Resources
A diver shines an underwater flashlight upward through calm lake water () toward a thin layer of floating linseed oil (), above which is air (). The diver assumes that because light travels from a lower-index medium (water) into a higher-index medium (oil), total internal reflection cannot possibly occur at the water-oil boundary. Calculate (a) the maximum angle of incidence at the water-oil interface for which light can ultimately escape into the air above the oil, and (b) compare this threshold to the direct critical angle between water and air.
Answer and steps
Final answer
(a) ; (b) The threshold angle is identical to the direct water-air critical angle , demonstrating that the intermediate oil layer does not alter the overall escape threshold to the air.
Steps
Part (a): Maximum Angle of Incidence in Water
When light passes through a stack of parallel, planar layers, Snell's law applies across each consecutive boundary:
Because (), the ray refracts toward the normal at the water-oil interface, and total internal reflection cannot occur at this first boundary.
However, at the oil-air interface, light travels from a higher-index medium () into a lower-index medium (). Total internal reflection occurs at this boundary if the angle of incidence in the oil exceeds the critical angle , meaning no light refracts into the air.
For light to just escape into the air, the refraction angle in air must satisfy . At the critical threshold of escape:
Applying the overall Snell's law relation between the initial water layer and the final air layer:
Solve for :
Therefore, the maximum angle of incidence in water for which light can escape into the air is .
Part (b): Comparison with the Direct Water-Air Critical Angle
If the oil layer were absent, light traveling directly from water into air would undergo total internal reflection when the incident angle exceeds the water-air critical angle :
The threshold angle is identical to the direct water-air critical angle , demonstrating that the intermediate oil layer does not alter the overall escape threshold to the air.
Common Pitfall: While the intermediate layer cannot prevent total internal reflection from ultimately occurring, it changes where the reflection occurs: the light enters the oil layer freely, but undergoes total internal reflection at the top surface of the oil (the oil-air boundary) and is reflected back down.
Typical errors
01 The student mistakenly calculates the critical angle at the oil-air interface and treats it as the angle of incidence in the water, ignoring Snell's law refraction from water into oil.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You found the critical angle inside the oil, , but you directly treated this value as . Light bends as it crosses the water-oil boundary according to Snell's law, , which simplifies directly to .
- Step 2
- Step 3
The threshold with oil is , which is smaller than the direct critical angle of .
CorrectThe escape threshold angle from water is , which is identical to the direct water-air critical angle.
Because your angle from part (a) was underestimated due to the missing refraction step at the water-oil interface, your comparison concluded that the oil layer alters the escape angle.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that total internal reflection occurs at the oil-air boundary rather than the water-oil boundary.
You correctly computed the direct critical angle between water and air as .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the critical angle at the upper boundary (oil-air) as the angle of incidence in the bottom layer (water), forgetting that light refracts across parallel interfaces according to the continuous invariant .
REASONING PATH
Your ACEpath teacher’s suggested approach- Invariant for Parallel Planar Layers
For any number of parallel optical layers, remains constant across all interfaces.
Equate the initial layer directly to the final escaping layer: .
- Escape Threshold Condition
At the threshold of escape into a final medium, the refraction angle in that final medium is .
Set and solve .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Snell's law across the parallel stack: .
At the critical escape threshold into air, , so .
Equate the water layer directly to the air layer: .
Compute .
(a) ; (b) The threshold angle is identical to the direct water-air critical angle ().
02 The student misapplies the critical angle formula between water and oil by placing the larger index in the numerator, concluding that total internal reflection occurs at the water-oil boundary at an unphysical angle.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
For total internal reflection at water-oil:
CorrectTotal internal reflection can only happen when light travels from an optically denser medium into a less dense medium (). Because , total internal reflection cannot occur at the water-oil boundary at any angle; light always enters the oil.
- Step 2
Since , no light can escape into the oil, so no angle allows light to escape.
CorrectBecause your setup for the critical angle at the first boundary was inverted, you concluded that no light escapes into the air, whereas light escapes for any incident angle .
- Step 3
Direct water-air critical angle is .
- Step 4
The direct threshold is , whereas with oil no light can enter the oil layer at any angle.
CorrectThe threshold angle is identical to the direct water-air critical angle (), showing that the intermediate oil layer does not change the overall escape angle.
Your comparison followed your earlier incorrect conclusion that light cannot enter the oil layer.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the direct water-to-air critical angle using Snell's law at the critical condition.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set and interpreted the impossibility of total internal reflection as light being unable to enter the medium.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the condition for total internal reflection ( with ) with refraction into a denser medium, combined with overlooking that for parallel planar layers, Snell's law links the first and last media directly: .
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Direction of Refraction
Total internal reflection (TIR) requires light to go from higher to lower ().
If , the ray bends toward the normal, and light always refracts into the second medium for all angles of incidence.
- Chain Rule for Parallel Layers
For parallel layers, .
To find whether light can escape into the final layer (air), directly equate the initial layer to the final layer: .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Snell's law across parallel layers directly from water to air: .
Set the escape threshold at the air boundary: , so .
Solve for the maximum angle in water: .
Compute the angle: .
(a) ; (b) The threshold angle is identical to the direct water-air critical angle ().
Lock it in
For light passing through multiple parallel planar media with refractive indices , what relation connects the angles of propagation and ?
. The intermediate layer index cancels out.
Similar question
A light ray travels from crown glass () through a flat layer of water () and into air (). Calculate the maximum angle of incidence in the glass for which light can escape into the air.
Answer
. Using Snell's law between the first and last layers: .
A layer of transparent liquid with unknown index floats on water (). If a light ray originating in water at an incident angle of enters the liquid and then refracts into air at , find (a) the index if the angle in the liquid is , and (b) whether affects the final angle in air.
Answer
(a) ; (b) No, does not affect the final angle in air because depends only on the water and air parameters.
A block of dense flint glass () is coated with a thin film of fluorite (), which is bordered by water (). Determine: (a) the critical angle for total internal reflection at the glass-fluorite boundary, and (b) the critical angle for light originating in glass to ultimately escape into water.
Answer
(a) ; (b) . Light with an incidence angle between and refracts into the fluorite but undergoes total internal reflection at the fluorite-water boundary.