Resources
A well-insulated vessel contains of liquid water at . Ice at is gradually added to the vessel. Determine the threshold mass of ice, , that must be added such that the entire system freezes into solid ice at with no liquid remaining and no further temperature decrease below . Use and .
Answer and steps
Final answer
Steps
Heat Released by the Freezing Water
Principle of Thermal Equilibrium
In a thermally insulated container, no heat enters or leaves the system from the outside. By the principle of conservation of energy, the heat lost by the warmer substance (the liquid water undergoing a phase change) must equal the heat gained by the colder substance (the ice warming up):
The initial state of the liquid water is at . To turn into solid ice at the same temperature (), the water must undergo a complete phase change without changing temperature.
The heat released during this freezing process is given by the latent heat of fusion:
Substitute the given values:
Heat Absorbed by the Ice
The added ice has an initial temperature of and warms up to a final temperature of without melting. The temperature change is:
The heat absorbed by the ice to reach is:
Substitute the specific heat of ice and the temperature increase:
Solve for the Required Mass of Ice
Set the heat released equal to the heat absorbed:
Rounding to three significant figures gives:
Pitfall Note: The water starts at its freezing point (), so it only releases latent heat during freezing; do not include a term for the water. Similarly, the ice only warms up to without melting, so no latent heat term applies to the cold ice.
Typical errors
01 The student includes a latent heat of fusion term for the added ice, mistakenly assuming the ice must also undergo a phase change rather than only warming to 0.0°C.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The ice starts at and only warms up to . Because the final state of the entire mixture is solid ice at , the ice does not undergo a phase change (it does not melt), so you should not add .
- Step 3Correct
You correctly set the heat gained equal to the heat lost and solved for the mass, but the numerical answer was affected by the extra latent heat term in Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that the water undergoes a phase change from liquid to solid at using .
You correctly applied energy conservation by equating the heat released to the heat absorbed.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou included latent heat of fusion for both the water and the ice. Latent heat is only exchanged when a substance actually changes its physical phase. Here, the water freezes from liquid to solid, but the added ice merely warms from to and remains solid.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Initial and Final Phases
A phase change term () only applies when a substance transitions between solid, liquid, or gas phases.
Check each component's starting state and target state. If the state remains solid throughout, use only .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the heat absorbed by the ice as it warms from to without melting: .
Equate heat absorbed by the ice to heat released by the freezing water: .
Solve for : .
02 The student equates the masses and specific heat capacities directly or assumes heat transfer depends only on temperature change without accounting for the latent heat of fusion of the freezing water.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You treated the heat exchange as depending solely on temperature change via . When liquid water at freezes into solid ice at , it releases latent heat of fusion, so even though .
- Step 2Correct
Because you set the latent heat release to zero, you attempted to balance sensible heat terms directly and set the masses equal.
WHAT YOU DID WELL
Compliments from Your TeacherYou identified that the temperature change for the liquid water is .
You noted the temperature span of across which the ice warms up.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated constant temperature () with zero thermal energy transfer, overlooking that freezing liquid water releases latent heat of fusion () at a constant temperature.
REASONING PATH
Your ACEpath teacher’s suggested approach- Phase Change vs. Temperature Change
During a phase change at a constant melting/freezing temperature, heat transfer is given by , not .
Always check whether a substance changes phase; if it does, include even when .
- Thermal Energy Conservation
, where heat absorbed by cold ice warming up equals heat released by water freezing.
Set and solve for .
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the latent heat released as the water completely freezes: .
Calculate the heat absorbed per kilogram of ice warming from to : .
Apply energy conservation to solve for : .
03 The student divides the temperature change by latent heat or inverts the heat balance equation, computing m_ice = Q_absorbed / Q_released instead of equating them.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the fraction. Because total heat balance requires , solving for mass gives . Checking the units confirms that , whereas your calculation had units of .
- Step 4Correct
This result follows directly from evaluating the inverted ratio in Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that the liquid water only undergoes a phase transition at and calculated .
You correctly identified that the ice only undergoes temperature change up to without melting and calculated .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally placed the specific heat change in the numerator and total energy in the denominator when rearranging .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisInverting the relationship between total heat and heat per unit mass during isolation of the unknown mass, which could be caught by checking dimensional units ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Set up the full heat conservation equation first
Always write before isolating variables.
Write explicitly so the division step is mathematically transparent.
- Perform dimensional analysis on final ratios
Mass must have units of kilograms ().
Verify that . Dividing results in , signaling an inverted quotient.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the thermal equilibrium balance: .
Solve for : .
Evaluate the quotient: .
Lock it in
When does a thermal calculation require a latent heat term ()?
Only when a substance changes its state of matter at its transition temperature (such as melting or freezing), not when it simply warms or cools.
Similar question
A sample of of liquid water at is placed in a calorimeter. Solid ice at is added until all the water just freezes into solid ice at . Calculate the mass of ice required. (Use and .)
Answer
. Heat released by freezing water: . Heat absorbed by ice warming to : . Equating gives .
An insulated container holds of liquid water at . How much ice at must be added so that the final equilibrium state is all solid ice at ? (Use , , and .)
Answer
. Heat released by water cooling to and freezing: . Heat gained by ice warming to : . Thus .
A mixture contains of ice and of liquid water at thermal equilibrium at . Ice at is introduced into the insulated container until all liquid water is just converted to ice at . What mass of the cold ice was added? (Use and .)
Answer
. Only the liquid water freezes, releasing . The existing ice at undergoes no temperature or phase change. The added cold ice warms by : . Equating gives .