Resources
In an experiment replicating the classic Millikan oil-drop method, two flat, circular parallel metal electrodes of diameter are separated by a vertical distance inside a temperature-regulated chamber. A high-voltage DC power supply establishes a potential difference between the plates, where the top plate is at higher potential. An oil droplet of density and measured radius is atomized into the chamber and observed through a telemicroscope to remain suspended perfectly stationary in midair between the plates. (a) Calculate the mass of the oil droplet. (b) Determine the electric potential energy of the suspended droplet if the bottom plate is grounded () and the droplet is suspended at a vertical height of above the bottom plate. (c) Determine the magnitude and sign of the net electric charge on the droplet, and calculate the exact number of elementary charges residing on the droplet. Take and .
Answer and steps
Final answer
(a) ; (b) ; (c) , corresponding to excess electrons.
Steps
Part (a): Mass of the Oil Droplet
- Volume of the spherical droplet: The droplet is spherical with radius . Its volume is:
- Mass calculation: Using the given density :
Part (c): Charge on the Droplet and Number of Elementary Charges
(Determining the charge first provides the value needed for the electric potential energy in Part (b).)
- Electric field between the parallel plates: The plates are separated by with a potential difference . The electric field between the plates is uniform and directed downward (from high to low potential):
-
Force balance for equilibrium: The droplet remains stationary in midair, meaning the net vertical force is zero:
- The downward gravitational force is:
- Therefore, the upward electric force must equal :
-
Magnitude and sign of the charge:
- Because the electric field points downward and the required electric force must point upward to counteract gravity, the charge must be negative.
- Solving for the magnitude:
- Thus, the net charge is:
- Number of elementary charges: Using the elementary charge :
Part (b): Electric Potential Energy of the Suspended Droplet
- Electric potential at the droplet's location: With the bottom plate grounded ( at ), the electric potential increases linearly with vertical height : At the droplet's position :
- Electric potential energy calculation: The electric potential energy of a charge at potential is: Using the suspended charge on the droplet: (Note: The negative sign indicates that a negative charge is located at a positive electric potential relative to ground.)
Typical errors
01 The student forgets that the downward electric field requires a negative charge to produce an upward force, wrongly concluding the charge and potential energy are positive.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Because gravity pulls the droplet downward, the required electric force must point upward toward the positive top plate. Since unlike charges attract, the droplet must carry a negative charge (). Alternatively, because points downward from the high-potential top plate to the grounded bottom plate, an upward force requires .
- Step 4
- Step 5Correct
Your potential calculation is completely correct, but substituting the positive charge sign propagated into a positive potential energy. With , the electric potential energy is negative: (or using unrounded intermediate values).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the spherical volume and mass of the oil droplet.
You correctly calculated the magnitude of the electric field and set up the static equilibrium force balance .
You accurately determined the number of elementary charges .
You correctly determined the electric potential at the droplet's position.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou assumed that being near or attracted to a positive plate meant the charge itself was positive, overlooking that electrostatic attraction requires opposite charges.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the sign of the source electrode with the sign of the test charge, rather than determining the sign from the required direction of the vector force relative to the electric field .
REASONING PATH
Your ACEpath teacher’s suggested approach- Establish the Electric Field Vector Direction
Electric field lines point from higher electric potential to lower electric potential: .
Identify that because , the electric field points vertically downward.
- Relate Force Direction to Charge Sign
The electrostatic force on a charge is . If and point in opposite directions, must be negative.
Since gravity points down, equilibrium requires to point up. Because points down, set .
CORRECTED PATH
ACEpath Teacher's DemonstrationDetermine the sign of : The electric field points downward from the top plate to the bottom plate. To balance gravity, must point upward. Thus, .
Calculate the electric potential energy: With and , .
(a) ; (b) (or ); (c) , with excess electrons.
02 The student confuses the droplet radius with diameter and divides the given radius by 2 to compute volume, leading to an eightfold underestimation of mass and charge.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The problem directly provides the measured radius , not the diameter. You did not need to divide by 2.
