Resources
In a scattering experiment, an alpha particle (, ) is fired head-on toward a stationary nucleus from a large distance with an initial kinetic energy of . Treating the lead nucleus as a point charge during approach: (a) find the distance of closest approach in femtometers (), and (b) compare this distance to the sum of their nuclear radii , where (, ), to determine whether the alpha particle touches the nuclear surface where the strong nuclear force takes over.
Answer and steps
Final answer
(a) ; (b) ; since , the alpha particle turns around before touching the nuclear surface.
Steps
Part (a): Finding the Distance of Closest Approach ()
- Principle of Conservation of Mechanical Energy: Because the lead nucleus is assumed stationary and only the conservative electrostatic force acts on the alpha particle, the total mechanical energy is conserved:
-
Setting up the Energy Equation:
- Initially, at a very large distance (), the electric potential energy is negligible, so the total energy is purely kinetic:
- At the distance of closest approach () in a head-on collision, the alpha particle momentarily comes to rest (). All initial kinetic energy is converted into electrostatic potential energy:
- Substituting Charges and Constants: The charges are and . Thus: Using the standard nuclear physics constant :
Part (b): Nuclear Radii and Surface Contact
-
Calculating the Nuclear Radii: The radius of a nucleus with mass number is modeled by:
- For the alpha particle ():
- For the lead nucleus ():
- Sum of Nuclear Radii: For the two nuclear surfaces to touch, the center-to-center distance must equal the sum of their radii:
- Comparison and Conclusion: Comparing the two distances: Since the distance of closest approach is significantly greater than , the repulsive Coulomb barrier halts and reverses the alpha particle before it can make contact with the lead nucleus. Therefore, the alpha particle turns around purely due to electrostatic repulsion, and the short-range strong nuclear force does not come into play.
Typical errors
01 The student confuses the atomic number Z with the mass number A for lead, using 208 instead of 82 for the charge of the nucleus in the potential energy calculation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You used the mass number as the charge of the lead nucleus instead of its atomic number . Nuclear charge is determined solely by the number of protons ().
- Step 3Correct
Your algebraic rearrangement and unit conversions were performed correctly, but the resulting numerical value was scaled up by a factor of due to the charge substitution error.
- Step 4
- Step 5Correct
Your comparison logic is sound, but it relied on the incorrect value of calculated in Part (a).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly equated initial kinetic energy to electrostatic potential energy to set up the turning point equation.
You correctly applied the formula using the mass numbers of both nuclei.
You accurately converted kinetic energy from to joules and distance from meters to femtometers.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted instead of into Coulomb's law.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused mass number (total nucleons: protons + neutrons) with atomic number (number of protons). Neutrons are electrically neutral, so only the protons contribute to the nuclear charge .
REASONING PATH
Your ACEpath teacher’s suggested approach- Nuclear Charge vs. Nuclear Mass
In nuclear notation , the positive charge is (protons only), whereas is the total nucleon count used for mass and radius scaling.
Before evaluating Coulomb potential energy, always check the lower index for charge and reserve the upper index for mass or radius.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the charge of the nucleus as .
Substitute into the energy conservation equation: .
Evaluate .
Compare with : since , the alpha particle turns around before contact.
(a) ; (b) ; since , the alpha particle turns around before touching the nuclear surface.
02 The student forgets to account for the alpha particle having a charge of +2e and uses q_alpha = 1e in the Coulomb potential energy expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You correctly applied conservation of energy, but an alpha particle is a helium nucleus with atomic number , so its charge is , not .
- Step 2
- Step 3
, so it touches the nuclear surface
Correct, so the alpha particle does not touch the nuclear surface
Your comparison followed logically from your calculated value of , but because was underestimated by a factor of 2, your final conclusion was reversed.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly equated initial kinetic energy to electrostatic potential energy at the turning point.
You used the convenient conversion factor cleanly.
You accurately computed the radii of both nuclei using .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted instead of for the charge of the alpha particle.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing an alpha particle's charge with that of a proton or singly charged ion (). An alpha particle is a helium-4 nucleus (), containing 2 protons, so .
REASONING PATH
Your ACEpath teacher’s suggested approach- Alpha particle charge definition
An alpha particle is a bare helium nucleus () consisting of 2 protons and 2 neutrons, giving it an electric charge of .
Whenever an alpha particle appears in Coulomb repulsion or electric field problems, immediately write down before setting up formulas.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute into the potential energy expression: .
Solve for using : .
Compare with the combined nuclear radii: .
(a) ; (b) ; because , the alpha particle turns around before touching the nuclear surface.
03 The student compares the closest approach distance only to the radius of the lead nucleus instead of the sum of both nuclear radii.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You treated the alpha particle as a point with zero radius instead of including its nuclear radius .
- Step 4
, so it does not touch the nuclear surface
Correct, so the alpha particle turns around before touching the nuclear surface.
Your qualitative conclusion is correct, but your comparison used an incomplete threshold distance because it omitted .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used conservation of energy to determine the distance of closest approach.
You used the nuclear radius scaling formula accurately for the lead nucleus.
You correctly understood that touching occurs when the center-to-center separation falls below the sum of the radii.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the alpha particle as a point particle when calculating the contact threshold, forgetting that both colliding nuclei have finite spatial extents given by .
REASONING PATH
Your ACEpath teacher’s suggested approach- Nuclear Contact Criterion
For two spherical nuclei of radii and to touch, their center-to-center separation must satisfy .
Always compute the radius of both the target and the projectile nucleus whenever the projectile is a composite nucleus (like an alpha particle) rather than a fundamental point lepton (like an electron).
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the radius of the alpha particle (): .
Find the total center-to-center touching distance: .
Compare with : since , the alpha particle turns around before touching the lead nucleus.
(a) ; (b) ; since , the alpha particle turns around before touching the nuclear surface.
Lock it in
In nuclear notation , which quantity determines the electric charge of the nucleus, and what is that charge?
The atomic number determines the charge: . The mass number includes uncharged neutrons and does not affect the net charge.
Similar question
An alpha particle () is directed head-on toward a stationary gold nucleus () with kinetic energy . Calculate the distance of closest approach in femtometers. (Take .)
Answer
.
A proton () is accelerated toward a stationary cobalt nucleus (). (a) Express the distance of closest approach in terms of initial kinetic energy . (b) What minimum kinetic energy (in ) is needed for the proton to reach the nuclear surface, given (treat the proton as a point charge)?
Answer
(a) . (b) Setting : .
In a nuclear fusion experiment, a deuteron () and a triton () collide head-on with equal kinetic energies in their center-of-mass frame. Modeling their radii as , find the minimum total kinetic energy (in ) required for their surfaces to touch.
Answer
- Charges: each has , so .
- Touching distance: .
- Energy required: .