Resources
Two ideal linear polarizers have their transmission axes crossed at so that no light passes through the system (). A student predicts that adding an extra absorbing polarizing filter can only decrease the transmitted intensity further. To test this intuition, a third ideal polarizer is inserted between the two crossed polarizers with its transmission axis oriented at relative to the first polarizer. If an unpolarized beam with initial intensity is incident on the first polarizer, calculate the new final transmitted intensity in , demonstrating that adding the intermediate polarizer paradoxically increases transmission.
Answer and steps
Final answer
Steps
Transmission through the First Polarizer ()
To determine the final transmitted intensity after inserting the intermediate polarizer, analyze the beam's polarization state and intensity sequentially through each of the three filters.
The incident beam is unpolarized with an initial intensity of:
When completely unpolarized light passes through an ideal linear polarizer, the transmitted light becomes linearly polarized along the polarizer's transmission axis, and its intensity is reduced by half:
Transmission through the Middle Polarizer ()
The light reaching the second polarizer is now linearly polarized along the axis of . The transmission axis of is rotated at an angle relative to .
According to Malus's Law, the intensity of linearly polarized light after passing through a polarizer oriented at an angle relative to its polarization direction is:
Applying Malus's Law for the transition from to :
Since :
The light emerging from is now linearly polarized at relative to .
Transmission through the Final Polarizer ()
The third polarizer was originally crossed with the first, so its axis is at relative to .
The relative angle between the polarization axis of the beam emerging from and the axis of is:
Applying Malus's Law again:
Since :
Why Transmission Paradoxically Increases
- Without the middle filter: The electric field vector from is strictly perpendicular () to the transmission axis of , resulting in transmission.
- With the middle filter: The middle polarizer projects the electric field onto a new axis at . This creates a non-zero component of the electric field along the direction of (), allowing light to pass through the otherwise fully blocked system.
Typical errors
01 The student measures the angle of the third polarizer relative to the first polarizer (90.0°) instead of relative to the preceding polarizer (60.0°), resulting in an intensity of 0 W/m².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
The angle in Malus's Law must be measured between the polarization direction of the incoming light (which is now aligned with at ) and the axis of at , giving , not .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the half-intensity factor for initially unpolarized incident light.
You correctly calculated the intensity transmitted through the intermediate polarizer using Malus's Law with .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou used the fixed lab/initial frame angle () rather than updating the reference frame to the relative angle between consecutive polarizing filters ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Reference Frame for Malus's Law
In Malus's Law , is always the relative angle between the polarization direction of the incoming beam and the transmission axis of that specific polarizer: .
At each consecutive polarizer, subtract the preceding polarizer's orientation angle from the current polarizer's orientation angle before taking the cosine.
CORRECTED PATH
ACEpath Teacher's DemonstrationFind the angle between the transmission axis of () and (): .
Apply Malus's Law at : .
Evaluate using : .
02 The student forgets that unpolarized light passing through the first polarizer is halved, erroneously applying Malus's law to the full initial intensity I₀.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
When completely unpolarized light passes through an ideal linear polarizer, the transmitted intensity is cut in half () because the electric field oscillations are uniformly distributed over all transverse directions.
- Step 2Correct
You correctly applied Malus's Law with , but this calculation inherited the un-halved intensity from Step 1.
- Step 3Correct
You correctly recognized the relative angle between the second and third polarizers as , but the final numerical value is doubled due to the initial omission of the one-half factor.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used Malus's Law () for successive polarizers.
You correctly evaluated and .
You correctly calculated the relative angle between the middle and final filters.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the behavior of unpolarized light entering a polarizer with polarized light entering an aligned polarizer, overlooking the one-half reduction factor for unpolarized light.
REASONING PATH
Your ACEpath teacher’s suggested approach- Incident Light State
Unpolarized light passing through an ideal linear polarizer always emerges with , whereas polarized light follows Malus's Law .
Always check whether the incoming beam is unpolarized or already linearly polarized before choosing your intensity formula.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the one-half rule for unpolarized light: .
Apply Malus's Law at the middle filter: .
Apply Malus's Law at the final filter: .
03 The student forgets to square the cosine in Malus's law, using cos(θ) instead of cos²(θ).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Malus's Law states that intensity is proportional to the square of the electric field amplitude, meaning , not .
- Step 3Correct
You correctly identified the relative angle between the second and third filters as , but this step inherits the incorrect prior intensity and repeats the omission of the square in Malus's Law.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied the half-intensity rule for unpolarized light entering the first polarizer.
You correctly identified the relative angle of between the second and third polarizers.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated transmitted intensity as scaling linearly with the projection factor rather than with the square of the electric field projection .
REASONING PATH
Your ACEpath teacher’s suggested approach- Amplitude vs. Intensity Relationship
The electric field amplitude after a linear polarizer is , but intensity depends on amplitude squared: .
Always write down explicitly before plugging in numeric values.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Malus's Law to the middle polarizer: .
Apply Malus's Law to the final polarizer with : .
Lock it in
What does the angle represent in Malus's Law, ?
It is the relative angle between the incident polarized light's electric field vector and the transmission axis of the analyzer filter, not an absolute laboratory angle.
Similar question
An unpolarized beam of light with initial intensity passes through three linear polarizers. Polarizer 1 has its axis vertical (), Polarizer 2 is oriented at to the vertical, and Polarizer 3 is oriented horizontal (). What is the final transmitted intensity?
Answer
. Step 1: . Step 2: . Step 3: , so .
A beam of light already linearly polarized with intensity at angle passes through two additional polarizers: the first oriented at and the second oriented at . Calculate the final transmitted intensity.
Answer
. Transition 1: . Transition 2: .
An unpolarized light beam of intensity passes through a sequence of four polarizers with transmission axes at , , , and respectively. Express the final intensity in terms of .
Answer
. Step 1: . Step 2 to 4: Each step rotates by , multiplying intensity by . Total transmission is .