- Step 2Correct
Your formulas for sphere volume and mass from density are correct, but your numerical result is smaller by a factor of because of the halved radius in Step 1.
- Step 3
- Step 4Correct
Your physical reasoning that the electric force must be directed upward opposing gravity, making negative, is completely sound. The numerical value is affected by the undercalculated mass from Step 2.
- Step 5Correct
You correctly applied the definition of electric potential energy , but the final answer is affected by the propagated value of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the uniform electric field and the local electric potential at the droplet's height.
You set up the upward electric force to balance the downward gravitational force accurately.
You correctly deduced that the droplet's charge must be negative because the downward electric field must exert an upward force.
You used the correct relationship between charge and electric potential energy .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided the given radius by 2 at the very start of the calculation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisHabitual division by 2 occurs when encountering circular or spherical geometric quantities, assuming the prompt provided a diameter rather than an explicit radius.
REASONING PATH
Your ACEpath teacher’s suggested approach- Radius vs. Diameter Prompt Check
Only divide by 2 when the problem explicitly specifies a 'diameter'. If the problem states 'radius', use the value directly.
Always circle or underline the specific word ('radius' or 'diameter') in the problem text before writing down .
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the given radius directly in the sphere volume formula: .
Compute the correct mass: .
Recompute the charge from the force balance : , giving .
Find the number of elementary charges: .
Calculate the potential energy: .
(a) ; (b) ; (c) , excess electrons
03 The student misidentifies the separation distance for electric field calculation by using the electrode diameter instead of the plate separation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You calculated , dividing by the electrode diameter () instead of the vertical plate separation distance ().
- Step 3Correct
Your formula is correct for a grounded bottom plate, but the numerical result was affected by your prior electric field value.
- Step 4Correct
Your force balance and your reasoning that must be negative are excellent, but the calculated charge magnitude was affected by the incorrect value of .
- Step 5Correct
Your potential energy formula is correct, but the result reflects your earlier values for and .
- Step 6Correct
You correctly divided the magnitude of the charge by the elementary charge , but the resulting electron count was inflated because of the propagated charge value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the volume and mass of the oil droplet in part (a).
You set up the vertical force balance with complete conceptual accuracy.
You correctly reasoned that because the electric field points downward, an upward force requires a negative charge.
You applied the correct definition for electric potential energy and correctly computed the number of elementary charges .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the plate diameter into instead of the distance between the two plates .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn parallel-plate capacitor geometry, the uniform electric field depends on the potential difference across the gap divided by the gap distance along the field lines (), whereas the plate dimensions (like diameter or area ) describe plate size rather than field gradient.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify the Direction of the Potential Gradient
For uniform fields between parallel plates, , where is the distance separating the plates along the direction of .
Always distinguish between plate dimensions (diameter, length, width, area) and the gap spacing () separating the opposing plates.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompute the electric field: .
Find the electric potential at : .
Solve for the net charge: .
Calculate the electric potential energy: .
Compute the number of elementary charges: excess electrons.
(a) ; (b) ; (c) , electrons
Lock it in
A uniform electric field points downward. What sign of charge experiences an upward electric force ?
Negative (). By , the force is opposite to the field only when the charge is negative.
Similar question
A dust particle of mass is suspended motionless between two horizontal parallel plates separated by . The top plate is at and the bottom plate is at . Find the magnitude and sign of the charge on the dust particle. (Use .)
Answer
- Field pointing downward.
- For equilibrium, must point upward, opposite to , so is negative.
- . Result: .
For the suspended dust particle in the previous question, determine its electric potential energy if it is located at a height of above the grounded bottom plate.
Answer
- Potential at height : .
- Potential energy: . Result: .
A charged sphere of mass is suspended in equilibrium between two horizontal plates. The bottom plate is at and the top plate is grounded (). Determine the sign of the charge on the sphere, and explain whether its electric potential energy is positive or negative relative to ground. (Take .)
Answer
- Since the bottom plate is at higher potential, points upward.
- Upward electric force is in the same direction as , requiring (positive charge).
- Any position between the plates has . Since and , (positive potential energy). Result: Charge is positive; electric potential energy is positive.