Resources
Consider the single-slit diffraction condition as the slit width approaches the wavelength from above (). Specifically, for an incident beam of wavelength , evaluate the angular position of the first diffraction minimum when: (a) , (b) , and (c) . State what happens to all diffraction minima as .
Answer and steps
Final answer
(a) ; (b) ; (c) ; for , no diffraction minima exist and the wave diffracts into the entire forward hemisphere without any zero-intensity nodes.
Steps
Condition for Single-Slit Diffraction Minima
In single-slit diffraction, destructive interference produces intensity minima (dark fringes) at angles given by:
where:
- is the slit width,
- is the wavelength of the incident light,
- is the order of the minimum,
- is the angle relative to the central forward axis.
For the first diffraction minimum (), the equation simplifies to:
Notice that the specific value of cancels directly when is expressed as a multiple of .
Calculating for Each Slit Width
- (a) For :
- (b) For :
- (c) For :
Physical Behavior as
For any minimum of order to physically appear on a viewing screen in front of the slit, the angle must satisfy:
- When , even the lowest-order minimum () requires , which has no real solution for .
- When , , corresponding to (along the plane of the slit itself).
Therefore, for , no diffraction minima exist in the forward direction. The central maximum broadens completely, and the wave diffracts smoothly across the entire forward hemisphere without any dark nodes (zero-intensity points).
Typical errors
01 The student improperly uses the small-angle approximation sin(θ) ≈ θ in radians or degrees for all parts, leading to severe error when the angle is large.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You set directly equal to . The small-angle approximation is not valid here; you must evaluate the exact inverse sine .
- Step 3Correct
You equated to , giving . For , the angle is very large, so the exact angle is .
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the single-slit destructive interference condition with .
You correctly calculated the ratio for each slit width.
You correctly identified that no diffraction minima can physically exist when .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated as equal to in radians even when was and .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOver-reliance on the small-angle approximation without checking whether (typically or ). When is moderately large or near , you must use the inverse sine function .
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Angle Magnitude Before Approximating
The small-angle approximation is only valid when (roughly ).
Always evaluate on a calculator unless a small-angle condition is explicitly confirmed or requested.
- Exact Inverse Function
For single-slit minima, .
Substitute the value of into directly rather than equating radians to the dimensionless sine ratio.
CORRECTED PATH
ACEpath Teacher's DemonstrationFor (b) where : .
For (c) where : .
(a) ; (b) ; (c) ; for , no diffraction minima exist.
02 The student confuses the slit width condition with double-slit interference and assumes minima disappear because destructive interference completely cancels out all transmitted light.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4
When , no light can pass through the slit so the screen becomes completely dark.
CorrectFor , , so no real diffraction minima exist. Light still transmits through the slit, spreading continuously across the forward hemisphere without any dark fringes.
The condition defines positions of zero intensity (dark fringes), not the transmission of light. When , , which means destructive interference nodes cannot physically form. Light continues to pass through and spreads out broadly across the entire forward screen.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the single-slit destructive interference condition for all three numerical sub-parts.
You recognized that cancels out directly when is given in multiples of .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the mathematical absence of destructive interference minima () with the physical blockage of the wave.
REASONING PATH
Your ACEpath teacher’s suggested approach- Meaning of the diffraction formula
The equation specifies where waves across the slit cancel each other out completely (intensity minima), not where light is allowed to pass.
Separate the condition for wave transmission from the geometric condition for destructive interference across the aperture.
- Sub-wavelength slit behavior
When , , which has no real angle solution for . Consequently, no dark nodes form.
Interpret the lack of minima as total spreading of the central diffraction peak, illuminating the entire forward region smoothly.
CORRECTED PATH
ACEpath Teacher's DemonstrationInspect the minimum condition for the lowest order .
Notice that for , , which means .
Conclude that destructive interference cannot produce any dark fringes in the forward viewing region ().
Recognize that light still transmits and diffracts as an open cylindrical or spherical wave front, filling the forward hemisphere without zero-intensity nodes.
(a) ; (b) ; (c) ; for , no diffraction minima exist and light spreads continuously over the entire forward hemisphere without any dark fringes.
Lock it in
When is the small-angle approximation (in radians) valid in wave optics?
Only for small angles, typically (or ). For larger angles, you must use .
Similar question
Light of wavelength passes through a single slit of width . Find the exact angular position of the first diffraction minimum, and calculate the percentage error if the small-angle approximation were used.
Answer
. The exact angle is (). The small-angle approximation gives . Percentage error is .
A slit of width is illuminated by light with . Determine the total number of diffraction minima visible on a distant semicircular screen centered on the slit.
Answer
Diffraction minima occur at , requiring . Here . Thus . The allowed integer orders are . Therefore, there are 4 diffraction minima in total (2 on each side of the central maximum).
Monochromatic light shines on a single slit. As the slit width is gradually reduced from to , describe what happens to the angular width of the central diffraction peak, noting any critical transition point.
Answer
As decreases, increases, so increases and the central peak broadens. At the critical transition , , giving (the central maximum spreads across the entire forward hemisphere). For , , so no dark fringes can form anywhere, and diffraction spreads continuously into the forward hemisphere.