Resources
A spherical metal satellite component of outer radius is operated in deep-space vacuum where convective heat transfer is absent and the background environmental radiation temperature is . An internal electronic payload dissipates a steady thermal power of , all of which is radiated into space from the satellite's spherical surface at steady state. If the surface temperature of the satellite is measured to be (), determine the surface emissivity required to maintain this thermal equilibrium. Use .
Answer and steps
Final answer
.
Steps
Identify the Governing Heat Transfer Mechanism
In the vacuum of deep space, there is no surrounding medium (fluid or gas), which means heat transfer by conduction and convection to the surroundings cannot occur. The entire thermal power generated internally must be dissipated into space exclusively by thermal radiation.
According to the Stefan-Boltzmann law for a gray surface radiating to large surroundings:
where:
- is the rate of net heat transfer from the satellite,
- is the surface emissivity (),
- is the Stefan-Boltzmann constant,
- is the outer surface area of the sphere,
- is the absolute surface temperature of the satellite,
- is the absolute background radiation temperature of deep space.
Calculate the Radiating Surface Area
For a sphere of radius , the surface area is:
Evaluate the Temperature Terms
Temperatures in radiation calculations must always be in absolute units (Kelvin):
Evaluating the fourth powers:
Notice that is negligible compared to :
Common Pitfall: Never calculate . Thermal radiation power depends on the difference of the fourth powers of the temperatures, , not the fourth power of the temperature difference.
Solve for the Emissivity
Rearranging the heat transfer equation for emissivity:
Substitute the known values into the equation:
Thus, the satellite requires a surface emissivity of to remain at in steady state.
Typical errors
01 The student uses the Celsius temperature rather than absolute temperature in kelvins when applying the fourth-power radiation law.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The Stefan-Boltzmann radiation law requires thermodynamic temperature in absolute units (kelvins). You entered directly instead of converting it to .
- Step 3Correct
Your algebra followed your previous equation, but the result was distorted by using Celsius in the fourth-power term. Surface emissivity must always satisfy .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that radiation is the sole heat dissipation mechanism in vacuum.
You accurately calculated the surface area of the sphere using .
You recognized that space background radiation at is negligible compared to the satellite surface emission.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou substituted temperature in degrees Celsius () directly into the Stefan-Boltzmann law instead of using absolute temperature in kelvins (). Because radiation scales with , temperature differences cannot be used interchangeably with scale offsets, and absolute temperature is required.
REASONING PATH
Your ACEpath teacher’s suggested approach- Absolute Temperature in Radiation Laws
Thermal radiation power depends on the fourth power of absolute temperature: , where must always be in kelvins ().
Before evaluating powers of temperature such as , convert degrees Celsius to kelvins using .
- Physical Range of Emissivity
By definition, emissivity is the ratio of actual emission to blackbody emission and must satisfy .
If a computed emissivity yields a value outside (such as ), immediately check whether temperature was converted to kelvins or if an area/power value was misplaced.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the surface temperature to kelvins: .
Evaluate the fourth power: .
Substitute into the radiation balance: .
Solve for emissivity: .
02 The student misremembers the surface area of a sphere as the cross-sectional area π * r² instead of 4 * π * r².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You used the area formula for a flat circle rather than the total surface area of a sphere. Because thermal radiation emits from the entire outer spherical surface, you need .
- Step 2
- Step 3Correct
Your rearrangement and temperature substitutions are mathematically sound, but this step inherits the incorrect surface area from Step 1.
- Step 4Correct
The calculation yields because the area in the denominator was four times too small. An emissivity value cannot exceed for any physical surface.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly stated the Stefan-Boltzmann radiation rate equation with fourth-power absolute temperatures.
You converted the temperatures properly into Kelvin and correctly recognized that deep space radiation is governed by .
You algebraically rearranged the equation for emissivity correctly.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the cross-sectional area of a disk () with the outer surface area of a three-dimensional sphere (). When solving thermal radiation problems, emission occurs across the entire exposed boundary area.
REASONING PATH
Your ACEpath teacher’s suggested approach- Area of Radiation Emission
A spherical object emits thermal radiation outward across its entire three-dimensional surface, . The disk formula applies only to projected cross-sections (such as absorbing collimated sunlight).
Always identify whether the problem describes full-surface emission () or directional projection () before calculating .
- Physical Bounds of Emissivity
By definition, surface emissivity must satisfy , where corresponds to an ideal blackbody.
If a calculated emissivity exceeds , immediately re-check your surface area and temperature units.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the correct spherical area into the solved expression for :
Evaluate the denominator:
Compute the ratio:
03 The student takes the fourth power of the temperature difference rather than the difference of the fourth powers.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Thermal radiation emission and absorption are each independently proportional to . Net radiated power is the difference between emitted power and absorbed power, which gives , not .
- Step 3Correct
Your algebra and arithmetic correctly followed your formula from Step 2, but the resulting numerical value was affected by the incorrect radiation law.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the outer surface area of the spherical satellite.
You used absolute temperature in Kelvin rather than Celsius in your calculation.
You properly set up the energy balance equation equating heat dissipation rate to radiated power.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou subtracted the temperatures before raising them to the fourth power. Because net radiation is the difference between emitted power (proportional to ) and absorbed environmental radiation (proportional to ), the Stefan-Boltzmann law requires computing the difference of fourth powers, .
REASONING PATH
Your ACEpath teacher’s suggested approach- Stefan-Boltzmann Net Radiation Law
Net radiative heat exchange between a convex gray body and large surroundings is .
Always evaluate each temperature to the fourth power individually before subtracting them.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the correct Stefan-Boltzmann radiation law: .
Evaluate the fourth powers: and .
Compute the difference: .
Solve for emissivity: .
Lock it in
Why must temperature always be in kelvins when applying the Stefan-Boltzmann law ?
The law is derived from absolute thermodynamic temperature. Because the relation is nonlinear (), a shift by changes the numerical value drastically, unlike linear temperature differences.
Similar question
A flat satellite panel has an exposed radiating area of and radiates directly into deep space (). It dissipates at a steady operating temperature of . Determine the emissivity of the panel coating. (Use .)
Answer
Convert temperature to kelvins: . Calculate . Using , .
A small spherical sensor of radius in an evacuated test chamber dissipates . The chamber walls are cooled to and the sensor surface is at . Find the sensor's surface emissivity .
Answer
Surface area . Convert sensor temperature: . Powers: and . Net difference: . Then .
An engineer miscalculates the power radiated by a plate at into deep space by entering instead of . By what factor does the engineer underestimate the true radiant heat flux?
Answer
The ratio of true radiant flux to the erroneous flux is . The true radiant heat flux is underestimated by a factor of approximately .