Resources
An acoustic depth transducer emits a continuous sound wave through seawater with an operating frequency of . At the ocean surface, the water has a salinity of and a temperature of , yielding an acoustic wave speed of . The wave travels downward into a colder deep layer where the speed drops to . (a) Calculate the wavelength of the sound wave in the surface layer in millimeters (). (b) If the acoustic beam approaches the boundary between the two water layers at a grazing angle of relative to the horizontal boundary surface, determine its angle of incidence relative to the normal in degrees, and the refracted angle relative to the normal in degrees. (c) Compute the wavelength change in millimeters.
Answer and steps
Final answer
(a) ; (b) , ; (c)
Steps
Part (a): Wavelength in the Surface Layer
The fundamental wave equation connects wave speed , frequency , and wavelength :
Given:
Substitute these values into the formula to find :
Converting meters to millimeters ():
Part (b): Angle of Incidence and Angle of Refraction
-
Find the angle of incidence :
The grazing angle is measured with respect to the interface boundary itself, whereas Snell's law requires angles measured relative to the normal (perpendicular) line: -
Find the angle of refraction using Snell's Law:
Snell's Law applies to acoustic waves at an interface between two media of differing sound speeds:Solving for :
Substitute the numerical values:
Taking the inverse sine:
Common Pitfall: Sound waves refract toward the normal when moving into a medium with a lower sound speed (), which means . This is the reverse of light crossing into an optically denser medium because wave speed in Snell's law appears directly in the denominator rather than via an inverse refractive index ().
Part (c): Change in Wavelength
When a wave crosses a boundary, its frequency remains constant because it is determined by the source. The wavelength in the second layer is:
The change in wavelength can be expressed directly as:
Substitute the values:
Converting to millimeters:
Typical errors
01 The student confuses the grazing angle relative to the boundary with the angle of incidence relative to the normal, setting θ₁ = 18.5°.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The problem states that the wave approaches at a grazing angle of relative to the horizontal boundary surface. The angle of incidence must be measured relative to the normal (perpendicular) to the interface, so .
- Step 3Correct
You set up Snell's law for acoustic waves correctly, but substituting the incorrect incident angle carried the error forward into your value for .
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted units between kilohertz, hertz, meters, and millimeters.
You applied the fundamental wave relationship accurately in both layers.
You correctly formulated Snell's law in terms of wave velocities as .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the grazing angle (measured between the beam and the horizontal interface surface) with the angle of incidence (measured between the beam and the normal perpendicular line). In optics and acoustics, angles in Snell's law are always defined relative to the normal line.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify the Reference Line for Angles
The angle of incidence is measured between the wave direction and the normal line ( to the boundary). A grazing angle is measured relative to the boundary surface itself.
Whenever a problem mentions a 'grazing angle' or 'angle with the surface' , immediately compute the angle of incidence as before applying Snell's law.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the angle of incidence relative to the normal: .
Substitute into Snell's law: .
Compute the inverse sine to find the angle of refraction: .
(a) ; (b) , ; (c)
02 The student inverts the ratio of wave speeds in Snell's law, using sin(θ₁)/sin(θ₂) = v₂/v₁ instead of v₁/v₂.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the velocity ratio in Snell's law. In terms of wave speeds, the relationship is , which gives . Because the wave slows down (), the refracted ray must bend toward the normal, making .
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the initial wavelength using the fundamental wave relationship.
You correctly identified that the angle of incidence is the complement of the grazing angle.
You correctly recognized that wave frequency remains constant across the boundary to compute the wavelength change.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing Snell's law in terms of refractive index () with Snell's law in terms of wave speed (). Because , wave speeds are directly proportional to , not inversely proportional.
REASONING PATH
Your ACEpath teacher’s suggested approach- Snell's Law with Wave Speeds
When setting up Snell's law without refractive indices, place each angle's sine directly over its medium's wave speed: .
- Physical Sanity Check on Bending
A wave bending into a slower medium () bends toward the normal ().
Compare and . If the wave slows down, verify that your calculated is smaller than .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite Snell's law in wave-speed form: .
Solve for : .
Substitute the values: .
Take the inverse sine: .
(a) ; (b) , ; (c)
03 The student assumes sound frequency changes proportionally with speed while wavelength remains constant, resulting in an erroneous wavelength change of zero.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
When a wave passes into a new medium, its frequency remains constant because it is driven by the source, whereas its wavelength changes according to .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the wave speed equation to compute the surface layer wavelength in millimeters.
You correctly related the grazing angle to the normal angle of incidence.
You accurately solved Snell's law for the refracted acoustic beam angle.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated wavelength as invariant across a medium interface rather than frequency. Because boundary oscillation is driven continuously by the source, must remain constant, forcing wavelength to scale directly with wave speed .
REASONING PATH
Your ACEpath teacher’s suggested approach- Boundary Invariance Rule
When any continuous wave crosses an interface between two media, frequency remains unchanged (), while speed and wavelength change proportionally.
Always keep frequency fixed across boundaries and calculate the new wavelength using .
CORRECTED PATH
ACEpath Teacher's DemonstrationHold frequency constant across the boundary: .
Compute the wavelength in the deeper layer: .
Subtract the surface wavelength from the deep layer wavelength: .
Lock it in
How is the angle of incidence defined in Snell's Law compared to a grazing angle ?
The angle of incidence is measured relative to the normal (perpendicular) to the interface, whereas the grazing angle is measured relative to the boundary surface itself: .
Similar question
An ultrasound pulse at travels from fat () into muscle (). The pulse strikes the planar boundary at an angle of relative to the boundary surface. Calculate (a) the angle of incidence and (b) the angle of refraction .
Answer
(a) . (b) By Snell's law, , so .
A sonar beam with frequency propagates in seawater at and enters an ocean thermocline where the wave speed is . If the beam's angle of incidence relative to the normal is , find the angle of refraction and the change in wavelength in millimeters.
Answer
. The wavelength change is .
An acoustic wave traveling in water () encounters a seabed layer where sound travels faster at . (a) Determine the critical angle of incidence relative to the normal. (b) What is the maximum grazing angle relative to the seabed surface that allows the wave to refract into the seabed without undergoing total internal reflection?
Answer
(a) Total internal reflection occurs when . (b) Refraction occurs for . Since the grazing angle is , transmission requires .