Resources
A high-precision dental radiography tube accelerates electrons through a potential difference of , producing continuous bremsstrahlung radiation whose Duane-Hunt cutoff wavelength represents the minimum possible wavelength . Given , elementary charge , and : (a) calculate converted explicitly into picometers () and Angstroms (), and (b) identify the electromagnetic spectral region corresponding to this radiation.
Answer and steps
Final answer
(a) ; (b) X-ray spectrum (hard X-rays)
Steps
Part (a): Calculating the Duane-Hunt Cutoff Wavelength
- Principle of Maximum Energy Transfer (Duane-Hunt Law): An electron accelerated through a voltage gains a maximum kinetic energy equal to: When an accelerated electron decelerates upon striking the target anode (bremsstrahlung process), it can lose up to its entire kinetic energy in a single collision to emit a single photon. The maximum possible photon energy corresponds to the minimum possible wavelength :
- Solving for : Rearranging the equation gives:
-
Substituting the Given Values:
Evaluating the numerator and denominator:
Dividing gives the wavelength in meters:
-
Converting Units:
- In picometers ():
- In Angstroms ():
Part (b): Identifying the Electromagnetic Spectral Region
- The wavelength of ( or ) lies well within the range of to , which defines the X-ray spectrum.
- Because this wavelength is significantly below (), these high-energy, deeply penetrating photons are categorized specifically as hard X-rays.
Typical errors
01 The student forgets to convert kilovolts to volts, substituting 75 instead of 75000 V into the Duane-Hunt formula.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted directly instead of converting into SI base units (). This made your calculated wavelength three orders of magnitude too large.
- Step 3Correct
Your conversion factors between meters, picometers (), and Angstroms () were applied correctly, but the values are off by a factor of due to the earlier voltage unit error.
- Step 4Correct
Because your calculated wavelength was (), you identified the region as ultraviolet. With the correct wavelength of (), the radiation lies firmly in the hard X-ray band.
WHAT YOU DID WELL
Compliments from Your TeacherYou stated the correct Duane-Hunt cutoff equation .
You used the correct metric prefix ratios to convert from meters to picometers and Angstroms.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used the numerical value directly instead of converting kilovolts to volts ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking metric prefixes attached to input quantities before inserting them into formulas requiring standard SI base units.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Input Units Against SI Base Units
Electrical potential must be expressed in volts (), where , for energy units to evaluate to Joules.
Always rewrite metric prefixes into powers of ten immediately when writing down given data.
- Reasonableness Check on X-ray Tube Wavelengths
Medical and dental diagnostic radiography tubes operating at tens of kilovolts produce penetrating X-rays with wavelengths on the order of picometers ( to ), never ultraviolet light.
If your computed cutoff wavelength for an X-ray tube falls in the ultraviolet or visible range, immediately inspect your accelerating voltage substitution for missing powers of ten.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert to picometers:
Convert to Angstroms:
Identify the spectrum: Wavelengths around () correspond to hard X-rays.
(a) ; (b) X-ray spectrum (hard X-rays)
02 The student inverts the metric unit conversion factors for picometers and Angstroms, multiplying by 10^-12 and 10^-10 instead of dividing by them.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Because , converting from meters to picometers requires dividing by (or multiplying by ). Multiplying by yields an unphysically small value.
- Step 3Correct
Because , converting from meters to Angstroms requires dividing by (or multiplying by ). Multiplying by inverts the conversion factor.
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recalled and applied the Duane-Hunt formula relating maximum electron kinetic energy to minimum photon wavelength.
You performed the numerical division accurately in base SI units.
You correctly classified the radiation into the X-ray band.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou knew that the metric prefix 'pico-' corresponds to and '\AA' corresponds to , but you multiplied by these scale factors instead of dividing by them.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the replacement of a prefix with dimensional unit conversion. While , converting an expression in meters to picometers requires setting up the dimensional ratio , which introduces a factor of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Unit Cancellation
To convert from unit to unit , multiply by a conversion fraction whose denominator has unit : .
Always write out unit labels explicitly in your fraction so meters cancel: .
- Magnitude Sanity Check
A smaller unit of measurement must always produce a larger numerical value for the same physical quantity.
Because a picometer is much smaller than a meter, the numerical coefficient for picometers must be much larger than , not smaller.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the conversion to picometers using dimensional analysis: .
Set up the conversion to Angstroms using dimensional analysis: .
(a) ; (b) X-ray spectrum (hard X-rays)
03 The student misremembers the photon energy-wavelength relation as E = hcλ rather than E = hc / λ.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Photon energy relates to frequency by and to wavelength by , which gives . Because photon energy is inversely proportional to wavelength, the maximum kinetic energy equals , not .
- Step 2Correct
Your arithmetic follows your inverted formula correctly, but substituting into the inverted expression yields the reciprocal of the intended value.
- Step 3Correct
You correctly applied the conversion factors and to your calculated value, but the result carries over the initial formula error.
- Step 4Correct
Classifying the radiation as radio waves logically matched your calculated wavelength of , but the correct cutoff wavelength of falls firmly in the hard X-ray band.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that the maximum photon energy comes from the accelerating potential energy .
You converted the tube voltage from to accurately.
You applied the metric prefix conversions for picometers and Angstroms correctly.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou recalled the photon energy relation as instead of , confusing direct and inverse proportionality between energy and wavelength.
REASONING PATH
Your ACEpath teacher’s suggested approach- Photon Energy Proportionality
Check dimensional consistency before rearranging: as frequency increases, energy increases; as wavelength increases, energy must decrease.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet the maximum photon energy equal to the kinetic energy gained across potential : .
Solve for the minimum wavelength: .
Substitute the given values: .
Convert to picometers () and Angstroms (): .
Identify the spectral regime: a wavelength of () corresponds to hard X-rays.
(a) ; (b) X-ray spectrum (hard X-rays)
Lock it in
What is the SI base unit of electric potential difference, and how do you convert into base units?
The SI base unit is the volt (). Convert using .
Similar question
A mammography X-ray tube operates at an accelerating potential of . Calculate its Duane-Hunt cutoff wavelength in picometers (). Use , , and .
Answer
. Key steps: Convert voltage to . Apply .
An electron microscope uses an electron gun accelerated through . If an electron loses its entire kinetic energy in a single bremsstrahlung impact with an aperture, calculate the resulting cutoff photon wavelength in Angstroms () and state whether this radiation is considered soft or hard X-rays.
Answer
; hard X-rays. Key steps: Convert . Compute . Wavelengths below () belong to the hard X-ray band.
A research linear accelerator produces bremsstrahlung photons with a minimum cutoff wavelength of . Determine the potential difference across the accelerator in megavolts () and classify the corresponding electromagnetic spectral region.
Answer
; gamma ray / high-energy X-ray region. Key steps: Rearrange for . Wavelengths near correspond to ultra-energetic gamma rays or high-energy bremsstrahlung.