Resources
A small wheeled probe rolls off the edge of a horizontal elevated stage at height above the floor. A vertical protective wall of height stands at a horizontal distance of from the launch edge. Assuming the probe can be treated as a point particle, air resistance is negligible, and , calculate the minimum initial horizontal launch speed required for the probe to clear the top edge of the wall.
Answer and steps
Final answer
Steps
Set Up the Coordinate System and Motion Equations
A projectile launched horizontally has its initial velocity entirely along the horizontal direction:
- Horizontal initial velocity:
- Vertical initial velocity:
- Horizontal acceleration:
- Vertical acceleration: downward
Taking the launch point at the edge of the stage as the origin , the position of the probe at any time before landing is:
Determine the Maximum Allowable Fall Distance
To just clear the top edge of the wall, the probe must reach a horizontal distance of at least while its height is still at or above the height of the wall .
The maximum vertical drop permitted before the probe drops below the wall height is:
Calculate the Time to Fall to the Wall's Height
Using the vertical equation of motion for free fall from rest:
Solving for the time :
Common Pitfall: Do not use the full stage height to calculate time. Using gives the total time of flight to the floor, whereas clearing the wall only allows a vertical drop of .
Solve for the Minimum Launch Speed
During this time window , the probe must travel at least the horizontal distance :
Substitute the values:
Rounded to three significant figures, the minimum required launch speed is:
Typical errors
01 The student uses the total height of the stage h₁ rather than the height difference h₁ - h₂ as the vertical fall distance, allowing the probe to drop all the way to the ground.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
To clear a wall of height , the probe can only drop by by the time it reaches horizontal position . Using allows the probe to fall all the way to the floor, colliding with the wall.
- Step 2Correct
Your kinematic formula for free-fall time from rest is completely correct, but substituting the incorrect resulted in an overestimation of the available fall time.
- Step 3Correct
Your relationship is correct, but because the calculated time of flight was too long, your resulting minimum launch speed was too low.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that a horizontally launched projectile has zero initial vertical velocity.
You used the valid kinematic formula to connect vertical displacement and time.
You correctly related horizontal distance, time, and launch speed via .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set equal to the total stage height instead of the vertical distance between the stage and the wall's top edge.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the total flight distance to the ground with the specific constraint required to clear an intermediate vertical obstacle at height .
REASONING PATH
Your ACEpath teacher’s suggested approach- Define the Boundary Condition
For an obstacle of height launched from height , the maximum vertical drop allowed before passing the obstacle is .
Always sketch the trajectory and mark the vertical coordinate of the obstacle before writing down .
CORRECTED PATH
ACEpath Teacher's DemonstrationFind the maximum allowed vertical drop to clear the wall: .
Compute the time available to drop that distance: .
Calculate the minimum horizontal launch speed: .
02 The student uses the height of the wall h₂ instead of the vertical clearance distance h₁ - h₂ as the downward displacement.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The projectile falls from the stage height () to the top of the wall (), so the maximum allowable vertical drop before it dips below the wall is , not the wall's height itself.
- Step 2Correct
Your formula for free-fall time is correct, but substituting the incorrect vertical displacement led to an incorrect time of flight.
- Step 3Correct
Your horizontal velocity calculation follows correctly from your time value, but it inherits the error from the earlier step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that the initial vertical velocity is zero for a horizontal launch.
You applied the correct kinematic relationship between free-fall displacement and flight time.
You correctly linked the required horizontal range to the flight time to solve for launch speed.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the wall height directly as the displacement rather than the difference between launch height and obstacle height.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing an object's elevation above the ground reference level with its displacement relative to the launch point.
REASONING PATH
Your ACEpath teacher’s suggested approach- Displacement vs. Position
Displacement measures change in position, not ground elevation.
Always sketch the problem and explicitly subtract the final height from the initial height before using .
CORRECTED PATH
ACEpath Teacher's DemonstrationDetermine allowable downward drop:
Calculate maximum time allowed to drop this distance:
Compute minimum launch speed:
03 The student forgets the factor of 1/2 in the vertical displacement equation, writing Δy = gt² instead of (1/2)gt².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The formula for displacement from rest under constant acceleration is . Since , this becomes . You omitted the factor of .
- Step 3Correct
Your algebraic solving technique was correct, but this step carries forward the missing factor of from the previous step.
- Step 4Correct
Your relationship is correct for constant horizontal velocity, but the numerical result is affected by the incorrect flight time.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that the vertical motion determines the available time to clear the wall.
You accurately subtracted the wall height from the stage height to obtain .
You correctly used constant horizontal velocity to relate time, distance, and speed.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote the vertical free-fall displacement formula as instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the acceleration formula or average velocity derivation with total displacement, leaving out the that accounts for the linear increase in velocity from rest.
REASONING PATH
Your ACEpath teacher’s suggested approach- Constant Acceleration Displacement Formula
For an object starting from rest () under constant acceleration , displacement is , not .
Always write out the general kinematic equation before dropping zero-value terms.
- Dimensional and Average Velocity Check
Average velocity during free fall from rest is .
Multiply average velocity by time: to quickly verify that the is included.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the correct vertical motion equation with : .
Solve for the time of flight to drop : .
Compute the minimum launch speed required to travel horizontal distance : .
Lock it in
When a projectile is launched horizontally from height toward an obstacle of height , what vertical drop defines clearing the obstacle?
. The projectile must clear the top of the barrier, not fall all the way to the ground.
Similar question
A dart is projected horizontally from a height of above the floor. A barrier of height is located horizontally from the launch point. Taking , find the minimum launch speed needed to clear the barrier.
Answer
. The maximum drop is . The time to drop this distance is . The speed required is .
A stunt car drives off a flat rooftop of height at speed . An adjacent building rooftop has a height of and is separated horizontally by a gap of . What minimum horizontal velocity ensures the car lands on the adjacent rooftop? (Use ).
Answer
. Allowed vertical drop is . Time to fall is . The minimum horizontal velocity is .
A tennis ball is hit horizontally from a height of above the court. It must clear a net of height located away, and then land in-bounds before the baseline located from the launch position. Taking , find the range of initial speeds for a successful shot.
Answer
. To clear the net: , giving , so . To land before the baseline: , giving , so .