Resources
An acoustic transducer operating at a frequency of produces ultrasound pulses that propagate through human muscle tissue with a speed of . The beam enters an adjacent bone layer where the sound speed increases to . (a) Calculate the ratio of the acoustic wavelength in bone to that in muscle tissue, . (b) Determine the percentage change in the sound wave's wavelength upon entering the bone. (c) Does the wave frequency change across the boundary? State the frequency in the bone.
Answer and steps
Final answer
(a) ; (b) ; (c) Frequency remains unchanged; .
Steps
Part (a): Ratio of Wavelengths
The relationship connecting wave speed , frequency , and wavelength is given by the wave equation:
When a sound wave travels from one medium to another, its frequency remains constant because it is determined solely by the vibrating source producing the wave.
Applying this relation to both media:
Taking the ratio of the wavelength in bone to that in muscle:
Substitute the given sound speeds:
Part (b): Percentage Change in Wavelength
The percentage change in wavelength as the wave enters bone is defined as:
Using the ratio from Part (a):
Substitute the exact fraction :
The wavelength increases by approximately .
Part (c): Behavior of Wave Frequency
- Does frequency change? No, the wave frequency does not change across the boundary.
- Physical reason: Frequency is an intrinsic property of the acoustic source driving the oscillations. At the boundary between muscle and bone, the particles on one side physically drive the adjacent particles on the other side at the exact same rate of oscillation to maintain boundary continuity.
- Frequency in bone:
Typical errors
01 The student inverts the ratio of wavelengths by assuming wavelength is inversely proportional to wave speed.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Since wave speed is and frequency is constant across the boundary, wavelength is directly proportional to speed: . Therefore, the ratio must be , rather than .
- Step 2Correct
You correctly applied the formula for percentage change, but your result was affected by the inverted wavelength ratio from part (a). Using the correct ratio of , the percentage change is .
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that the frequency of the sound wave does not change across the boundary.
You stated the correct numerical value for the frequency in bone.
You set up the percentage change calculation using the correct relative difference structure.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou assumed an inverse relationship between wavelength and wave speed (writing ) instead of applying the direct relationship at constant frequency.
REASONING PATH
Your ACEpath teacher’s suggested approach- Proportionality Check
From , when frequency is constant, .
Always write out before setting up ratios so you match each medium's wavelength to its own speed: .
- Physical Reality Check
When a wave enters a medium where it travels faster, wave crests separate farther apart each cycle.
If wave speed increases (), verify that the wavelength also increases ().
CORRECTED PATH
ACEpath Teacher's DemonstrationRelate wavelength to speed at constant frequency: , so .
Substitute the speeds: .
Calculate the percentage change: .
(a) ; (b) ; (c) Frequency does not change; .
02 The student calculates the percentage change using the final wavelength in bone as the denominator instead of the initial wavelength in muscle.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Percentage change must be calculated relative to the initial value before entering the new medium, so the denominator must be (or ), not the final value .
- Step 3
f_{} = 2.50 10^4_
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied the wave relationship to find the ratio of wavelengths.
You recognized that wave frequency remains constant when passing from one medium to another.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou divided by the final value () instead of the initial base value () in the percentage change formula.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Initial vs. Final State
Always place the initial reference state in the denominator, which is the medium where the wave originated.
CORRECTED PATH
ACEpath Teacher's Demonstration$ = 100%$$
(a) ; (b) ; (c) Frequency remains unchanged; .
03 The student assumes wavelength is invariant across a boundary and mistakenly assumes frequency changes proportionally with speed.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You treated wavelength as constant across the tissue boundary. However, wave frequency is invariant across an interface because boundary particles must oscillate synchronously with the driving source. Since , the ratio of wavelengths equals the ratio of wave speeds.
- Step 2Correct
You calculated the percentage change consistently using your wavelength ratio of , but the calculation was affected by the initial incorrect assumption from part (a).
- Step 3Correct
You concluded that frequency changes proportionally with speed. In reality, frequency is strictly determined by the acoustic transducer and remains unchanged as the wave propagates through different media.
WHAT YOU DID WELL
Compliments from Your TeacherYou remembered the fundamental wave relationship .
You used the correct relative percentage change formula structure.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou swapped the boundary behaviors of frequency and wavelength, assuming wavelength stays fixed while frequency changes with wave speed.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing source-dependent properties with medium-dependent properties. Frequency is a temporal rate determined solely by the emitter and boundary continuity, whereas wave speed is governed by medium elasticity and density, which forces the spatial period (wavelength) to adjust.
REASONING PATH
Your ACEpath teacher’s suggested approach- Source Invariance Rule
Frequency depends only on the wave source and never changes when crossing a boundary between different passive media.
Always set first before analyzing changes in speed or wavelength.
- Medium Speed-to-Wavelength Link
Because with constant, wavelength is directly proportional to speed: .
If wave speed increases across an interface, stretch the wavelength accordingly; never hold wavelength constant.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the boundary condition: .
Express wavelength in each medium using : and .
Compute the ratio: .
Evaluate the percentage change: .
State the frequency in bone: (unchanged).
(a) ; (b) ; (c) Frequency does not change;
Lock it in
When a sound wave crosses into a new medium at constant frequency, how are wave speed and wavelength related?
They are directly proportional: , meaning .
Similar question
A sound wave with frequency travels from air () into water (). Find the ratio of the wavelength in water to the wavelength in air, , and the percentage change in wavelength.
Answer
Ratio: . Percentage change: .
An ultrasound wave passes from fat tissue () into liver tissue (). If the wavelength in fat is , find the wavelength in liver tissue and state whether the frequency changes.
Answer
Frequency does not change. Since , we have .
A seismic P-wave of frequency travels across a geological boundary from sedimentary rock () into granite (). Calculate: (a) the original wavelength , (b) the new wavelength , and (c) verify that .
Answer
(a) . (b) . (c) and , confirming direct proportionality.