Resources
In a university chemistry laboratory, students monitor the saponification of ethyl acetate in an alkaline medium. The reaction progress is monitored via electrical conductivity and modeled by the second-order integrated rate law , where represents in and is elapsed time in seconds. The standardized initial hydroxide concentration is titrated and determined to be . After of reaction in the thermostat-jacketed cell at , a standardized back-titration reveals that the remaining hydroxide concentration is . Use this experimental data to calculate the second-order rate constant (in ), and estimate the concentration remaining at . Round to four decimal places and to four decimal places.
Answer and steps
Final answer
,
Steps
Identify the Given Model and Parameters
The reaction follows the second-order integrated rate law:
From the problem statement, the known values are:
- Initial concentration:
- Concentration at :
Calculate the Rate Constant
Rearrange the rate law to solve for :
Compute the reciprocal concentrations:
Substitute these values and into the formula:
Rounding to four decimal places gives:
Estimate the Concentration at
Using the model with :
Substitute the initial condition and the rate constant:
(Note: Using the rounded value yields .)
Now invert to find :
Rounding to four decimal places gives:
Common Pitfall: A frequent mistake is taking as the final concentration; remember that the integrated rate equation solves for the reciprocal concentration , so you must take the inverse to find .
Typical errors
01 The student forgets to invert 1/[A]₁₂₀₀ at the end of the calculation, reporting the reciprocal concentration as the final concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You equated directly to the calculated value of . To obtain the actual concentration , you must take the reciprocal of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the second-order integrated rate law formula.
You accurately calculated the reciprocal concentrations and solved for the rate constant .
You correctly substituted to find the value of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou dropped the reciprocal operator on the left side of the equation in the final step, writing instead of inverting it.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating the reciprocal variable with the target concentration . In second-order kinetics, the integrated rate law is linear in , so the algebraic result of the right-hand side represents , not itself. A physical reality check also shows that a reactant starting at cannot increase to as time passes.
REASONING PATH
Your ACEpath teacher’s suggested approach- Isolate the Desired Variable
If an equation is written in terms of , then , not .
Always write the left-hand side explicitly as until you perform the inversion step: .
- Physical Reality Check
In a chemical reaction, reactant concentration must strictly decrease over time: .
Compare your final numerical value to . If the value is larger than the starting concentration, check whether you forgot to invert the reciprocal.
CORRECTED PATH
ACEpath Teacher's DemonstrationTake the reciprocal of both sides to isolate :
Evaluate the quotient:
Round to four decimal places as requested:
,
02 The student mistakenly subtracts 1/[A]ₜ from 1/[A]₀ when solving for k, resulting in a negative rate constant that propagates to an unphysical concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
When isolating from , subtracting from both sides yields , not .
- Step 2Correct
Your arithmetic and rounding were executed accurately, but the resulting rate constant became negative due to the reversed subtraction in Step 1.
- Step 3Correct
You correctly remembered to take the reciprocal to find , but using the negative value for led to an impossible negative concentration.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the second-order integrated rate law formula.
You accurately calculated the reciprocal concentrations and .
You correctly inverted in the final step to solve for the molar concentration.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou swapped the minuend and subtrahend when moving to the other side of the equation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the direction of change in reciprocal concentration: because reactant concentration decreases over time (), the reciprocal concentration increases (), meaning the final reciprocal must subtract the initial reciprocal to yield a positive slope .
REASONING PATH
Your ACEpath teacher’s suggested approach- Physical Reality of Rate Constants
Reaction rate constants must always be non-negative quantities ().
Whenever you obtain a negative value for , pause and check whether you inverted the subtraction order in your rate law rearrangement.
- Isolating Additive Terms
If , subtracting from both sides gives .
Always subtract the initial value from the value at time : .
CORRECTED PATH
ACEpath Teacher's DemonstrationRearrange by subtracting from both sides: .
Substitute the known values at : .
Solve for : .
Estimate : .
Invert to obtain : .
,
03 The student misapplies the rate law by treating the concentration values directly without taking their reciprocals, confusing second-order kinetics with zero-order kinetics.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You substituted the concentration values directly without taking their reciprocals. The second-order integrated rate law models the change in reciprocal concentration, .
- Step 2Correct
Your arithmetic in this step followed your equation from Step 1 consistently, but using the incorrect model and negative produced an impossible negative concentration.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the given initial concentration, reaction times, and measured concentration at .
You carried out standard linear algebraic rearrangements accurately to solve for the unknown parameter and evaluated the subsequent substitution.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the concentration terms directly as linear quantities rather than working with their reciprocal values , confusing a second-order rate law with a linear model.
REASONING PATH
Your ACEpath teacher’s suggested approach- Match Model Variables to Given Formula
For a second-order integrated rate law, the linear variable is reciprocal concentration , not concentration .
Always convert concentrations into reciprocals before subtracting or solving for .
- Check Physical Plausibility of Results
A chemical rate constant must be positive, and a chemical concentration can never be negative.
If your calculated or concentration is negative, pause immediately and check whether you omitted a reciprocal or inverted a sign.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompute the reciprocal concentrations: and .
Solve for the rate constant: .
Compute the reciprocal concentration at : .
Invert to obtain : .
,
Lock it in
In the second-order integrated rate law , what quantity does the right-hand side evaluate to?
It evaluates to the reciprocal concentration , not . You must invert it: .
Similar question
A gas-phase decomposition follows the second-order rate law with rate constant and initial concentration . Calculate the remaining concentration after .
Answer
. Inverting gives .
In a dimerization reaction following , the concentration drops from to at . Find , then determine the time required for to reach .
Answer
First, , so . For , . Then .
A chemical engineer models a wastewater contaminant following second-order decay with and . An intern claims that after , the concentration is . Identify the error and calculate the correct concentration in .
Answer
The intern calculated and forgot to invert it. The correct concentration is .