Resources
A single-loop electrical circuit contains a DC voltage source of EMF with negligible internal resistance, connected in series with three resistors: , , and . Traversed in the clockwise direction along the assumed current , the path enters the negative terminal and leaves the positive terminal of the source. Identify the fundamental circuit conservation law governing the potential differences around this closed loop, write the algebraic loop equation adhering strictly to the passive sign convention, and solve for the loop current .
Answer and steps
Final answer
Kirchhoff's Voltage Law (KVL / Conservation of Energy); ; .
Steps
Applicable Physical Law
The fundamental rule governing potential differences around a closed loop is Kirchhoff's Voltage Law (KVL), which is a direct consequence of the conservation of energy. In an electrostatic field, the electric potential is single-valued; therefore, the net work done moving a unit charge around any complete closed path must equal zero:
Formulating the Loop Equation
Traverse the single loop in the clockwise direction, aligned with the assumed current :
- DC Voltage Source (): The path moves from the negative () terminal to the positive () terminal. Moving to a higher potential represents a potential gain (or rise):
- Resistors (): Under the passive sign convention, traversing a resistor in the direction of current flow moves from the higher potential () to the lower potential (), resulting in a potential drop across each resistor:
Summing these potential changes according to KVL yields the loop equation:
Common Pitfall: Inverting the sign of resistor drops is a frequent error. When moving in the direction of current flow through an ohmic resistor, potential always decreases. If traversing against the current direction, the term would instead be .
Solving for the Loop Current
Rearrange the equation to isolate :
Substitute the given values:
The loop current is .
Typical errors
01 The student misapplies the sign convention by adding resistor potential differences instead of subtracting potential drops in the direction of current flow.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Kirchhoff's Voltage Law
- Step 2Correct
When traversing a resistor in the direction of electric current, electric potential decreases. Under the passive sign convention, each resistor contributes a negative potential difference (), not a positive one.
- Step 3Correct
Your numerical substitution and factoring were algebraically correct, but the expression inherited the incorrect positive signs from your loop equation.
- Step 4Correct
You solved your linear equation correctly, but because of the sign error in the loop equation, your final current has the opposite sign.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly named Kirchhoff's Voltage Law as the governing principle.
You correctly combined the series resistors algebraically.
You accurately solved your linear equation for the loop current.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated all loop terms as additive gains rather than applying the passive sign convention, where moving in the direction of current through a resistor results in a potential drop ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Traversing Resistors Along Current
Moving through a resistor in the direction of current always goes from high potential to low potential , giving .
Always assign a negative sign () to potential differences across resistors when your loop path follows the current.
- Traversing DC Voltage Sources
Moving through a source from the negative terminal to the positive terminal represents a potential rise ().
Check your traversal direction relative to source terminals: entering and leaving is ; entering and leaving is .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply Kirchhoff's Voltage Law with potential drops for each resistor: .
Factor out the current: .
Solve for the current: .
Kirchhoff's Voltage Law; ;
02 The student confuses series and parallel combinations, incorrectly computing the equivalent resistance using reciprocal addition.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- I R_1 - I R_2 - I R_3 = 0
- Step 2
= + + = R_{} = , 1.85,_
CorrectR_{} = R_1 + R_2 + R_3 = 4.00, + 6.00, + 8.00, = 18.0,_
In a single continuous loop, the components are connected in series, meaning their resistances add directly. The reciprocal addition formula applies only to parallel branches sharing common nodes.
- Step 3
I = = 9.75
CorrectI = = = 1.00
Your calculation for current substituted your incorrect equivalent resistance into Ohm's law, propagating the error from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified Kirchhoff's Voltage Law as the governing physical principle.
You correctly applied the passive sign convention to formulate the clockwise loop equation.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused series and parallel resistor combinations by applying the reciprocal equivalent resistance formula to elements sharing a single, unbranched series loop.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Component Topology
Components connected end-to-end along a single path without junctions carry identical current and are in series: .
Trace the current path: if no junction splits the current, simply sum all resistances directly.
- Direct Isolation from the Loop Equation
Factoring current from KVL gives .
Isolate algebraically directly from your loop equation rather than computing an intermediate equivalent resistance.
CORRECTED PATH
ACEpath Teacher's DemonstrationSolve the loop equation directly for current:
Substitute the given resistance values:
Compute the loop current:
Kirchhoff's Voltage Law; ;
03 The student confuses Kirchhoff's Voltage Law with Kirchhoff's Current Law, identifying junction charge conservation instead of closed-loop energy conservation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Kirchhoff's Current Law (conservation of charge)
CorrectKirchhoff's Voltage Law (KVL / Conservation of Energy)
Kirchhoff's Current Law (KCL) governs the sum of currents entering and leaving a node and represents conservation of charge. In contrast, the sum of potential differences around any closed loop is governed by Kirchhoff's Voltage Law (KVL), which represents conservation of energy.
- Step 2
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly formulated the closed-loop potential equation using proper sign conventions.
You accurately calculated the equivalent series resistance and the final loop current.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the conservation law for closed potential loops (energy conservation, KVL) with the conservation law for junction currents (charge conservation, KCL).
REASONING PATH
Your ACEpath teacher’s suggested approach- Loop Potential vs. Node Current
A closed loop deals with electric potential differences (work per unit charge), so reflects conservation of energy (KVL). A node/junction deals with charge flow rate, so reflects conservation of charge (KCL).
Whenever you analyze voltages around a loop, write down Kirchhoff's Voltage Law (KVL / Energy Conservation). Reserve Kirchhoff's Current Law (KCL / Charge Conservation) for junctions.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify that potential difference is work done per unit charge, meaning any closed loop must have a net potential change of zero: .
Name this relationship Kirchhoff's Voltage Law (KVL), which directly embodies the conservation of energy in an electrostatic field.
Keep your correct loop equation and your solution .
Kirchhoff's Voltage Law (KVL / Conservation of Energy); ;
Lock it in
According to the passive sign convention, what is the potential change when traversing a resistor in the direction of current ?
. Current flows from high potential to low potential, so moving with the current is a potential drop.
Similar question
A single-loop circuit has a battery of EMF and two resistors, and . Traversed clockwise in the direction of the assumed current , the path moves from the negative to the positive terminal of the source. Write the algebraic KVL loop equation and calculate .
Answer
KVL equation: . Substituting values: .
A single-loop circuit contains two opposing DC sources, and , connected in series with a resistor . Traversed clockwise, the path goes from the negative to positive terminal of , through in the direction of clockwise current , and from the positive to negative terminal of . Write the loop equation and solve for .
Answer
KVL equation: . Substituting values: .
A loop contains an EMF source (traversed ) and three identical resistors of resistance . An ammeter measures a clockwise loop current of flowing through all three resistors in series. Write the KVL loop equation in terms of , , and , then find the resistance value .
Answer
KVL equation: . Rearranging gives .