Resources
A narrow beam of monochromatic light propagating in air () strikes the flat, horizontal surface of a crown glass block () at an angle of incidence of measured with respect to the normal. Calculate the angle of refraction inside the glass.
Answer and steps
Final answer
Steps
Identify the Relevant Physical Law
When a light ray travels from one transparent medium into another, its change in speed causes it to bend at the boundary. The relationship between the angles of incidence and refraction and the refractive indices of the media is given by Snell's Law:
where:
- is the refractive index of air,
- is the angle of incidence measured from the normal,
- is the refractive index of crown glass,
- is the angle of refraction inside the glass.
Rearrange the Formula for the Unknown Angle
Isolate :
Substitute the Given Values and Calculate
- Compute the sine of the incident angle:
- Substitute this value into the equation:
- Take the inverse sine () to find :
Physical Consistency Check
- Pitfall to avoid: Always ensure angles are measured relative to the normal (the line perpendicular to the surface), not the surface itself.
- Direction of bending: Because light enters an optically denser medium (), the ray bends toward the normal line, resulting in an angle of refraction smaller than the angle of incidence (). Since , this result is physically consistent.
Typical errors
01 The student inverts the ratio of refractive indices in Snell's law, effectively multiplying by n₂ instead of dividing by it.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
When dividing both sides of by to isolate , the ratio should be , not .
- Step 3Correct
Your numerical evaluation was executed correctly according to your rearranged formula, but the result was affected by the inverted index ratio.
- Step 4Correct
You correctly took the inverse sine of your calculated value, but the final angle is incorrect due to the earlier inversion.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and wrote down Snell's Law as the governing equation.
You accurately looked up or matched the given indices and angle of incidence.
You performed the trigonometric and inverse trigonometric calculations accurately based on your algebraic setup.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally flipped the fraction to instead of dividing both sides by .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the algebraic isolation of variables in a product equation , leading to multiplying by the coefficient of the target variable rather than dividing by it.
REASONING PATH
Your ACEpath teacher’s suggested approach- Isolate the Unknown Variable
To isolate in , divide both sides by : .
Always write out the division step explicitly: divide both sides by so that .
- Qualitative Physical Sanity Check
When light travels from an optically less dense medium into a denser medium (), it must bend toward the normal, meaning .
Compare your calculated angle () with the incident angle (); since the ray entered a denser medium, the angle should have decreased, not increased.
CORRECTED PATH
ACEpath Teacher's DemonstrationDivide both sides of by : .
Substitute the given values: .
Take the inverse sine: .
02 The student evaluates the trigonometric functions with a calculator set in radians mode instead of degrees mode.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Your calculator evaluated in radians rather than degrees. In degree mode, .
- Step 3Correct
You carried out the division correctly using your value from the previous line, but the result is affected by the radian-mode error.
- Step 4Correct
Your inverse sine operation was also evaluated in radians ($ \arcsin(0.1950) 0.196\text{ rad}$$), which you then labeled as degrees. Evaluating \arcsin(0.4050)23.9^$.$$
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified Snell's Law as the governing equation for refraction.
You accurately substituted the known refractive indices and the angle of incidence.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou entered the angle into a calculator configured in radians mode.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisUnchecked calculator mode setting. Because trigonometric functions take different numerical inputs depending on whether the mode is set to DEG (degrees) or RAD (radians), evaluating in radians mode computes instead of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Check calculator angle mode
Whenever an angle is given in degrees (), the calculator display indicator must show DEG, not RAD or GRAD.
Switch your calculator mode to DEG before evaluating sine or inverse sine functions for degree-based problems.
- Perform a physical plausibility check
When light passes into a medium with a higher index of refraction (), it bends toward the normal, so , but the angle will remain on a comparable scale unless .
Notice that an angle of would mean the ray barely deviated from normal incidence, which is unrealistic for and .
CORRECTED PATH
ACEpath Teacher's DemonstrationEvaluate the sine of the angle in degree mode: .
Isolate : .
Take the inverse sine in degree mode: .
03 The student directly equates the ratio of angles to the ratio of refractive indices without taking the sine of the angles.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You omitted the trigonometric sine function from Snell's Law. Refraction depends on the ratio of wave phase velocities, which relates through the sines of the angles, , rather than the angles themselves directly.
- Step 2Correct
Your algebraic isolation and division were carried out accurately, but the resulting numerical value is incorrect due to the missing sine functions from the first step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the given values , , and .
You accurately solved for the unknown variable algebraically and completed the arithmetic division without calculation mistakes.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou used the simplified linear approximation (which is only roughly valid for near-normal incidence, ) as if it were the exact governing law of refraction, forgetting the sine function in Snell's Law.
REASONING PATH
Your ACEpath teacher’s suggested approach- State the Law of Refraction
Snell's Law relates refractive indices to the sines of the angles to the normal: .
Always write down the full sine terms before substituting numerical values.
- Calculate Sine and Inverse Sine
Isolate first, calculate its decimal value, and then take on your calculator in degree mode.
Compute , divide by to get , and find .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite Snell's Law with sines: .
Substitute the given numbers: .
Solve for the sine of the angle of refraction: .
Take the inverse sine: .
Lock it in
In Snell's Law , what is the correct algebraic expression for ?
. Always divide both sides by the coefficient of the unknown ().
Similar question
A light ray in air () strikes water () at an angle of incidence of . Calculate the angle of refraction inside the water.
Answer
. Using Snell's law: . Then .
A ray of light traveling inside a diamond () reaches a flat interface with air () at an incident angle of . Calculate the angle of refraction in air.
Answer
. Using Snell's law: . Then .
A laser beam passes from oil () into an unknown transparent liquid at an angle of incidence . The measured angle of refraction is . Determine the refractive index of the liquid .
Answer
. Rearranging Snell's law for gives .