Resources
An open observation well extends downward beneath the ground. Defining the top of the well as the origin () with the positive vertical axis directed upward ( upward), a stone is thrown vertically upward from the well opening with an initial velocity of . The acceleration due to gravity is . The stone travels upward, momentarily halts at its peak, and falls back down, passing the origin and plunging into the well until it strikes the bottom at vertical coordinate . Determine the stone's signed displacement , the total elapsed time of flight , and the signed final velocity immediately before impact.
Answer and steps
Final answer
; ;
Steps
Identify Given Parameters and Coordinate System
The problem sets the origin at the mouth of the well with the positive -axis directed upward:
- Initial position:
- Final position at the well bottom:
- Initial velocity:
- Acceleration:
Determine the Signed Vertical Displacement ()
Displacement is a vector defined solely by the difference between the final and initial positions, independent of the path taken:
The negative sign indicates that the stone's final position is located below its starting point.
Calculate the Total Elapsed Time of Flight ()
Using the kinematic position-time equation:
Substitute the known values:
Rearrange into standard quadratic form:
Divide the entire equation by :
Factor the quadratic expression:
This yields two solutions: and . Since time must be positive for motion occurring after the launch ():
Determine the Signed Final Velocity ()
Using the velocity-time relationship:
Substitute the values:
Pitfall to avoid: Using gives , but you must choose the negative sign because the stone is moving downward into the well upon impact.
Typical errors
01 The student treats displacement as a distance scalar and sets Δy = +49.0 m, which miscalculates the elapsed time of flight and the final velocity.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
With the upward vertical direction chosen as positive (), positions below the ground level () are negative. Because the stone ends below its launch point, its vertical displacement is .
- Step 2Correct
Your algebraic setup and rearrangement were executed correctly, but substituting the positive displacement led to a negative discriminant (). With the correct displacement , the quadratic factors smoothly into , giving the physical solution .
- Step 3Correct
(or )
Because was substituted with a positive sign while acceleration was negative, the term was subtracted rather than added, yielding a negative value for . With , the terms multiply to a positive quantity: , giving .
WHAT YOU DID WELL
Compliments from Your TeacherYou selected the appropriate kinematic relationships for both position-time and velocity-displacement.
You correctly assigned signs to initial velocity () and gravitational acceleration ().
You correctly recognized that a negative discriminant means no real solution exists for your written equation.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used the scalar distance of instead of checking the sign of the displacement vector .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing scalar distance traveled or depth with signed vertical displacement along a defined coordinate axis.
REASONING PATH
Your ACEpath teacher’s suggested approach- Establish Axis and Vector Signs First
Displacement is . Any position below the chosen origin along a -upward axis must be negative.
Always mark and explicitly on a vertical axis diagram before writing down kinematic formulas.
- Heuristic Check on Quadratic Discriminant
In free-fall kinematics, a projectile with sufficient initial energy will always reach every coordinate lower than its launch height.
If your kinematic equation yields no real solutions for an object falling past its launch level, immediately check the sign of .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet the coordinate positions: and , so .
Substitute into the position formula: .
Divide by : , giving since .
Substitute into : .
; ;
02 The student calculates the final speed from v_f² = v_0² + 2aΔy but takes the positive square root, neglecting the downward direction indicated by the negative sign.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
Solving yields . Because the stone is plunging downward at impact and upward is designated as , you must choose the negative sign.
WHAT YOU DID WELL
Compliments from Your TeacherYou accurately determined the signed displacement using the given coordinate system.
You correctly set up, factored, and solved the quadratic kinematic equation to find the flight time.
You correctly calculated the magnitude squared of the final velocity using .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou took the principal (positive) square root and reported speed rather than the signed velocity vector component.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisThe algebraic equation yields only the squared magnitude, losing directional information. Taking the square root always requires choosing based on the physical direction of motion relative to your chosen coordinate axis.
REASONING PATH
Your ACEpath teacher’s suggested approach- Square Root Sign Selection
When solving , select for motion along the positive axis and for motion along the negative axis.
Always check the object's physical direction of travel at that instant before writing the final sign.
- Alternative Linear Velocity Check
naturally preserves vector signs without needing a square root.
Use as a cross-check to verify the sign directly: .
CORRECTED PATH
ACEpath Teacher's DemonstrationTake the square root with explicit consideration of sign: .
Since points upward and the stone is plunging downward into the well bottom, choose the negative root: .
, ,
03 The student assumes acceleration is directed along the initial upward motion and uses a = +9.80 m/s², leading to an incorrect quadratic equation for time.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
With the upward direction defined as positive (), gravity accelerates the stone downward, so you must use . Substituting rather than produced an incorrect quadratic equation with a negative discriminant.
- Step 3Correct
Because the time of flight was blocked by the sign error in the quadratic equation, you were unable to evaluate the final velocity.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly established the signed vertical displacement as .
You selected the appropriate kinematic formulas relating displacement, time, and velocity.
You correctly analyzed the discriminant of your resulting quadratic equation.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set , treating acceleration due to gravity as positive rather than negative in an upward-positive coordinate system.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that the acceleration due to gravity points downward regardless of whether an object moves upward or downward. Once is designated as upward, acceleration must remain throughout the entire flight.
REASONING PATH
Your ACEpath teacher’s suggested approach- Coordinate System Sign Consistency
In any coordinate frame where upward is defined as positive, free-fall acceleration is always downward: .
Write out , , , and with their explicit plus/minus signs before substituting them into any kinematic formula.
- Quadratic Feasibility Check
A real physical event (such as a stone hitting the ground) must yield at least one positive real root for time.
If your time equation yields a negative discriminant or only negative roots, immediately check whether the signs of , , and agree with your chosen coordinate axes.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute into : .
Rearrange to standard quadratic form: .
Divide by : , which factors as .
Select the positive physical root: .
Substitute into : .
; ;
Lock it in
How is 1D vertical displacement formally defined relative to an upward-pointing coordinate axis?
. If the object ends below its starting level, regardless of the path taken.
Similar question
A coin is tossed vertically upward from the edge of a balcony with an initial speed of . It falls past the balcony and hits the sidewalk below. Taking upward and , find the total time of flight.
Answer
. Key steps: Set , , . The equation rearranges to . Using the quadratic formula, .
A projectile is launched vertically upward from the roof of a tall building at . With upward and , calculate its final velocity immediately before striking the street level at the base of the building.
Answer
. Key steps: Set . Using : . Because the projectile is moving downward upon landing, choose the negative root: .
A ball is launched vertically upward from ground level () with speed . A sensor is placed at and another in a pit at . Explain why the equation requires to reach the upper sensor, but requires no minimum nonzero launch speed to eventually pass the pit sensor after falling back down.
Answer
To reach the upper sensor, the displacement is , requiring . To reach the lower pit sensor, displacement is , so . This term is strictly positive for any launch speed , guaranteeing the falling ball will cross into the pit with real speed.