Resources
In a physics laboratory experiment, a student determines the spring constant of a vertically suspended spring by attaching known calibration masses to the lower end and recording the static equilibrium extension using a vernier height gauge. The collected data is tabulated as follows:
Using : (a) Determine the experimental spring constant from the slope of the force vs. elongation relationship ( vs. ). (b) Calculate the elastic potential energy stored in the spring when supporting the mass at static equilibrium.
Answer and steps
Final answer
(a) ; (b)
Steps
Part (a): Determine the Spring Constant
-
Relate Force and Extension at Static Equilibrium: When a mass hangs at rest from a vertical spring, the upward restoring force exerted by the spring balances the downward gravitational force:
According to Hooke's Law, the magnitude of the restoring force is directly proportional to the extension :
-
Calculate the Restoring Force for the Data Points: Using :
- For :
- For :
- Determine the Slope of the vs. Line: Because the data shows a linear relationship, the spring constant is the slope of the versus line:
Part (b): Calculate the Elastic Potential Energy
- Formula for Elastic Potential Energy: The energy stored in an extended ideal spring is given by the integral of the restoring force over the extension, which corresponds to the area under the force-displacement graph:
- Substitute the Values for the Load: At , the measured extension is . Using :
(Common Pitfall: Do not calculate the elastic potential energy as . Because the spring force increases linearly from to as it stretches, the average force applied is only , resulting in the factor of in .)
Typical errors
01 The student forgets to multiply the mass by gravitational acceleration g when determining the slope, calculating mass versus extension instead of force versus extension.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You calculated the slope of mass versus extension () rather than restoring force versus extension (). In Hooke's Law, , the balancing restoring force at static equilibrium equals the weight , not simply the mass .
- Step 2Correct
You correctly applied the elastic potential energy formula and substituted the proper extension, but the numerical result was affected by the incorrect value of from Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou selected appropriate endpoints from the data table to compute the slope.
You correctly stated and used the elastic potential energy formula .
You performed the algebraic substitutions and decimal arithmetic accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set the restoring force equal to mass instead of weight .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated mass with gravitational force , treating kilograms directly as newtons when evaluating the slope of the force-extension curve.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Hooke's Law quantities and units
Hooke's Law balances force with extension: , meaning with units , or .
Always convert suspended mass to weight using before computing the spring constant.
- Verify slope dimensions
The ratio has units of , which is mass per unit length, not stiffness.
Multiply by to obtain the spring constant in .
CORRECTED PATH
ACEpath Teacher's DemonstrationCompute the change in gravitational force: .
Divide by the corresponding stretch: .
Substitute and into the energy formula: .
(a) ; (b)
02 The student forgets the square on the stretch in the formula for elastic potential energy, writing Us = (1/2)ky instead of (1/2)ky².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
F = mg k = = k = = 40.0
- Step 2
U_s = ky U_s = (40.0)(0.1225)
CorrectU_s = ky^2 = (40.0)(0.1225)^2
You omitted the exponent on the stretch . The energy stored in a spring is the area under the force-displacement graph (or the integral ), giving .
- Step 3
U_s = 2.45
CorrectU_s = 0.300
Your arithmetic matches your formula, but the value is incorrect because it stems from using the linear formula instead of the quadratic one.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the equilibrium condition to find the force on each mass.
You correctly computed the slope of the force versus elongation line to find .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNo, this represents a conceptual formula error where stretch is treated linearly rather than quadratically.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou wrote instead of . The product represents the restoring force , not energy. To obtain units of energy (Joules = ), the spring force must be multiplied by another factor of displacement, reflecting the triangular area under the line: .
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional and Unit Consistency
Energy has units of Joules (). Since the spring constant is measured in , the term has units of (force), whereas has units of (energy).
Always verify units before completing an energy problem: ensure your expression yields rather than just .
- Work Done by a Linearly Varying Force
The work required to stretch a spring from to is .
Recall that spring potential energy is quadratic in displacement () because the restoring force increases linearly with stretch.
CORRECTED PATH
ACEpath Teacher's DemonstrationState the correct formula for elastic potential energy: .
Substitute and : .
Evaluate the expression: .
(a) ; (b)
03 The student computes the reciprocal of the slope (stretch over force) instead of force over stretch when calculating the spring constant.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
According to Hooke's law, , meaning the spring constant is the ratio of force to stretch, , which gives units of . You calculated , which represents compliance () with units of .
- Step 2Correct
Your formula and algebra for elastic potential energy are completely sound, but your numerical answer inherits the inverted value from Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the gravitational force values for the hanging masses.
You selected the correct formula for stored elastic potential energy.
You correctly evaluated the algebraic expression without calculation errors based on your intermediate values.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated stretch over force () as the spring constant instead of force over stretch (), conflating the independent and dependent variables on the force vs. elongation relationship.
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit and Dimensional Check
The SI unit for spring constant is Newtons per meter (), representing force divided by extension.
Check that your slope calculation matches the units : evaluate rather than .
- Hooke's Law Definition
In static equilibrium, the restoring force satisfies .
Isolate algebraically before substituting values: .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the spring constant as force per unit extension: .
Substitute the corrected spring constant and static stretch into .
Compute the elastic potential energy: .
(a) ; (b)
Lock it in
What is the defining relationship for spring constant in a vertical hanging spring experiment?
. You must multiply the suspended mass by because Hooke's Law relates force to extension, not mass to extension.
Similar question
A vertical spring stretches by when a calibration mass is hung from it in static equilibrium. Using , find the spring constant .
Answer
. Calculate weight . Then apply Hooke's Law: .
A student plots suspended mass (in ) on the vertical axis versus spring extension (in ) on the horizontal axis and finds a best-fit line slope of . Using , calculate (a) the spring constant and (b) the elastic potential energy stored when the spring is stretched by .
Answer
(a) ; (b) . (a) Since , . (b) .
An unloaded vertical spring of unstretched length is mounted above a lab bench. Suspending a mass increases its total length to , and increasing the mass to increases its total length to . Using , determine the elastic potential energy stored in the spring under the load.
Answer
. The change in extension is . The change in force is . Thus, . Total stretch under is . Therefore, .