Resources
During an analytical chemistry experiment, a fiber-optic Abbe-type refractometer probe () is dipped into a titration beaker containing of an unknown sucrose solution. As pure water is titrated into the beaker, the critical angle of total internal reflection at the prism-solution interface is observed to shift continuously from to . Using Snell's law boundary conditions, determine the initial refractive index and final refractive index of the solution.
Answer and steps
Final answer
; .
Steps
Condition for Total Internal Reflection
Total internal reflection (TIR) occurs when a light ray travels from an optically denser medium (refractive index ) toward a less dense medium (refractive index , where ).
According to Snell's law:
At the critical angle of incidence, , the angle of refraction reaches its maximum possible value, . Substituting this boundary condition into Snell's law gives:
Here, the prism is the denser medium () and the solution is the surrounding medium (). Therefore:
Calculate the Initial Refractive Index ()
Before titration, the observed critical angle is :
Using :
Calculate the Final Refractive Index ()
After titrating with pure water, the sucrose concentration decreases, lowering the solution's refractive index and shifting the critical angle to :
Using :
Common Pitfall to Avoid
Always ensure the critical angle is measured relative to the normal (perpendicular) to the interface, not relative to the prism's surface plane. Additionally, remember that total internal reflection is only possible when light originates in the medium with the higher refractive index (); attempting to take where is undefined.
Typical errors
01 The student inverts the ratio in Snell's law at the critical angle, writing sin(θ_c) = n_prism / n_solution, resulting in unphysical refractive indices greater than n_prism.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You inverted the index ratio as . Because light originates inside the prism () and refracts into the solution at (), Snell's law gives , which means .
- Step 2Correct
You repeated the inverted formula for the final state, which yielded an unphysically high refractive index of . Diluting a sucrose solution with water () must decrease its refractive index, not increase it.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the given numerical values and computed the sine of each critical angle accurately.
You recognized that total internal reflection is governed by Snell's law at a angle of refraction.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou memorized the critical angle formula as a generic ratio of refractive indices without deriving it directly from Snell's law, leading you to place the denser medium in the numerator.
REASONING PATH
Your ACEpath teacher’s suggested approach- TIR Direction Condition
Total internal reflection is physically possible only when light moves from an optically denser medium () to an optically rarer medium (), meaning .
Always check that the incident medium has a higher refractive index than the surrounding medium before setting up the equation.
- Sine Magnitude Constraint
Because for any real critical angle, the ratio of indices must satisfy .
Ensure the smaller refractive index is in the numerator and the larger index is in the denominator.
- Physical Trend Check
Adding water () to a concentrated sucrose solution lowers the concentration, which must decrease the solution's refractive index toward that of pure water.
Verify that your calculated is lower than and approaches .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite Snell's law at the critical boundary: .
Calculate the initial index: .
Calculate the final index: .
;
02 The student uses the cosine function instead of the sine function when applying the boundary condition for the critical angle.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Snell's law uses the sine function: . Replacing sine with cosine gives an index below , which is physically impossible for an aqueous solution.
- Step 2Correct
Applying Snell's law at the critical angle requires the sine function: .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that the critical angle relates the prism refractive index to the solution refractive index.
You correctly plugged in the given numerical values and evaluated your trigonometric expressions accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of when setting up the critical angle equation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisSnell's law is fundamentally formulated with the sine of the angle of incidence and refraction measured relative to the normal (). At the critical angle, the angle of refraction is , leading to . Using cosine instead stems from confusing normal-based angles with grazing-incidence or surface-tangent angles.
REASONING PATH
Your ACEpath teacher’s suggested approach- Snell's Law Definition
, where angles are measured from the interface normal.
Always verify that your equation uses the sine ratio for ray angles relative to the surface normal.
- Physical Reality Check
The refractive index of any physical liquid or solid medium must be greater than (and an aqueous solution must have ).
If your computed refractive index for a liquid is less than (like ), stop immediately and check whether you mixed up sine and cosine or inverted the index ratio.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Snell's law at the critical angle: .
Compute the initial refractive index: .
Compute the final refractive index: .
;
03 The student evaluates the trigonometric function with the calculator set to radian mode instead of degree mode, yielding negative or nonsensical refractive index values.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You evaluated with your calculator set to radians instead of degrees. Because physical angles in this problem are given in degrees, , which yields a positive refractive index of .
- Step 3Correct
You repeated the radian mode error on . In degree mode, , giving .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that total internal reflection at grazing emergence gives .
You accurately substituted the prism index and the corresponding angles into your equations.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou evaluated trigonometric expressions treating degree values () as radians.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou did not verify that your calculator was set to DEG mode before calculating sine, and you did not perform a physical sense check on the resulting negative index (), which is physically impossible for conventional dielectric solutions.
REASONING PATH
Your ACEpath teacher’s suggested approach- Calculator Mode Verification
Whenever angle measurements carry the degree symbol (), your calculator must be set to DEG mode (or explicitly converted via ).
Check your calculator display for 'DEG' before computing trigonometric functions for geometric optics problems.
- Physical Sanity Check for Refractive Index
Standard transparent liquids have positive refractive indices greater than (water is ; aqueous sugar solutions are between and ).
If you compute or for an ordinary liquid, stop immediately and check your trigonometric angle mode and algebra.
CORRECTED PATH
ACEpath Teacher's DemonstrationSwitch calculator mode to DEG: .
Compute initial index: .
Compute final index: .
;
Lock it in
What fundamental condition must be met by the two media for Total Internal Reflection (TIR) to occur?
Light must travel from an optically denser medium into an optically less dense medium ().
Similar question
A liquid core waveguide has a cladding of fluoropolymer with refractive index . If the critical angle at the core-cladding boundary is , determine the refractive index of the liquid core .
Answer
Using Snell's law at the critical angle, . Thus, .
An optical probe made of sapphire () measures the salinity of seawater. When the critical angle at the probe-seawater interface changes from to , does the refractive index of the seawater increase or decrease? Calculate the change .
Answer
Since , an increasing critical angle corresponds to an increasing refractive index. Initially: . Finally: . The change is an increase of .
A step-index optical fiber has a core of refractive index surrounded by a cladding with . A student claims that light entering from the cladding into the core can undergo total internal reflection at . Explain why this claim is physically impossible and state the correct critical angle for guided rays within the fiber.
Answer
Total internal reflection requires light to travel from a medium of higher index to lower index (). Light traveling from cladding () toward core () always refracts toward the normal without TIR, and yields an undefined sine value. Guided rays stay inside the denser core, giving a valid critical angle at the core-cladding boundary of .