Resources
A student sets up a double-slit experiment in air using light of wavelength and slit separation , observing an adjacent bright-fringe spacing of on a screen at distance . The entire apparatus is then submerged in a transparent liquid of refractive index . Counter to the student's initial intuition that adding a medium with a higher optical density will cause the fringes to spread farther apart, calculate the new fringe spacing (in millimeters) in the liquid and state whether the pattern compressed or expanded.
Answer and steps
Final answer
(the fringe pattern compresses)
Steps
Relate Fringe Spacing to Wavelength
In Young's double-slit experiment, the distance between adjacent bright fringes on a distant screen is given by the small-angle approximation:
where:
- is the wavelength of light in the surrounding medium,
- is the distance from the slits to the screen,
- is the separation between the two slits.
Initially, in air (where ), the fringe spacing is:
Determine the Wavelength in the Liquid
When light travels from air into a medium with refractive index , its frequency remains unchanged because the oscillations are driven by the source. However, the speed of light decreases to . Consequently, the wavelength in the liquid, , shortens according to the wave relation :
For :
Calculate the New Fringe Spacing
Because the physical geometry of the apparatus ( and ) does not change when submerged, the new fringe spacing is:
Substitute the given values:
Qualitative Behavior: Compression vs. Expansion
Because the refractive index of the liquid is greater than that of air (), the wavelength decreases (). Since fringe spacing is directly proportional to wavelength (), the distance between adjacent fringes decreases:
Therefore, the interference pattern compresses (the fringes move closer together).
Common Pitfall: A higher refractive index means a denser optical medium, which students sometimes intuitively associate with "spreading" or scattering waves. In reality, the wave speed slows down while the frequency remains constant, forcing the wavefronts closer together (smaller wavelength) and reducing the diffraction/interference spread on the screen.
Typical errors
01 The student assumes that wavelength increases in an optically denser medium by multiplying by the index of refraction, leading to an expanded fringe spacing.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Light slows down upon entering an optically denser medium () while frequency remains constant, which causes the wavelength to shorten to rather than increase.
- Step 2Correct
Because fringe spacing is directly proportional to wavelength (), dividing by requires dividing the fringe spacing by .
- Step 3
The fringe pattern expanded.
CorrectThe fringe pattern compressed.
Because the new fringe spacing is smaller than the original , the fringes move closer together, meaning the pattern compresses.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that the change in fringe spacing depends directly on the change in wavelength.
You correctly substituted the numerical values into your chosen formula.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the index of refraction as an expansion factor rather than a slowing and wave-compressing factor, multiplying and by instead of dividing by .
REASONING PATH
Your ACEpath teacher’s suggested approach- Wave speed and wavelength in a medium
and
Always remember that in an optically denser medium (), light slows down while frequency remains constant, so the wavelength must decrease.
- Double-slit fringe spacing scaling
When the surrounding medium changes without altering geometry ( and ), scale the fringe spacing inversely with : .
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the wavelength relation for a medium with refractive index : .
Substitute into the fringe-spacing formula: .
Compare with : since , the fringe spacing is smaller.
(the fringe pattern compressed)
02 The student misremembers the fringe spacing formula with wavelength in the denominator, concluding that a shorter wavelength causes fringes to spread farther apart.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
In double-slit interference, the path difference between adjacent bright fringes satisfies , which gives . Placing in the denominator inverted the direct proportionality between fringe width and wavelength.
- Step 3Correct
Because of the inverted formula in Step 2, you multiplied by the refractive index instead of dividing by it.
- Step 4
The fringe pattern expanded.
CorrectThe fringe pattern compressed.
Because your calculated spacing was larger than the initial spacing, you concluded the pattern expanded. With the correct value , the pattern compresses.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied the relationship to find the shortened wavelength in the liquid medium.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNo, this is a conceptual error involving the geometric derivation and proportionality of fringe spacing in wave interference.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou misremembered the Young's double-slit fringe spacing formula by placing the slit separation in the numerator and wavelength in the denominator. Remembering that diffraction and interference spreading scale directly with wavelength () prevents this inversion.
REASONING PATH
Your ACEpath teacher’s suggested approach- Derive from path difference
Constructive interference requires . For small angles, , leading directly to .
Always verify the position of variables by checking that increasing must increase the diffraction and fringe spread.
- Dimensional and physical sanity check
Fringe spacing has units of length (meters). In , units are . In , units are also meters, but physically, zero wavelength (ray optics limit) must yield zero fringe separation, not infinite separation.
Check the limiting case: as , wave effects vanish, so fringe spacing must approach , requiring to be in the numerator.
CORRECTED PATH
ACEpath Teacher's DemonstrationState the standard fringe spacing formula: .
Relate the submerged spacing to the air spacing: .
Substitute the given values: .
Compare spacings: since , the fringes move closer together.
; the fringe pattern compressed.
03 The student correctly calculates the compressed fringe spacing but misinterprets smaller spacing as an expansion of the fringe pattern.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
Because the fringes are closer together, the pattern expanded.
CorrectBecause the fringe spacing decreased from to , the fringes are closer together, so the pattern compressed.
When adjacent fringes move closer together, the overall spacing across the screen shrinks, which corresponds to compression, not expansion.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the wavelength reduction relation to express the new fringe spacing as .
You accurately calculated .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou correctly noted that the fringes are closer together, but wrote that the pattern expanded instead of compressed.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the spatial extent of the interference pattern with fringe count: packing more fringes into a given space makes each fringe interval smaller, which means the physical pattern has compressed or squeezed together.
REASONING PATH
Your ACEpath teacher’s suggested approach- Fringe Spacing vs. Pattern Size
An interference pattern expands when fringe spacing increases, and compresses when decreases.
Check the sign of change: if , the pattern shrinks toward the central maximum (compresses).
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the initial and final fringe spacings: .
Because the distance between neighboring bright maxima decreased, the interference fringes cluster closer to the central axis, which means the pattern compressed.
, compressed
Lock it in
When light enters a medium with refractive index , how do its frequency , speed , and wavelength change?
Frequency stays constant, speed decreases to , and wavelength decreases to .
Similar question
A double-slit experiment uses light of wavelength in air, producing bright fringes spaced by . What is the fringe spacing if the entire setup is submerged in a liquid with index of refraction ?
Answer
. The fringe pattern compresses.
In a double-slit setup immersed in an unknown oil, the fringe spacing is measured to be . When the setup is cleaned and operated in air with the same light source and geometry, the fringe spacing is . Determine the refractive index of the oil.
Answer
Since , we have .
A double-slit apparatus submerged in water () produces fringes separated by . By what factor must the slit separation be changed so that the fringe spacing returns to the original air value without removing the apparatus from water?
Answer
To restore , we require , so . Thus, the slit separation must be reduced by a factor of (multiplied by ).