Resources
Consider the limiting case of a double-slit setup where the slit separation is made arbitrarily small relative to the wavelength . For incident light of wavelength , determine the critical threshold slit spacing below which no non-zero interference maxima () or minima can be formed on a planar screen at any distance . Furthermore, for , determine the total number of interference minima that appear in the full angular range .
Answer and steps
Final answer
(i.e., ); exactly minima appear for (at )
Steps
Condition for Interference Features on a Planar Screen
In Young's double-slit experiment, the path difference between the waves arriving from the two slits separated by distance at an angle relative to the central normal is:
For a planar screen positioned at an arbitrary distance parallel to the slit plane, the light rays span the physical angular range:
Therefore, the maximum possible path difference between the two sources in the forward hemisphere is bounded by:
Threshold Slit Spacing
The conditions for interference extremes are:
- Maxima: , where
- Minima (destructive interference): , where
The central maximum always exists at (). As decreases, the first non-trivial fringe to disappear is the first non-zero maximum at (requiring ), followed ultimately by the very first pair of minima (), which requires:
For at least one pair of minima to physically appear on the screen, the maximum path difference must be strictly greater than :
Below this critical threshold, even a half-wavelength path difference cannot be attained at any physical angle, so no destructive interference minima or non-zero maxima can form:
Substituting :
Common Pitfall: Do not confuse the condition for the first higher-order maximum () with the condition for any interference variation to exist. Minima occur at half-integral multiples of , so the threshold for having any fringes other than the central bright region is governed by the first minimum at .
Number and Angles of Minima for
The angular locations of the interference minima satisfy:
Substitute :
- For the first order (): Since , these angles are physically realized:
- For the second order (): Because , no real solution exists for .
Thus, exactly minima appear across the entire angular range , located symmetrically at .
Typical errors
01 The student confuses the condition for the first interference minimum with the condition for the first non-zero interference maximum, setting d_crit = λ instead of λ/2.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
First non-zero maximum occurs at : For no fringes to form, , so
CorrectThe first interference feature to disappear is the first-order maximum at , but destructive interference minima can still form down to . For neither non-zero maxima nor minima to form, we require , so .
You considered the disappearance of the first non-zero maximum at . However, destructive interference minima satisfy . The very last interference fringe to disappear as decreases is the minimum, which requires .
- Step 2
Minima condition:
- Step 3
Integer values are Total number of minima =
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the grating equation for destructive interference, .
You correctly applied the physical domain constraint for a planar screen.
You correctly solved the inequality for integer values of and determined the exact count of minima.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated the condition for 'no fringes at all' with the disappearance of the bright fringe, overlooking that dark fringes persist for smaller slit separations.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisDestructive interference occurs at path differences of half-integer wavelengths, . The smallest non-zero path difference that produces an observable fringe variation is the first dark fringe at . Because , the dark fringes survive down to a smaller slit width () than the bright fringes ().
REASONING PATH
Your ACEpath teacher’s suggested approach- First feature to vanish vs. last feature to vanish
As slit spacing decreases, higher-order fringes vanish first. The last fringe pattern variation to disappear is the lowest-order minimum (), where the required path difference is .
When asked for the cutoff below which no fringes or intensity variations exist, set the maximum possible path difference equal to the smallest non-zero fringe requirement, .
CORRECTED PATH
ACEpath Teacher's DemonstrationThe condition for destructive interference is .
The lowest required path difference for any non-trivial fringe is the minimum: .
On a planar screen, the maximum possible path difference is bounded by .
Therefore, for no minima (and no higher-order maxima) to form at any angle, we must have , which gives .
; total number of minima =
02 The student forgets that diffraction/interference minima occur symmetrically on both sides of the central axis (negative angles) and counts only the positive angle order.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Minima occur at
- Step 2
- Step 3Correct
You restricted the angular range to instead of the full forward hemisphere . Minima occur symmetrically on both sides of the central axis ( and ).
- Step 4Correct
Because each allowed order yields two symmetric minima ( and ), there are minima in total.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the half-wavelength path difference condition for the disappearance of interference fringes.
You accurately calculated .
You correctly set up the angular inequality for the order .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou solved for the number of minima only in the half-space instead of the full range .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the angular variable as an unsigned magnitude rather than a signed angle spanning both sides of the central normal, forgetting that diffraction and interference patterns are symmetric about .
REASONING PATH
Your ACEpath teacher’s suggested approach- Symmetry of Interference Extremes
Interference fringes satisfy (minima) and (maxima).
Always account for both positive and negative angles unless the problem explicitly restricts you to one side of the central axis.
- Counting Total Fringes
For a planar screen spanning , each valid non-zero solution () corresponds to two distinct fringes.
Multiply the count of non-central orders by to account for both symmetric halves of the screen.
CORRECTED PATH
ACEpath Teacher's DemonstrationThe condition for minima over is .
This yields , so the only integer solution is .
For , , giving two solutions: .
; exactly minima appear for (at )
03 The student uses the single-slit diffraction minimum condition a sin θ = mλ instead of the double-slit interference minimum condition.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Minima occur at First minimum is at :
- Step 2
Minima condition:
CorrectYou used the condition , which applies to double-slit maxima (or single-slit diffraction minima). For double-slit interference minima, destructive interference requires a half-integer path difference: .
- Step 3
requires For minima cannot be , so no integer satisfies this Total number of minima
CorrectFor , ; for , . Total number of minima .
Carrying forward the correct half-integer formula gives , which yields exactly valid physical angles within .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that the threshold for any non-zero fringe is set by the very first interference minimum at .
You calculated the critical spacing accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the condition for double-slit interference minima with either the single-slit diffraction minimum rule () or the double-slit maximum rule (), even after writing the correct half-integer rule earlier on the page.
REASONING PATH
Your ACEpath teacher’s suggested approach- Double-slit vs. Single-slit Minima Condition
For two discrete point sources (double slit), destructive interference occurs when waves arrive exactly out of phase: . For continuous wavelets across one slit of width , complete cancellation occurs when ().
Always verify whether the problem deals with discrete two-slit interference (half-integers for dark fringes) or continuous single-slit diffraction (integers for dark fringes).
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the destructive interference condition for two slits: for .
Substitute : .
Test non-negative integers : for , , which is physically valid since .
For , , which has no real solution.
Total number of minima (at )
Lock it in
In a double-slit experiment, what is the minimum path difference needed to produce any non-uniform interference feature on a screen?
. This produces the first pair of destructive interference minima ().
Similar question
A double-slit apparatus is illuminated by monochromatic light of wavelength . Determine the minimum slit separation required for at least one pair of non-zero interference maxima to be visible on a distant screen.
Answer
For non-zero maxima (), the required path difference is . Since , we require . Thus, .
Light of wavelength is incident on two slits separated by . Determine the total number of interference maxima and the total number of interference minima observable across the full angular range .
Answer
For maxima: , so ( maxima). For minima: , so ( minima).
A double-slit setup in air has slit separation and uses light of wavelength . (a) Are any non-zero maxima visible? (b) How many minima appear? (c) If the entire apparatus is submerged in water (), what is the new total number of minima?
Answer
(a) In air, , so no non-zero maxima form. (b) For minima, and , yielding minima. (c) In water, , so . The condition still yields , so there are still exactly minima.