Resources
A portable outdoor concert speaker array radiates spherical sound waves. A listener initially standing at distance moves directly away along a radial line to distance . (a) Calculate the ratio of the sound intensity at to that at , . (b) Determine the change in sound intensity level . (c) Explain conceptually why moving five times farther away reduces the decibel level by only rather than reducing it by a factor of 5 or 25.
Answer and steps
Final answer
(a) ; (b) ; (c) Because the decibel scale is logarithmic, an intensity reduction by a factor of translates to a constant arithmetic subtraction of rather than a proportional percentage reduction of the decibel value.
Steps
Part (a): Ratio of Sound Intensities
A point source or array radiating spherical sound waves spreads acoustic power uniformly over a sphere of surface area . The sound intensity at a distance is:
Because the power output remains constant, intensity is inversely proportional to the square of the distance from the source (the inverse-square law):
Substitute the given distances and :
Part (b): Change in Sound Intensity Level
The sound intensity level in decibels () relative to the reference threshold of hearing is defined as:
The change in intensity level between the two positions is:
Substitute the intensity ratio found in part (a):
Since :
The sound intensity level drops by .
Part (c): Conceptual Understanding of the Decibel Scale
A common pitfall is attempting to scale decibels linearly with distance or intensity (e.g., dividing the decibel rating by 5 or 25).
The decibel scale is logarithmic, not linear:
- Multiplication becomes subtraction: In logarithmic functions, dividing the physical intensity by a factor () corresponds to subtracting a constant value () from the initial level, regardless of how loud the source was initially.
- Perceptual scaling: The human auditory system perceives loudness logarithmically. A reduction of roughly is typically perceived as halving the subjective loudness. Therefore, dropping the intensity by a factor of 25 (an intense physical reduction to of the original energy flux) corresponds to a reduction of , which represents a noticeable but gradual drop in perceived loudness rather than an extreme 25-fold drop in the numerical decibel value.
Typical errors
01 The student assumes sound intensity is inversely proportional to distance rather than distance squared, leading to an incorrect intensity ratio of 0.200 and a change of -7.0 dB.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You set the intensity ratio inversely proportional to distance () rather than distance squared (). Because the source radiates spherical sound waves, sound power distributes over a sphere of area .
- Step 2Correct
You set up the decibel level change formula correctly, but substituting your incorrect ratio of from part (a) produced instead of .
- Step 3
"Decibels use a logarithmic scale, so a multiplicative change in intensity corresponds to subtracting decibels rather than dividing decibels."
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the decibel change formula .
You provided a clear, accurate explanation of how the logarithmic nature of the decibel scale handles multiplicative intensity changes.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated spherical wave intensity as inversely proportional to linear distance () rather than distance squared ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Wave Geometry and Area Scaling
For point sources radiating spherical waves uniformly in three dimensions, intensity follows the inverse-square law: , meaning .
Always identify the wave geometry before setting up ratios: 3D point/spherical sources scale as , while ideal 2D infinite line sources scale as .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the inverse-square law for spherical waves: .
Substitute the corrected ratio into the decibel formula: .
(a) ; (b) ; (c) Decibel scale is logarithmic, mapping a intensity drop to .
02 The student inverts the ratio of distances when applying the inverse-square law, calculating IA / IB instead of IB / IA and obtaining a positive decibel change.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because sound intensity from a spherical source obeys an inverse-square law (), intensity decreases with distance. Moving from to makes the sound weaker, so the ratio must be , not .
- Step 2Correct
Your decibel formula setup was correct. However, substituting your inverted ratio of instead of produced a gain of instead of a drop of .
- Step 3
The decibel scale is logarithmic, so a factor of 25 change in intensity corresponds to adding or subtracting decibels.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the logarithmic decibel formula to relate intensity ratios to decibel changes.
You correctly calculated .
You correctly identified that logarithmic scales convert multiplicative intensity factors into additive or subtractive decibel differences.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up a direct square ratio instead of an inverse square ratio .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing direct proportions with inverse-square proportions when writing two-point ratios. When two quantities are inversely related (), the ratio must equal , placing the initial distance in the numerator and the final distance in the denominator.
REASONING PATH
Your ACEpath teacher’s suggested approach- Physical Reality Check
Sound gets quieter as you move farther away from the source.
Always verify that if , then , meaning and .
- Ratio Construction for Inverse Powers
For any inverse relationship , the ratio is .
Write out the base definition and take the explicit ratio to avoid flipping variables.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the inverse-square law correctly: .
Substitute the correct ratio into the decibel formula: .
(a) ; (b) ; (c) Because the decibel scale is logarithmic, dividing intensity by 25 corresponds to subtracting rather than dividing the decibel rating.
03 The student uses the natural logarithm instead of base-10 logarithm in the decibel formula, resulting in an incorrect decibel change of -32.2 dB.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You used the natural logarithm instead of the common logarithm . The decibel scale is defined using base-10 logarithms: .
- Step 3
Because the sound level uses a log function, multiplying intensity by a factor causes an additive shift in decibels instead of dividing the decibel value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied the inverse-square law to relate wave intensity to distance.
You accurately calculated the numerical intensity ratio as .
You correctly explained the mathematical property that turns multiplicative intensity changes into additive decibel differences.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeUsing instead of when applying the decibel formula.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the natural logarithm (base ) with the common logarithm (base ). The Bel scale and decibel system are defined strictly in powers of (base ), where and .
REASONING PATH
Your ACEpath teacher’s suggested approach- Logarithm Base in Decibel Formulas
Sound intensity level is defined as , not .
Always write or explicitly when working with decibels, and select the 'LOG' button (base ) rather than 'LN' on your calculator.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the definition of sound level change using base-10 logarithm: .
Substitute the intensity ratio from part (a): .
Evaluate using base-10 logarithm: .
(a) ; (b) ; (c) Because the decibel scale is logarithmic, multiplying intensity by a factor corresponds to an additive or subtractive shift in decibels.
Lock it in
How does sound intensity scale with distance from an isotropic point source radiating spherical waves?
. Power spreads over a sphere of surface area , giving .
Similar question
A sound source radiates spherical waves uniformly. If listener 1 is at and listener 2 is at , calculate the intensity ratio and the difference in sound level .
Answer
. .
A person walks directly away from an omnidirectional point speaker until the sound intensity level drops by exactly . By what factor has their distance from the speaker increased?
Answer
. Because , . The distance increased by a factor of 10.
A sound meter measures an intensity level of at a distance of from a small outdoor siren radiating spherical waves. What will the sound intensity level be at a distance of , assuming no reflections or ground absorption?
Answer
Distance increases by a factor of . By the inverse-square law, intensity decreases by a factor of . Level drop: . New sound level: .