Resources
In a titration of a weak monoprotic acid with standardized , a student considers whether the standard equilibrium assumption is valid prior to titrant addition. If the acid has an initial analytical concentration of , determine the threshold value of the acid dissociation constant () above which the ionization exceeds the traditional rule boundary, necessitating the quadratic formula.
Answer and steps
Final answer
Steps
Set Up the Acid Dissociation Equilibrium
To determine the critical dissociation constant () at which the acid ionizes to an extent greater than the standard limit, we analyze the equilibrium of a weak monoprotic acid before any titrant is added.
The dissociation of a weak monoprotic acid in water is represented by:
The equilibrium constant expression is:
Let represent the concentration of acid that ionizes at equilibrium:
Apply the Ionization Criterion
The rule states that the approximation is valid only if the fraction of dissociated acid is at most ():
At the boundary where ionization is exactly :
Calculate Equilibrium Concentrations
At this critical boundary:
Solve for
Substitute these equilibrium values into the exact expression:
Common Pitfall: A frequent mistake is substituting the approximate concentration into the denominator, which yields . Because we are determining the exact physical threshold where the actual dissociation reaches , the true equilibrium concentration must be used.
Thus, for any acid with at , the ionization exceeds , and the quadratic formula must be employed.
Typical errors
01 The student calculates the 5% ionization threshold Ka by applying the approximation [HA] ≈ C₀ in the denominator instead of subtracting the ionized amount.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
To find the true physical threshold where ionization reaches , you must use the exact equilibrium concentration of un-ionized acid in the denominator, rather than assuming .
- Step 3Correct
This value follows directly from using instead of in the denominator.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that at the boundary, the dissociated concentration is .
You correctly set up the numerator for the weak acid equilibrium expression as .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the initial concentration into the denominator of rather than subtracting the that ionized.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou applied the small- approximation while evaluating the exact physical boundary of that approximation. At a ionization level, has decreased to , which must be reflected in the equilibrium constant expression.
REASONING PATH
Your ACEpath teacher’s suggested approach- Exact vs. Approximate Equilibrium Concentration
, where is the degree of dissociation.
When solving for threshold parameters at a specified percent dissociation , always write the exact denominator .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the exact equilibrium expression:
Substitute and :
Compute the quotient:
02 The student misinterprets 5.00% as a decimal multiplier of 0.500 rather than 0.0500, leading to an incorrect ionization concentration and Ka.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You converted as instead of dividing by to get . A multiplier of corresponds to ionization.
- Step 2Correct
Your subtraction formula is conceptually sound, but the numerical result is affected by your earlier error in .
- Step 3Correct
You substituted into the equilibrium expression correctly based on your values, but the final constant reflects the incorrect ionization value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that the threshold concentration of ionized acid is found by taking a percentage of the initial concentration .
You used the exact equilibrium expression for the undissociated acid, , rather than approximating at the critical boundary.
You correctly substituted the equilibrium concentrations into the expression.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated as , shifting the decimal point one place too few and calculating for dissociation instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing single-digit percentages with tenths (e.g., mistaking for ).
REASONING PATH
Your ACEpath teacher’s suggested approach- Percent-to-Decimal Rule
To convert any percentage to a decimal, divide by : .
Always write before multiplying by concentration.
- Physical Reality Check
A weak acid undergoing only ionization should remain roughly intact.
Check that is close to ; here, is half of , which immediately signals a dissociation rather than .
CORRECTED PATH
ACEpath Teacher's Demonstration03 The student forgets to square the hydronium ion concentration in the numerator of the acid dissociation constant expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You wrote the numerator as rather than . Since dissociation produces one and one , their product must be .
- Step 4Correct
Your arithmetic was accurate for the expression you wrote, but omitting the squared term propagated an error of a factor of into the final threshold.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly translated the rule into the dissociated concentration .
You recognized that the exact threshold requires using rather than approximating it as .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the numerator of the acid dissociation constant as a single concentration rather than the product of the two dissociated ion concentrations .
REASONING PATH
Your ACEpath teacher’s suggested approach- Equilibrium Law Product Rule
For , the equilibrium law states .
Always write down the full symbolic equilibrium expression before substituting numbers to verify that every product concentration is represented.
- Equimolar Products in Pure Water
When a neutral monoprotic acid dissociates in water, , giving .
Check the units and power: since has effective concentration units of for monoprotic weak acids, the numerator must be a concentration squared divided by a single concentration.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the definition: .
Substitute , , and .
Compute the numerator: .
Evaluate the quotient: .
Lock it in
Why must you use instead of when calculating the critical at the ionization boundary?
Because you are finding the exact thermodynamic corresponding to an actual conversion, where of the acid has dissociated ().
Similar question
A solution of a weak monoprotic acid has an initial concentration . Find the threshold above which ionization exceeds .
Answer
At ionization, , and . Substituting into gives .
In some analytical protocols, a more stringent ionization rule is used before neglecting . For an acid with , calculate the critical acid dissociation constant for this limit.
Answer
At ionization, , so . The equilibrium acid concentration is . Thus, .
A weak base with hydrolyzes according to . What is the maximum value of such that the approximation remains valid within the boundary?
Answer
At the boundary of hydrolysis, , and . Then .