prevents dielectric breakdown.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted directly into Coulomb's constant formula instead of converting centimeters to meters ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking unit alignment when constants contain SI base units: is given in , requiring all distance variables to be expressed in meters before evaluating powers.
REASONING PATH
Your ACEpath teacher’s suggested approach- SI Unit Consistency Check
Whenever using electrostatic constants ( or ), all spatial dimensions must be in meters.
Write down explicit unit conversions () before plugging numerical values into algebraic expressions.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the radius to SI units: .
Recalculate .
Divide by to find the final charge on each identical sphere: .
(a) (or ); (b) Final charge on each sphere is , and dielectric breakdown does not occur.
03 The student incorrectly doubles the charge upon contact assuming sparks or charge addition, rather than recognizing that charge is conserved and shared equally.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
When an isolated charged conductor contacts an identical uncharged conductor, total charge is conserved (). By symmetry, the charge splits equally, giving , not .
- Step 3Correct
Your field calculation and conclusion logically followed your incorrect doubled charge from the previous step. With the correct shared charge, the surface field is halved to , which is well below the threshold of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recalled and rearranged the formula for the electric field at the surface of a charged conducting sphere.
You accurately converted the radius from centimeters to meters and correctly computed the numerical value for in microcoulombs.
You correctly identified that identical spheres reach equal charges and potentials upon contact.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated contact with a second sphere as doubling the available charge () rather than recognizing that an isolated system conserves total charge and partitions it ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Conservation of Electric Charge
In an isolated system, net charge is strictly conserved: . Contact redistributes charge; it never creates new charge.
Before calculating individual final charges, always write out to find the total pool of charge.
- Equal Sharing by Identical Conductors
When two identical conducting spheres touch, they reach equal potential, dividing into two equal halves: .
Divide the conserved sum by the number of identical objects (), ensuring the sum of final charges equals the initial total.
CORRECTED PATH
ACEpath Teacher's DemonstrationFind the conserved total charge before contact: .
Equally distribute between the two identical spheres: .
Evaluate the new surface electric field: .
Compare to breakdown threshold: since , no breakdown occurs.
(a) ; (b) Each sphere carries , and dielectric breakdown does not occur.
Lock it in
What is the formula for the magnitude of the electric field at the surface of a charged spherical conductor of radius ?
. Electric field obeys the inverse-square law (), unlike potential ().
Similar question
A metal sphere of radius is placed in dry air where . Using , calculate the maximum charge it can hold before sparking.
Answer
. Use .
A conducting sphere of radius carries charge . It is briefly touched to an identical uncharged isolated sphere and then separated. What is the surface electric field on each sphere after separation?
Answer
. Each sphere gets . The surface field is .
Two conducting spheres with radii and are connected by a thin, long wire. A total charge is placed on the system. Find the ratio of their surface electric fields, .
Answer
. At equilibrium, potentials are equal (). Since , .