Resources
A whistle emitting sound at is attached to a string and swung in a horizontal circle of radius at an angular speed . A microphone is positioned in the plane of the circle at a very large distance . Assuming the speed of sound in air is , determine the maximum and minimum frequencies recorded by the distant microphone over one complete revolution.
Answer and steps
Final answer
,
Steps
Calculate the Linear Speed of the Sound Source
The whistle undergoes uniform circular motion. Its tangential speed along the circular path is related to the angular speed and the radius by:
Substitute the given values:
Relate the Source Motion to the Observer's Line of Sight
The microphone is located in the plane of the circle at a distance . Because the distance is much greater than the radius of the circle, the line of sight from the source to the microphone can be treated as essentially parallel throughout the entire orbit:
- The maximum Doppler shift towards higher frequencies occurs when the tangential velocity vector points directly toward the microphone (maximum component of velocity toward the observer, ).
- The minimum Doppler shift occurs half a revolution later, when the tangential velocity vector points directly away from the microphone (maximum component of velocity away from the observer, ).
Calculate the Maximum Frequency ()
When the source moves directly toward a stationary observer at speed , the wavefronts are compressed along the line of sight. Using the Doppler effect formula for a moving source and stationary observer:
where:
- is the emitted frequency,
- is the speed of sound,
- is the speed of the source.
Substitute the values:
Rounding to the nearest whole number gives:
Calculate the Minimum Frequency ()
When the source moves directly away from the stationary observer, the wavefronts are stretched:
Substitute the values:
Rounding to the nearest whole number gives:
(Pitfall to avoid: Do not average the speed or use the formula for a moving observer , as the Doppler shift for a moving source alters the wavelength rather than the speed of wave reception.)
Typical errors
01 The student misapplies the Doppler effect formula for a moving observer rather than a moving source, placing the source speed in the numerator.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You applied the formula for an observer moving toward a stationary source. Because the source is moving toward a stationary microphone, the wavefronts are compressed in space, which modifies the denominator: .
- Step 3Correct
You applied the formula for an observer moving away from a stationary source. For a source moving directly away from a stationary microphone, the apparent wavelength expands, giving .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the relationship between angular velocity, radius, and tangential speed.
You recognized that the extreme frequencies occur where the tangential velocity aligns directly along the observer's line of sight.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou swapped the roles of source and observer in the general Doppler effect expression , placing the source's speed in the numerator as if the microphone were moving instead of the whistle.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify which entity is in motion
In the general Doppler equation , the observer speed always appears in the numerator, and the source speed always appears in the denominator.
Check who is emitting the sound and who is detecting it before writing down the Doppler fraction.
- Physical mechanism check
Source motion physically changes the wavelength , leading to . Observer motion changes the relative speed of wave reception .
Whenever the source moves, place in the denominator.
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the stationary observer () and moving source formula: .
For maximum frequency (source moving toward the microphone along the line of sight), use a minus sign in the denominator: .
For minimum frequency (source moving directly away), use a plus sign in the denominator: .
,
02 The student reverses the signs in the denominator of the Doppler formula, associating approaching with a plus sign and receding with a minus sign.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
When the source moves toward the observer, the observed frequency increases because wavefronts are compressed. To make the frequency greater than , the denominator must be smaller than , requiring rather than .
- Step 3Correct
When the source moves away from the observer, the observed frequency decreases because wavefronts are stretched. To make the frequency lower than , the denominator must be larger than , requiring rather than .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the circular motion relation to find the source speed.
You accurately identified that the extreme frequencies occur when the velocity vector points directly along the observer's line of sight.
You performed the numerical arithmetic and rounding accurately for the formulas you set up.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou associated the positive sign with an increase in frequency and the minus sign with a decrease, forgetting that the source speed appears in the denominator.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisMisinterpreting how denominator signs affect fraction value in the moving-source Doppler formula: a source approaching compresses the wavelength, requiring a smaller denominator to yield a higher frequency .
REASONING PATH
Your ACEpath teacher’s suggested approach- Physical Reality Check
Approaching objects always produce an observed pitch higher than the source frequency (); receding objects always produce a lower pitch ().
Always compare your calculated answer to . If an approaching source yields a frequency lower than , check the denominator sign immediately.
- Denominator Logic for Moving Source
For a stationary observer and moving source, .
Use a minus sign in the denominator for approach to shrink the denominator and boost ; use a plus sign in the denominator for recession to enlarge the denominator and reduce .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the maximum frequency formula with the source approaching: .
Substitute the known values: .
Set up the minimum frequency formula with the source receding: .
Substitute the known values: .
,
03 The student calculates linear velocity as v_s = ω / R instead of v_s = ω * R, resulting in an incorrect source speed.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
To convert angular speed to tangential linear speed , multiply by the radius (). You divided by the radius instead, which gave an incorrect source speed.
- Step 2Correct
Your formula for the maximum frequency of an approaching source is completely correct, but the calculation was affected by using rather than .
- Step 3Correct
Your formula for the minimum frequency of a receding source is also correct, but the result is shifted due to the earlier source speed error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly chose the moving-source Doppler formulas for maximum and minimum perceived frequencies.
You correctly identified that the maximum frequency corresponds to the source moving directly toward the observer ( in the denominator) and the minimum corresponds to moving directly away ().
You carried out the algebraic arithmetic accurately based on your calculated source speed.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNo, this represents a conceptual confusion between linear and angular velocity relations rather than a minor transcription slip.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou inverted the relationship between linear speed and angular speed, using instead of . Checking the units ( versus ) will help you catch this immediately.
REASONING PATH
Your ACEpath teacher’s suggested approach- Relating Angular and Tangential Velocity
Tangential speed is proportional to the distance from the rotation axis: .
Always verify units before proceeding: multiplying by yields .
CORRECTED PATH
ACEpath Teacher's Demonstration,
Lock it in
In the general Doppler effect equation , which velocity belongs in the numerator and which in the denominator?
Observer speed is always in the numerator; source speed is always in the denominator. Memory cue: Alphabetical order from top to bottom (O over S).
Similar question
A stationary siren emits a sound at . A car drives directly toward the siren at . If the speed of sound is , calculate the frequency heard by the driver.
Answer
. Key steps: Here the observer moves and the source is stationary, so enters the numerator: .
A police car with a siren emitting travels at toward a stationary pedestrian. The speed of sound is . Find the frequency heard by the pedestrian, and compare it with the frequency the police officer would hear if the pedestrian were blowing a whistle instead.
Answer
(moving police car) vs. (moving officer). Key steps: For moving source: . For moving observer: . This illustrates that moving source produces a greater shift than moving observer at the same speed.
A sound source with frequency moves along a circular track of radius at constant speed . A detector is located in the circle's plane at a large distance. Assuming , find the ratio of maximum to minimum detected frequency .
Answer
. Key steps: . . The ratio is .