Resources
A research nuclear facility prepares an aqueous tracer solution of phosphorus-32 (, ) with an initial specific activity of . A technician dilutes a aliquot of this stock solution into an assay tank containing pure water to a total volume of . The diluted mixture is then stored for . Calculate the final activity concentration of the solution in microcuries per milliliter (), given that .
Answer and steps
Final answer
Steps
Calculate the activity concentration immediately after dilution
A volume of the initial stock solution with specific activity is mixed into water to a total volume of .
The total activity transferred to the tank is:
The activity concentration in the tank immediately after dilution is:
Converting this concentration to (since ):
Account for radioactive decay over the storage period
The diluted solution is stored for . With a half-life of , the number of elapsed half-lives is:
Using the radioactive decay law:
Convert the activity concentration to
We are given that . Therefore:
Converting the final concentration from to :
Typical errors
01 The student forgets to convert milliliters to liters when computing the dilution factor, calculating 20.0 / 50.0 instead of 0.0200 / 50.0.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You divided by without converting both volumes to the same unit first. Because , the dilution factor is , not .
- Step 2
- Step 3Correct
Your radioactive decay calculation and conversion from to were executed correctly, but the numerical result was scaled by the incorrect initial concentration .
- Step 4Correct
You correctly used the conversion factor , but the final answer inherited the factor error from Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the number of half-lives that elapsed over the storage period.
You applied the exponential decay formula properly.
You converted between megabecquerels per liter, becquerels per milliliter, and microcuries per milliliter with correct conversion factors.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou omitted unit conversion between milliliters and liters when calculating the ratio of aliquot volume to total tank volume, treating as dimensionless without matching prefixes.
REASONING PATH
Your ACEpath teacher’s suggested approach- Match volume units before computing dilution factors
The dilution factor is a dimensionless ratio; both and must be expressed in identical volume units.
Explicitly write units in the quotient, such as , and cancel them out before dividing.
CORRECTED PATH
ACEpath Teacher's Demonstration02 The student miscalculates radioactive decay as linear decay by multiplying by 3 half-lives rather than raising (1/2) to the third power.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Your dilution factor and initial value of are correct. However, and , which gives , so equals rather than .
- Step 2
- Step 3Correct
Radioactive decay is exponential, not linear. In each elapsed half-life, the remaining amount is multiplied by . After half-lives, the fraction remaining is , not .
- Step 4Correct
You set up the unit conversion from to correctly using , but the result is numerically off due to the earlier errors in Steps 1 and 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the volumetric dilution factor of .
You correctly found the number of elapsed half-lives by dividing total time by half-life.
You correctly used the conversion relation .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou dropped a factor of when converting from to .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated radioactive decay as a linear process (subtracting half-lives or dividing by ) instead of raising the retention factor to the power of the number of half-lives, .
REASONING PATH
Your ACEpath teacher’s suggested approach- Exponential Half-Life Law
, where
Always apply repeated multiplication by for each elapsed half-life rather than dividing by or subtracting.
- Compound Metric Conversions
Convert numerator and denominator prefixes separately when dealing with compound units like .
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the un-decayed concentration in consistent units: .
Apply the radioactive decay law for half-lives: .
Convert to : .
03 The student uses 1 μCi = 3.70 × 10¹⁰ Bq instead of 3.70 × 10⁴ Bq, confusing curies with microcuries during the unit conversion.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You assigned the full curie value () to instead of accounting for the prefix micro (). Since , dividing by made your answer six orders of magnitude too small.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the volumetric dilution factor and the diluted concentration before decay.
You correctly found that 3 half-lives elapsed and calculated the remaining activity concentration in becquerels per milliliter.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of , accidentally equating one microcurie directly to one curie.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the SI metric prefix () when applying an equivalence given for the base unit (curies).
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Prefixes on Non-SI and Derived Units
.
Always convert a prefixed unit to its base unit first, or substitute the numerical power of ten for the prefix before dividing.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the conversion from microcuries to becquerels: .
Divide the decayed activity concentration by the correct conversion factor: .
Lock it in
Why must you express and in the same unit when computing the dilution factor ?
Because a dilution factor is a dimensionless ratio. Dividing different units (such as by ) introduces an unintended factor of or .
Similar question
A radioactive stock solution of iodine-131 has an activity concentration of . A sample is diluted with buffer to a total volume of . Calculate the activity concentration of the freshly diluted solution in .
Answer
First, convert volumes to identical units to find the dilution factor: . Multiply by initial concentration: . Finally, convert to : .
A technician dilutes of a technetium-99m () solution with specific activity into saline to a total volume of . The solution is left for . Find the final activity concentration in .
Answer
Dilution factor: . Initial tank concentration: . Elapsed half-lives: . Final concentration: .
A aliquot of sodium-24 () with specific activity is added to an industrial water tank of total volume . After , what is the activity concentration in ? (, )
Answer
Match volume units: , . Dilution factor: . Initial tank concentration: . Elapsed half-lives: . Decayed concentration: . Convert to : .