Resources
The concentration of an antibiotic in a patient's bloodstream is modeled by , where is measured in hours () and is in milligrams per liter (). (a) Find the time at which the absolute maximum concentration occurs on the interval . Show your calculus justification. (b) Express the instantaneous rate of change of concentration at in units of micrograms per milliliter per minute ().
Answer and steps
Final answer
(a) ; , which equals on only at . Evaluating endpoints and critical point: , , and , confirming an absolute maximum of at . (b) , since , and converting via .
Steps
Part (a): Absolute Maximum Concentration on
To find the absolute maximum of the continuous function on the closed interval , apply the Extreme Value Theorem by evaluating at any critical points in and at the endpoints.
- Find the critical points using the Quotient Rule: Let and , with derivatives and .
- Solve for : The derivative equals zero when the numerator is zero: Since the domain is , the only interior critical point is .
-
Evaluate the function at the critical point and endpoints:
- At the left endpoint:
- At the critical point:
- At the right endpoint:
Comparing these values, the absolute maximum concentration is , which occurs at .
Part (b): Instantaneous Rate of Change with Unit Conversion
- Evaluate the derivative at :
-
Convert the units to : Use the standard conversion factors:
Set up dimensional analysis:
Notice that the mass and volume conversion factors cancel each other out:
Therefore, only the time conversion factor affects the numerical value:
Typical errors
01 The student forgets to square the denominator when applying the quotient rule, resulting in an incorrect derivative and critical points.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
When applying the quotient rule , the denominator must be squared as .
- Step 2
- Step 3Correct
You substituted correctly into your derivative, but the missing squared denominator led to an evaluated rate of instead of .
- Step 4Correct
Your unit conversion factor of dividing by is completely correct, but the final numerical value is affected by the earlier derivative error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the quotient rule numerator structure .
You correctly evaluated the function at critical points and interval boundaries to find the absolute maximum.
You recognized that is equivalent to and divided by to convert hours to minutes.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote in the denominator of instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisForgetting the square on the denominator function in the quotient rule formula .
REASONING PATH
Your ACEpath teacher’s suggested approach- Quotient Rule Formula Template
The derivative of a quotient is .
Always write down the denominator with an explicit square before expanding or simplifying terms.
- Dimensional Unit Check
The rate of change has units of .
Verify conversions factor by factor using dimensional analysis cancellation.
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the correct derivative with the squared denominator: .
Substitute : .
Apply the unit conversion factor : .
02 The student multiplies by 60 instead of dividing by 60 when converting the time unit from per hour to per minute.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
Because hours are in the denominator, replacing with places in the denominator, requiring division by rather than multiplication.
WHAT YOU DID WELL
Compliments from Your TeacherYou applied the Quotient Rule and simplified the derivative algebraically without error.
You used the closed interval method by comparing function values at the critical point and both endpoints.
You correctly calculated the instantaneous rate of change at .
You recognized that is equivalent to .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the unit of time as if it were in the numerator when converting from hours to minutes, forgetting that converting a unit in the denominator requires the conversion factor in the opposite orientation so that the original unit cancels.
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Cancellation via Dimensional Analysis
To cancel a unit in the denominator, place that unit in the numerator of your conversion factor: .
Write out full unit fractions with explicit cancellation bars instead of multiplying or dividing by memory.
- Reasonableness Check on Rate Magnitude
A rate per minute must be of the rate per hour because far less change occurs in a single minute than in a full hour.
Check whether converting to a smaller time interval should make the numerical rate smaller or larger.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the dimensional analysis ratio: .
Cancel matching mass and volume units: , leaving .
Divide by : .
03 The student assumes 1 mg/L equals 1000 μg/mL by converting milligrams to micrograms while failing to convert liters to milliliters in the denominator.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
You converted to in the numerator, but did not convert to in the denominator. Because both the mass and volume scale by a factor of , is identically equal to .
- Step 5Correct
Your final calculation divided by minutes correctly, but carried over the extra factor of from step 4.
WHAT YOU DID WELL
Compliments from Your TeacherYou found the first derivative accurately using the Quotient Rule.
You properly tested the critical point and interval endpoints to justify the absolute maximum.
You evaluated correctly with appropriate initial units of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou converted milligrams to micrograms in the numerator but forgot to convert liters to milliliters in the denominator.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisTreating compound units as single units rather than writing full conversion fractions where numerator and denominator units cancel independently.
REASONING PATH
Your ACEpath teacher’s suggested approach- Set Up Explicit Conversion Factors
For compound units , convert and independently using multiplying factors that equal : and .
Always write out each conversion ratio with its units so you can visually verify which units cancel.
- Recognize Metric Concentration Equivalents
in dilute aqueous solutions.
Double-check compound metric ratios by comparing their scaling factors before multiplying.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the complete dimensional analysis expression: .
Cancel the mass units () and volume units (): .
Divide by the time conversion: .
Lock it in
What is the complete quotient rule for differentiating ?
. Remember: 'Low d-High minus High d-Low, over the square of what's below'.
Similar question
Find the derivative of the function , and evaluate .
Answer
. At , .
A substance concentration is given by for in hours. Find the instantaneous rate of change of at in .
Answer
. At , .
For the same function , convert the rate of change at into units of . Note: .
Answer
From the previous exercise, . Converting hours to minutes gives .