Resources
A student investigating the work-energy theorem stretches a horizontal spring () from its relaxed state () to an elongation of , and then further stretches the spring from to . (a) Calculate the elastic potential energy at and at . (b) Determine the additional external work required to double the elongation from to , and state the ratio of to the work done during the first stretch .
Answer and steps
Final answer
(a) , ; (b) , with ratio
Steps
Part (a): Calculating Elastic Potential Energy
The elastic potential energy stored in an ideal spring stretched by a displacement from its equilibrium position is given by:
where:
- is the spring constant,
- is the elongation from equilibrium.
- At elongation :
- At elongation :
Part (b): Work Done and Comparison of Intervals
By the work-energy theorem, the external work done to slowly stretch a spring is equal to the change in the spring's elastic potential energy:
- Work during the first stretch ():
- Additional work to stretch from to :
- Ratio of the work values:
Common Pitfall: A common mistake is to assume that doubling the total stretch requires double the work. Because the restoring force increases linearly with displacement (), the spring pulls back harder during the second interval ( to ) than during the first ( to ). Consequently, the second stretch of equal distance requires three times as much work as the first stretch, resulting in four times the total stored energy.
Typical errors
01 The student forgets to square the displacement in the elastic potential energy formula, treating potential energy as proportional to elongation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You wrote the elastic potential energy formula as rather than . Because displacement must be squared, should be and should be .
- Step 2Correct
Your work-energy setup was conceptually correct, but substituting your earlier linear energy values led to instead of .
- Step 3Correct
Your division method was correct, but carrying forward the incorrect work values yielded a ratio of instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied the work-energy relationship equating external work to the change in elastic potential energy.
You set up the ratio of external work quantities accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated elastic potential energy as directly proportional to elongation () rather than quadratic in elongation (), confusing the formula for potential energy with Hooke's law force () integrated over distance.
REASONING PATH
Your ACEpath teacher’s suggested approach- Formula check for spring potential energy
Elastic potential energy is quadratic in displacement: .
Always verify units and powers: energy has units of , so multiplying (in ) by (in ) gives joules.
- Variable force implies non-linear work intervals
Because spring force increases linearly with stretch (), stretching through equal successive intervals requires increasing amounts of work.
Check your answer intuitively: the second stretch must require more work than the first because the spring resists with greater force.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate
Calculate
Compute the work done during the second stretch:
Find the work done during the first stretch:
Calculate the ratio:
(a) , ; (b) , ratio
02 The student calculates the work done over the second interval by evaluating (1/2)k(Δx)² instead of finding the difference between final and initial potential energies.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
,
- Step 2Correct
Work equals the change in stored potential energy, . Because the potential energy depends on , . Stretching the spring when it is already under tension requires overcoming a larger restoring force than stretching it from equilibrium.
- Step 3Correct
Your ratio calculation followed logically from your value in Step 2, but it was affected by the incorrect work for the second stretch.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the stored elastic potential energy at both and using .
You correctly recognized that the work during the first interval from equilibrium is equal to .
You set up the ratio of the two work quantities correctly.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the work required to stretch a spring over an interval as , forgetting that spring force varies linearly with displacement from equilibrium. Work is the area of a trapezoid under the curve, , not the area of a triangle starting from zero.
REASONING PATH
Your ACEpath teacher’s suggested approach- Work-Energy Relation for Springs
Always evaluate final potential energy minus initial potential energy rather than placing inside the squared term.
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the work-energy theorem:
Substitute the values calculated in part (a):
Compute the ratio:
(a) , ; (b) , with ratio
03 The student omits the factor of 1/2 in the elastic potential energy formula, confusing potential energy with Hooke's law spring force multiplied by displacement.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You used instead of . Because the spring force varies linearly with stretch (), the work done corresponds to the triangular area under the graph, which introduces the factor of .
- Step 2Correct
You correctly subtracted the initial potential energy from the final potential energy, but your numerical values were doubled due to the missing in Step 1.
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the work-energy theorem by calculating the external work as the difference between two potential energy states.
You recognized that stretching the spring across equal consecutive intervals does not require equal work.
You correctly divided the two work quantities to find the ratio.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of including the prefactor .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou may have confused the formula for elastic potential energy () with the product of the maximum Hooke's law restoring force and displacement (). Because the restoring force increases linearly from to , the average force is , which yields for the stored energy.
REASONING PATH
Your ACEpath teacher’s suggested approach- Recall the elastic potential energy formula
The potential energy stored in an ideal Hookean spring stretched by is .
Always write the explicit factor before substituting numerical values for and .
- Verify units and average force
.
Check that your work calculation accounts for the changing force rather than treating force as constant.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompute .
Compute .
Determine .
Find the ratio .
(a) , ; (b) , with ratio
Lock it in
What is the correct formula for the elastic potential energy stored in an ideal spring stretched by a distance ?
. Remember that potential energy is proportional to the square of elongation, not elongation itself.
Similar question
A spring with spring constant is stretched from equilibrium to . Calculate the elastic potential energy stored in the spring.
Answer
. Key steps: .
A spring with is initially stretched by . How much additional external work is needed to extend it to a total stretch of ?
Answer
. Key steps: .
An archer pulls a bowstring modeled as an ideal spring with from to , and then continues pulling from to . Find the ratio of work done in the second interval to work done in the first interval.
Answer
Ratio . Key steps: ; ; Ratio .