Resources
In a laboratory experiment on atomic hydrogen emission, a photon corresponding to a transition from to is directed normally onto a diffraction grating with . Calculate: (a) the transition energy of the emitted photon in (where the energy levels are given by ), (b) the emitted wavelength in , and (c) the first-order () diffraction angle in degrees.
Answer and steps
Final answer
(a) ; (b) ; (c) .
Steps
Part (a): Transition Energy of the Emitted Photon
The energy of an electron in the -th principal quantum level of a hydrogen atom is given by:
Calculate the energy of the initial state () and the final state ():
By conservation of energy, the energy of the emitted photon equals the difference between the two levels:
Part (b): Emitted Wavelength
The relationship between the energy of a photon and its wavelength is given by the Planck-Einstein relation:
Using the combined constant (or ):
(Note: This transition represents the line in the visible Balmer series of hydrogen).
Part (c): First-Order Diffraction Angle
A diffraction grating with has a slit spacing (grating spacing) equal to:
The condition for constructive interference for a diffraction grating at normal incidence is:
For the first-order maximum ():
Taking the inverse sine:
Typical errors
01 The student forgets to square the principal quantum numbers when calculating the energy difference, leading to an incorrect photon energy and carried-over errors in wavelength and angle.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You divided by rather than in the energy formula , leading to incorrect values for , , and the resulting transition energy .
- Step 2Correct
You correctly applied the Planck-Einstein relation with , but your result was affected by the incorrect value of from Step 1.
- Step 3Correct
You correctly converted the grating density into line spacing and applied the grating condition , but the angle was altered because came from the previous propagated error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly subtracted the lower energy level from the upper energy level to determine the photon energy.
You used the convenient conversion factor to find the wavelength from the photon energy.
You accurately calculated the grating spacing and correctly applied the diffraction grating equation for .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of dividing by , omitting the square on the principal quantum number.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating the -dependence of atomic orbital radii (which scale as ) or momentum/velocity (which scale as ) with the energy levels, which scale inversely with the square of the quantum number ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Bohr Energy Level Formula
For a hydrogen atom, the bound energy levels scale inversely with : .
Always explicitly write out (e.g., and ) in the denominator before carrying out the division.
- Rydberg Consistency Check
The transition wavelength satisfies .
Verify that the difference term involves squares of integers, such as .
CORRECTED PATH
ACEpath Teacher's Demonstration(a) ; (b) ; (c)
02 The student treats the line density N directly as the slit separation d instead of taking the reciprocal d = 1/N, resulting in an impossible grating equation value.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You treated the line density as the slit spacing . The slit spacing is the distance per line, which is the reciprocal of the line density: .
- Step 4Correct
Your diffraction formula setup was correct, but carrying forward the incorrect value of produced an angle near zero instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the energies of the and principal levels.
You correctly found the photon transition energy by taking the difference between the initial and final states.
You used the relation accurately to find the emitted wavelength.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou noted the unit for , but then substituted it into the grating equation as a distance in meters.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing grating line density (lines per unit length) with grating slit spacing (length per line). Since has units of length, it must be calculated using .
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit check on grating parameters
Slit separation has units of meters (length), whereas line density has units of or .
Whenever a problem provides grating lines per millimeter, immediately take the reciprocal: .
CORRECTED PATH
ACEpath Teacher's Demonstration(a) ; (b) ; (c)
03 The student misidentifies the transition as being from the ground state n=1 to n=5 rather than n=5 to n=2, yielding an incorrect transition energy and corresponding wavelength.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
and
You calculated the transition energy down to the ground state rather than the state given in the problem.
- Step 2Correct
You correctly applied the Planck-Einstein relation , but your numerical result was affected by the incorrect transition energy from Step 1.
- Step 3Correct
You correctly converted the grating density to slit spacing and applied the grating condition , but the angle carried forward the incorrect wavelength.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the energy of the initial state .
You applied the Planck-Einstein relationship accurately using .
You correctly determined the grating spacing from the line density and applied the diffraction grating equation .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou solved for a transition to the ground state rather than the specified final state .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn atomic physics problems, it is easy to assume by default that an electron falls all the way to the ground state () unless you explicitly highlight the given final quantum level (the Balmer series).
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Initial and Final Quantum Numbers
For an emission transition between two discrete levels, .
Underline or write down both and explicitly from the prompt before calculating the individual level energies.
- Sanity Check the Spectral Series
Transitions ending at belong to the Lyman series (ultraviolet, ); transitions ending at belong to the Balmer series (visible, ).
Check whether your resulting wavelength matches the expected spectral region for the given series.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompute the correct final energy level: .
Find the emitted photon energy: .
Recalculate the emitted wavelength: .
Apply the diffraction grating equation with the correct wavelength: .
(a) ; (b) ; (c)
Lock it in
What is the general expression for the energy of the -th level of a hydrogen atom in ?
. Notice that the principal quantum number in the denominator is squared (), not linear ().
Similar question
Calculate the energy in of the photon emitted during a transition from to in a hydrogen atom.
Answer
. Key steps: , , so .
A hydrogen atom emits light of wavelength in the transition. If this light shines normally onto a grating with , find the first-order diffraction angle .
Answer
. Key steps: ; ; .
In a singly ionized helium ion (, ), energy levels follow . Find the wavelength of the photon emitted in the transition from to .
Answer
. Key steps: , ; ; .