Resources
In an analytical chemistry laboratory, a aliquot of iron(II) sulfate solution is titrated to its equivalence point under acidic conditions () using standard solution. (a) Write the balanced oxidation half-reaction for the analyte and the balanced reduction half-reaction for the titrant . (b) If of titrant is required to reach the light-pink end point, calculate the initial molarity of in the sample.
Answer and steps
Final answer
(a) Oxidation: ; Reduction: ; (b)
Steps
Oxidation Half-Reaction
Part (a): Balancing the Half-Reactions
Iron(II) ion, , is oxidized to iron(III) ion, :
- Balance atoms: Iron is already balanced with atom on each side.
- Balance charge: The reactant has a charge of and the product has a charge of . Add to the product side:
Reduction Half-Reaction (in Acidic Solution)
Permanganate ion, , is reduced to manganese(II) ion, :
- Balance elements other than and : is already balanced ( on each side).
- Balance oxygen atoms: Add to the product side to balance the oxygen atoms:
- Balance hydrogen atoms: Add to the reactant side:
- Balance electrical charge:
- Left side charge:
- Right side charge:
- Add to the reactant side to reduce the charge from to :
Part (b): Calculating the Initial Molarity of
Determine the Overall Reaction Stoichiometry
Multiply the oxidation half-reaction by so the electrons cancel when combined with the reduction half-reaction:
The stoichiometric ratio between and is:
Calculate the Moles of Consumed
Convert the volume of titrant to liters:
Calculate moles using molarity ():
Calculate the Moles of in the Aliquot
Using the mole ratio:
Calculate the Initial Concentration of
The volume of the iron aliquot is :
Common Pitfall: Forgetting the stoichiometric factor and applying a simple formula leads to an answer that is 5 times too small. Always write out the balanced redox equation to identify the correct mole ratio.
Typical errors
01 The student assumes a 1:1 mole ratio between Fe²⁺ and MnO₄⁻ rather than using the 5:1 stoichiometric ratio from the balanced redox reaction, resulting in a calculated molarity of 0.0150 M.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
and
- Step 2
- Step 3Correct
Because the oxidation half-reaction releases and the reduction half-reaction consumes , the overall balanced reaction requires per . Therefore, must be 5 times the moles of .
- Step 4Correct
You correctly divided your mole quantity by the aliquot volume, but the final value is 5 times too low due to the missing stoichiometric factor from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced both the oxidation and reduction half-reactions under acidic conditions.
You converted the titrant volume to liters accurately.
You calculated the moles of permanganate ion using the correct concentration formula.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou jumped directly from finding the titrant moles to the analyte moles without combining the two half-reactions into a net redox equation to determine the stoichiometric electron-transfer ratio.
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometric Factor Check
In redox titrations, the mole ratio of reactants is governed by electron conservation: , giving .
Always multiply the half-reactions to equalize the electrons and write down the net stoichiometric ratio before calculating the unknown moles.
CORRECTED PATH
ACEpath Teacher's DemonstrationCombine the half-reactions by multiplying the oxidation reaction by : .
Determine the mole ratio: .
Calculate moles of : .
Compute the initial concentration: .
02 The student inverts the stoichiometric ratio and divides moles of MnO₄⁻ by 5 instead of multiplying by 5, obtaining an initial concentration of 0.00300 M.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
From the balanced equation, of reacts with of . Therefore, you need to multiply the moles of by , rather than dividing by .
- Step 4Correct
You correctly divided your calculated moles by the sample volume, but the value was affected by dividing by in the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou balanced both the oxidation and reduction half-reactions completely with correct electron transfers.
You correctly calculated the moles of permanganate titrant using molarity and volume.
You successfully derived the balanced overall equation and recognized that a relationship exists.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided the titrant moles by instead of multiplying by when converting from to .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisSetting up stoichiometry without explicit dimensional units can lead to inverting the conversion factor. Because each mole of oxidizes five moles of , there must be five times as many moles of present as consumed.
REASONING PATH
Your ACEpath teacher’s suggested approach- Use Dimensional Analysis with Chemical Formulas
Always write conversion factors with both the unit and the substance: .
Multiply moles of by so that cancels out.
- Perform a Physical Sense Check
If a reaction consumes 5 analyte particles per 1 titrant particle, the analyte must be present in a higher molar quantity.
Check whether your calculated analyte moles are larger than the titrant moles when the stoichiometric coefficient of the analyte is greater than 1.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the stoichiometric ratio as a conversion factor: .
Divide by the aliquot volume to find molarity: .
03 The student forgets to balance the oxygen and charge in the permanganate reduction half-reaction, assuming MnO₄⁻ is reduced directly to Mn²⁺ with 3 electrons, leading to an incorrect 3:1 stoichiometric ratio and a concentration of 0.0450 M.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
In acidic solution, you must balance oxygen atoms by adding and hydrogen atoms by adding before balancing the charge with electrons. Balancing the change from in to requires , not .
- Step 3
- Step 4Correct
Because your reduction half-reaction contained instead of , your combined mole ratio was instead of the correct . Your mole calculation correctly follows your equation, but is affected by the earlier balancing error.
- Step 5Correct
You correctly applied the concentration formula , but the numerical value is affected by the incorrect mole count from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly wrote the one-electron oxidation half-reaction for .
You correctly converted the titrant volume to liters and found the moles of consumed.
You correctly applied molarity formulas throughout your stoichiometric calculations.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNo — this is a conceptual misunderstanding of the half-reaction method for polyatomic oxyanions in acidic media.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou balanced the manganese reduction directly by looking only at overall ionic charges or confusing the oxidation state change with neutral conditions, omitting the addition of to balance oxygen and to balance hydrogen in acidic solution. As a result, the reduction was assigned rather than the true ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Stepwise Half-Reaction Balancing in Acid
For redox half-reactions in acidic solution: 1) Balance elements other than and ; 2) Balance by adding ; 3) Balance by adding ; 4) Balance net charge by adding electrons ().
Always verify that atoms (including and ) and net electrical charges are equal on both sides before moving to stoichiometric ratios.
CORRECTED PATH
ACEpath Teacher's DemonstrationBalance in by adding to the product side: .
Balance by adding to the reactant side: .
Balance net charge: left side is , right side is . Add to the left side: .
Multiply the iron oxidation half-reaction by to equalize electrons, giving a ratio of to .
Calculate moles of : .
Calculate initial molarity: .
(a) ; ; (b)
Lock it in
How do you find the stoichiometric mole ratio between the analyte and titrant in a redox titration?
Equalize the number of electrons lost and gained across both half-reactions and combine them into the net balanced redox equation.
Similar question
A sample of an oxalate solution () is titrated with . The half-reactions are and . If of titrant is used, what is ?
Answer
. Moles of . The balanced equation requires , so . Concentration .
A aliquot containing is titrated with in acidic solution. The half-reactions are and . If of dichromate solution is required, find the initial concentration of .
Answer
. Moles of . Since accepts and each loses , the ratio is . Moles of . Concentration .
An iron ore sample containing is analyzed by redox titration. If of electrons were transferred during the complete oxidation of the iron aliquot by , how many grams of iron were present in the aliquot? (Molar mass of )
Answer
. Since the oxidation is , each mole of iron releases of electrons. Therefore, . Mass .