Resources
An optical sensor is submerged inside a benzene container () and emits a ray directed upward toward an overlying layer of water (). Determine the critical angle of incidence at the benzene-water interface at and beyond which the refracted ray grazes the boundary or undergoes total internal reflection.
Answer and steps
Final answer
Steps
Understanding the Critical Angle
Total internal reflection can occur when light travels from an optically denser medium (higher refractive index) into a less dense medium (lower refractive index).
Here, the light travels upward from benzene () toward water (). Because , the ray bends away from the normal line. As the angle of incidence increases, the angle of refraction eventually reaches , causing the refracted ray to skim along the interface. The angle of incidence that produces this condition is called the critical angle ().
Step-by-Step Derivation
-
Apply Snell's Law of Refraction: where:
- (refractive index of benzene)
- (refractive index of water)
- (critical angle of incidence)
- (angle of refraction at the grazing boundary)
- Substitute : Since , the equation simplifies to:
- Solve for :
- Calculate the Critical Angle:
Key Pitfall to Avoid
- Always place the medium with the lower refractive index in the numerator: . If the ratio were inverted (), the sine value would exceed , which has no real solution because total internal reflection cannot occur when going from a lower index to a higher index.
Typical errors
01 The student inverts the ratio of refractive indices as n_incident / n_refracted, which yields a sine value greater than 1, leading them to misinterpret or invert it.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
From Snell's law at the critical condition, , where is the incident medium (benzene) and is the refracting medium (water). Solving for gives , placing the smaller refractive index in the numerator.
- Step 2
, which has no solution, so total internal reflection cannot occur.
CorrectBecause the sine value was incorrectly calculated as greater than , your subsequent conclusion that there is no solution was an error propagated from Step 1. In reality, total internal reflection occurs because light travels from a denser medium () to a less dense medium ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that the critical angle relates to the inverse sine of a ratio of refractive indices.
You correctly identified that the sine function cannot exceed for real angles.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou swapped the incident medium () and transmitting medium () in the critical angle formula, forgetting that Snell's law requires , which always yields a ratio of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Derive from Snell's Law
at gives .
Always solve for rather than relying on memorizing whether or is on top.
- Sanity Check on Sine Values
For any real angle , .
If your ratio exceeds , check whether light is actually traveling from a higher index to a lower index medium, and verify that the smaller index is in the numerator.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up Snell's law at the grazing boundary: .
Solve for : .
Calculate the inverse sine: .
02 The student calculates the critical angle relative to air rather than relative to the overlying water layer by using n = 1.00 for the second medium.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You used the refractive index of vacuum/air () in the numerator instead of water (), which is the actual medium overlying the benzene.
- Step 2Correct
You evaluated the inverse sine correctly for your ratio, but the result is incorrect due to the index substituted in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that total internal reflection is governed by Snell's law when the refracted angle reaches .
You correctly applied the inverse sine operation to solve for the critical angle.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used the simplified formula , which is valid only when light exits into air or vacuum.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisDefaulting to air () as the second medium instead of checking the actual boundary material specified in the problem statement.
REASONING PATH
Your ACEpath teacher’s suggested approach- General Critical Angle Formula
For light traveling from medium 1 into medium 2 (), Snell's law gives .
Always write down first, and identify both media explicitly before substituting.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the boundary relation using Snell's law at grazing incidence: .
Substitute the given refractive indices: .
Calculate the critical angle: .
Lock it in
What are the two necessary physical conditions for total internal reflection (TIR) to occur at an interface?
- Light must travel from a medium of higher refractive index into a medium of lower refractive index ().\n2. The angle of incidence must be greater than or equal to the critical angle ().
Similar question
A flint glass prism () is immersed in water (). Calculate the critical angle for light attempting to pass from the glass into the water.
Answer
.
An optical fiber has a core with refractive index and a cladding with refractive index . Determine the minimum angle of incidence at the core-cladding boundary required to keep light guided within the core by total internal reflection.
Answer
. The angle of incidence must satisfy .
Light traveling inside a liquid strikes the boundary with air () at an angle of and just barely grazes the surface along the boundary. What is the refractive index of the liquid, and would total internal reflection occur if the liquid were replaced by one with at the same angle of incidence?
Answer
- From , we have .\n2. For a liquid with , the new critical angle is . Since the incident angle () is less than , total internal reflection will not occur (the ray refracts into air).