Resources
In a physics laboratory experiment, a student measures the position of a cart attached to a horizontal spring using an ultrasonic motion detector sampling at . The recorded position-time data is fitted to the model . The fitted parameters yield an initial amplitude , a damping coefficient parameter , and a damped angular frequency . (a) Calculate the spring constant of the spring, accounting for the damping correction . (b) Determine the mechanical energy lost by the system, , between and .
Answer and steps
Final answer
(a) ; (b)
Steps
Part (a): Determine the Spring Constant
- Relate the frequencies:
In a weakly damped harmonic oscillator described by the position function , the damped angular frequency is related to the undamped natural angular frequency and the damping parameter by: - Compute :
Substitute the given values and : - Calculate the spring constant :
The natural frequency of a mass-spring system is defined by , which gives: Substitute :
Part (b): Determine the Mechanical Energy Lost
- Energy of a damped oscillator:
The amplitude of oscillation at any time decays exponentially according to: The total mechanical energy stored in the oscillator is proportional to the square of its amplitude: - Calculate initial energy :
At : - Calculate remaining energy at :
Using the damping factor over : - Calculate energy loss :
The mechanical energy dissipated by damping between and is:
Typical errors
01 The student ignores the factor of 2 in the exponent when calculating energy decay, scaling energy by e^(-γt) instead of e^(-2γt).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Mechanical energy depends on the square of the amplitude, . Because amplitude decays as , energy decays as .
- Step 4Correct
Your subtraction method was correct, but your final answer was affected by the incorrect value of from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the undamped angular frequency and the spring constant .
You correctly evaluated the initial mechanical energy using the given amplitude.
You correctly set up the energy loss as the difference between the initial and remaining mechanical energy.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou scaled the energy directly by the amplitude decay factor rather than squaring the amplitude factor to get .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the linear exponential decay rate of amplitude, , with the quadratic exponential decay rate of mechanical energy, .
REASONING PATH
Your ACEpath teacher’s suggested approach- Amplitude vs. Energy Decay Rates
For a damped harmonic oscillator with amplitude , mechanical energy is proportional to amplitude squared: .
Always multiply the damping exponent by 2 whenever you evaluate quantities proportional to amplitude squared (such as kinetic, potential, or total mechanical energy).
CORRECTED PATH
ACEpath Teacher's DemonstrationExpress the remaining energy at with the correct exponent: .
Compute the mechanical energy loss: .
(a) ; (b)
02 The student forgets to square the amplitude when evaluating the initial mechanical energy formula E = (1/2)kA.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You forgot to square the amplitude in the mechanical energy formula. Elastic potential energy and total mechanical energy in harmonic motion scale with the square of displacement: .
- Step 3Correct
Your exponential decay factor is completely correct, but the calculated value of inherits the error from .
- Step 4Correct
Your subtraction method is correct, but downstream from the un-squared amplitude error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the undamped frequency and the spring constant .
You correctly identified that the mechanical energy decays with an exponential factor of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the linear restoring force with the quadratic potential energy leads to forgetting the square on the amplitude.
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Consistency Check
Force has units of , while energy has units of .
Always verify that multiplying by length yields energy only after squaring the length: .
CORRECTED PATH
ACEpath Teacher's Demonstration,
03 The student subtracts the damping term instead of adding it in the correction formula, calculating ω₀ = √(ω'² - γ²).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You subtracted under the square root instead of adding it. Rearranging the standard damped frequency relation gives .
- Step 2Correct
You applied the formula correctly, though the value carried forward the minor subtraction error from Step 1.
- Step 3
- Step 4
- Step 5
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly related the undamped natural frequency and mass to find the spring constant via .
You used the exponential damping envelope correctly to find the amplitude at .
You set up the energy conservation relation correctly by taking the difference between initial and final mechanical energy.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote a minus sign inside instead of adding the damping term as .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou likely recalled the formula for damped frequency in terms of natural frequency, , and mistakenly applied the subtraction to solve for instead of isolating .
REASONING PATH
Your ACEpath teacher’s suggested approach- Natural frequency vs. damped frequency
Damping always slows down oscillations, so the natural frequency must exceed the damped frequency: .
When solving for the undamped frequency , always add to : .
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate .
Find .
Evaluate energy dissipation: .
(a) ; (b)
Lock it in
If the amplitude of a damped harmonic oscillator decays as , how does its total mechanical energy decay with time?
. Because mechanical energy is proportional to the square of amplitude (), squaring doubles the decay constant in the exponent.
Similar question
A damped oscillator with initial energy and damping parameter oscillates for . Calculate the mechanical energy remaining in the system at .
Answer
.
A mass on a spring () starts with an amplitude of . Due to weak damping with , its amplitude decreases. Find the total energy lost by the system between and .
Answer
- Initial energy: .\n2. Energy at : .\n3. Energy lost: .
For a damped harmonic oscillator, show that the time required for the mechanical energy to drop to half its initial value is exactly half the time required for the amplitude to drop to half its initial value.
Answer
- For amplitude: .\n2. For energy: .\n3. Comparing the two expressions gives .