Resources
A remediation engineer models the migration of trichloroethylene (TCE) between an industrial wastewater stream and a natural organic sediment layer. The octanol-water partition coefficient of TCE is reported as . A student attempts to calculate the soil organic carbon-water distribution coefficient using the empirical sorption equation , but incorrectly treats the logarithm values: the student takes due to a mistaken sign convention regarding thermodynamic equilibrium distribution constants, resulting in instead of the correct evaluation. (a) Calculate the true linear adsorption distribution coefficient in . (b) If an aquifer sediment contains an organic carbon fraction and , calculate the correct solid-water distribution ratio () versus the corrupted value caused by the negative sign convention blunder.
Answer and steps
Final answer
(a) ; (b) vs.
Steps
Correct Value of
Part (a): Calculating the True Soil Organic Carbon-Water Distribution Coefficient ()
The empirical relation between the octanol-water partition coefficient () and the soil organic carbon-water partition coefficient () is: Substitute the correct value : Convert from logarithmic form to find :
Part (b): Calculating the True vs. Corrupted Solid-Water Distribution Ratio ()
The sediment-water distribution coefficient represents the ratio of contaminant mass bound to the sediment per unit mass of sediment relative to its concentration in the pore water, scaled by the sediment fraction of organic carbon ():
Using the organic carbon fraction and the rounded true :
(Using the unrounded intermediate value yields .)
Corrupted Value of
From the sign-error calculation, the corrupted was :
Multiplying by :
Environmental Significance Pitfall
Partition coefficients such as and are defined as concentration ratios at equilibrium () and are strictly positive values; their logarithms are also positive whenever the chemical partitions preferentially into the organic phase over water.
A sign error converting from positive to negative drastically underestimates the compound's affinity for sediment by more than four orders of magnitude (), incorrectly predicting that trichloroethylene (TCE) will barely adsorb and will flush immediately, whereas it actually undergoes significant retardation in organic-rich sediment.
Typical errors
01 The student forgets to take the antilogarithm of log Koc and mistakenly uses the logarithmic value as Koc itself.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You equated directly to . Because the correlation yields the common logarithm, you must take the antilogarithm: .
- Step 3Correct
You correctly multiplied by , but this calculation inherited the un-exponentiated value from Step 2.
- Step 4Correct
You used the corrupted directly as , producing a negative distribution coefficient. An equilibrium partition ratio cannot be negative; you must first convert using .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly substituted into the linear empirical equation and calculated .
You correctly applied the relationship in Part (b).
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou dropped the logarithm operator without applying its inverse, equating directly to .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated logarithmic values as linear equilibrium constants rather than converting via . A key physical check is that partition coefficients represent positive equilibrium concentration ratios and can never be negative.
REASONING PATH
Your ACEpath teacher’s suggested approach- Logarithmic vs. Linear Values
If an equation outputs , then the physical quantity is .
Always convert to before substituting into linear multi-phase partitioning formulas.
- Physical Reality Check
An equilibrium partition coefficient must always be strictly positive ().
If your calculated or is negative, check whether you accidentally used directly instead of .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert to linear form: .
Calculate correct : .
Convert corrupted to linear form: .
Calculate corrupted : .
(a) ; (b) vs.
02 The student misinterprets foc = 0.018 as a percentage and divides by 100 when calculating Kd.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You divided by , but is already given as a dimensionless mass fraction (), not as .
- Step 3Correct
You correctly multiplied your by , but this value is off by two decimal places due to dividing by in the previous step.
- Step 4Correct
You correctly found the corrupted and applied the formula for , but the result inherits the dilution from the error.
WHAT YOU DID WELL
Compliments from Your TeacherYou substituted correctly to determine the true value of .
You converted logarithmic partition coefficients back to linear scale using base- exponentiation.
You used the correct relationship for both the true and corrupted scenarios.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated a decimal fraction () as though it were already a percentage value () requiring conversion to decimal by dividing by .
REASONING PATH
Your ACEpath teacher’s suggested approach- Fraction vs. Percent Notation
Values given as a fraction (, such as or mass fraction ) without a percent symbol are already in decimal form; only values explicitly written with '' need to be divided by .
Check whether the parameter symbol is (fraction) or explicitly labeled with . If , use directly.
CORRECTED PATH
ACEpath Teacher's DemonstrationKeep the fraction as given: .
Compute the correct distribution ratio: .
Compute the corrupted distribution ratio: .
(a) ; (b) vs.
Lock it in
How do you convert a common logarithmic partition coefficient into the linear partition coefficient ?
. The inverse of the common logarithm (ase 10) is exponentiation with base 10.
Similar question
A hydrophobic pesticide has an estimated . Calculate the linear organic carbon partition coefficient in , and find for a soil with an organic carbon fraction .
Answer
. Then, .
Benzene has . An empirical relation gives . Determine: (a) , (b) true , and (c) the sediment distribution ratio in an aquifer with .
Answer
(a) . (b) . (c) .
A polar herbicide has a negative logarithmic sorption value: . A technician incorrectly writes . (a) Calculate the true . (b) If , calculate the true and explain physically why a negative is impossible.
Answer
(a) True . (b) True . A distribution ratio cannot be negative because physical chemical concentrations cannot be less than zero.