Resources
A very large, open cylindrical storage reservoir with a diameter of is filled with water to a depth of . A small drain orifice of diameter is uncapped at the base of the tank. Using the continuity equation and Bernoulli's equation, derive the exact ratio in terms of diameters, and evaluate the exit speed under both the exact finite-area formulation and the asymptotic reservoir limit (, where surface velocity , taking ).
Answer and steps
Final answer
; exact , asymptotic Torricelli limit (fractional difference )
Steps
Continuity Equation and Velocity Ratio
For an incompressible fluid like water, the volume flow rate must be conserved between the top surface of the reservoir (cross-sectional area ) and the exit orifice at the base (cross-sectional area ):
Both the reservoir and the orifice are circular in cross section with diameters and , respectively:
Substituting these areas into the continuity equation:
Solving for the ratio of the surface speed to the orifice exit speed:
Using the given dimensions, and :
Bernoulli's Equation for the Exact Exit Velocity
Apply Bernoulli's equation along a streamline from point 1 at the upper free surface to point 2 just outside the discharge orifice.
- Both points are open to the atmosphere, so .
- Choosing the elevation of the drain orifice as the reference level (), the surface elevation is .
Bernoulli's principle states:
Subtracting and dividing by density :
From the continuity relation, substitute :
Solving for the exact exit speed:
Asymptotic Reservoir Limit (Torricelli's Law)
When the reservoir is very large compared to the drain hole (), the ratio , which implies . The denominator approaches , yielding the classic Torricelli speed:
Evaluating numerically with and :
Comparison of Exact and Asymptotic Results
Evaluating the correction factor :
Since this factor is negligible compared to :
The fractional difference between the exact formulation and Torricelli's approximation is approximately , confirming that Torricelli's law is an exceptionally accurate approximation for large reservoirs.
Typical errors
01 The student linearly scales the area with diameter instead of diameter squared, setting the area ratio and velocity ratio to d/D rather than (d/D)².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The area of a circle scales with the square of its diameter (), so the area ratio must be , not .
- Step 2Correct
Your application of Bernoulli's equation is algebraically correct, but because , squaring introduces a fourth-power term in the denominator rather than .
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly stated the continuity equation .
You applied Bernoulli's equation across the two open atmospheric boundaries with the correct reference height.
You correctly identified and evaluated the asymptotic Torricelli speed .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of squaring the diameter ratio.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated cross-sectional area as proportional to the first power of diameter rather than the square of diameter (), confusing linear scale factors with area scale factors.
REASONING PATH
Your ACEpath teacher’s suggested approach- Area Scaling for 2D Geometries
For any circle of diameter , the cross-sectional area is , so the ratio of two circular areas is .
Always write out the explicit area formula before canceling constants, ensuring the exponent is retained on the linear dimensions.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute into Bernoulli's equation:
Solve for the exact velocity:
; exact , asymptotic limit
02 The student forgets to convert the orifice diameter from centimeters to meters, resulting in an unphysical ratio d/D = 0.25 and an excessively large correction in the exact formula.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You substituted the orifice diameter directly alongside without converting centimeters into meters, overestimating the diameter ratio by a factor of .
- Step 4Correct
Your algebraic evaluation followed correctly from your previous value of , but the resulting velocity is inaccurate due to the earlier unit conversion error.
- Step 5
WHAT YOU DID WELL
Compliments from Your TeacherYou stated and applied the continuity equation accurately to express the velocity ratio as the square of the diameter ratio.
You set up Bernoulli's equation across the two open surfaces and algebraically solved for the exact exit speed.
You correctly implemented Torricelli's approximation for a large reservoir.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided by directly without converting the orifice diameter from centimeters into meters.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking mismatched metric prefixes ( vs. ) when computing a dimensionless geometric ratio.
REASONING PATH
Your ACEpath teacher’s suggested approach- Homogeneous Units in Dimensionless Ratios
Before computing any ratio of lengths , convert both quantities to the same base unit (e.g., meters).
Always write explicit units inside your fractions: .
- Physical Reality Check for Reservoir Approximations
A hole in an wide reservoir is tiny; its diameter ratio must be much smaller than .
Notice that means the hole is one-quarter of the tank's width (), which contradicts the description of a small drain hole.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert to meters: .
Calculate the true diameter ratio: .
Evaluate the velocity ratio: .
Compute the exact exit speed: .
, exact , asymptotic Torricelli
03 The student adds rather than subtracts the kinetic energy terms when rearranging Bernoulli's equation, leading to a plus sign in the denominator of the exact speed expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
gh = v_{}^2 - v_{}^2 = v_{}^2 v_{} =
When transposing across the equals sign, you must subtract it from the orifice term: . Factoring out leaves , not .
- Step 4
= = 0.0025 ^4 = 3.91 10^{-11} v_{} = = 9.39_
Correctv_{} = 9.39_
Because is so extremely small, the numerical answer rounds to the correct three significant figures (), but your expression inherits the sign error from Step 3.
- Step 5
v_{} 0 (v_{})^2 = gh v_{} = = = 9.39_
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly derived the continuity area ratio .
You correctly formulated Bernoulli's equation between the liquid surface and the exit orifice.
You evaluated the asymptotic Torricelli exit velocity accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally placed a plus sign instead of a minus sign in the factor when isolating .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisWhen grouping the two kinetic energy terms on the same side of the equation, moving to the side with requires a subtraction, reflecting that the change in kinetic energy equals the loss of potential energy.
REASONING PATH
Your ACEpath teacher’s suggested approach- Energy Conservation Sanity Check
As water descends, potential energy converts into kinetic energy, so the final velocity must be slightly greater than or equal to the stationary-surface approximation: .
Check whether your correction factor increases the exit speed compared to . A denominator with produces a value , which increases the speed, whereas erroneously decreases it.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubtract from both sides:
Divide by and substitute :
Solve for :
Lock it in
How does the cross-sectional area ratio of two circular pipes relate to their diameters and ?
. Area scales with the square of linear dimensions, not linearly.
Similar question
A garden hose with an internal diameter of is fitted with a nozzle of diameter . If water flows through the main hose at , what is the exit speed of the water leaving the nozzle?
Answer
. Using continuity .
A cylindrical syringe barrel has diameter and the attached needle has internal diameter . If the plunger moves forward at , determine the velocity of the liquid emerging from the needle.
Answer
. Convert units to match: and . The ratio . By continuity, .
A cylindrical tank of diameter drains through an orifice of diameter at its base. Using Bernoulli's equation and continuity, derive the exact algebraic expression for the exit speed in terms of water depth , , , and , and evaluate the percentage correction compared to Torricelli's speed .
Answer
Exact formula: . Here . The correction factor is , which is an increase of approximately over .