Resources
In a quality-control lab, a chemist analyzes a wastewater sample for dissolved barium ions using sulfate precipitation: , where for (so for the precipitation reaction written as reactants forming solid, ). The chemist dispenses of a solution into an Erlenmeyer flask, and slowly titrates with of from a burette. (a) Calculate the initial concentrations and immediately upon mixing. (b) Calculate the solubility product reaction quotient . (c) Predict whether precipitation of barium sulfate will occur in the titration flask.
Answer and steps
Final answer
(a) , ; (b) ; (c) Because (), precipitation of will occur.
Steps
Part (a): Initial Concentrations Immediately Upon Mixing
When two solutions are mixed, the total volume of the resulting mixture increases, which dilutes both solutes.
- Calculate the total volume of the mixture:
- Calculate using the dilution equation (): Since each formula unit of dissociates completely to yield one ion:
- Calculate using the dilution equation: Since each formula unit of dissociates completely to yield one ion:
Part (b): Reaction Quotient ()
The dissolution equilibrium for barium sulfate is:
The ion product reaction quotient, , takes the same mathematical form as the solubility product expression, , but uses the instantaneous concentrations right after mixing:
Substitute the diluted concentrations:
Part (c): Predicting Precipitation
To determine if a precipitate forms, compare to :
- If , the solution is unsaturated; no precipitate forms.
- If , the solution is saturated at dynamic equilibrium.
- If , the solution is supersaturated; the reverse reaction (precipitation) is favored to restore equilibrium.
Here:
Because (), excess ions will combine to form a solid precipitate until the ion product decreases to equal . Therefore, precipitation of will occur.
Typical errors
01 The student forgets to account for dilution upon mixing the two solutions, directly using the stock concentrations to compute Q_sp.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
When of barium nitrate solution is mixed with of sodium sulfate solution, the total volume becomes . You must dilute each stock solution using before finding the initial ion concentrations upon mixing.
- Step 2Correct
Your formula for and your arithmetic were both correct, but this value was affected by using the undiluted concentrations from Step 1.
- Step 3Correct
Your comparison rule and qualitative conclusion were correct, but the numerical value of propagated from the dilution omission in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly wrote the ion product expression .
You correctly applied the criterion that precipitation occurs when .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the stock solution concentrations as the concentrations in the combined mixture, overlooking the increase in total volume () that dilutes both ions immediately upon mixing.
REASONING PATH
Your ACEpath teacher’s suggested approach- Calculate Total Solution Volume
When two solutions are combined, .
Always add the volumes of the two reacting solutions first before calculating any molar concentrations.
- Dilute Both Species
.
Recalculate the initial concentration of every precipitating ion in the total mixture volume.
CORRECTED PATH
ACEpath Teacher's DemonstrationBecause , precipitation will occur.
(a) , ; (b) ; (c) Precipitation will occur.
02 The student misinterprets the precipitation criterion by comparing Q_sp to the reverse reaction formation constant K = 1/K_sp rather than K_sp.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Because , the solution is supersaturated and precipitation will occur.
You compared the solubility product quotient to the net precipitation formation constant instead of . Because , the forward dissolution is exceeded, meaning a precipitate of forms.
WHAT YOU DID WELL
Compliments from Your TeacherYou accounted for dilution by finding the combined total volume of .
You correctly calculated the initial concentrations of both barium and sulfate ions.
You correctly multiplied the initial concentrations to obtain the reaction quotient .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou matched the reaction quotient expression for dissolution () with the equilibrium constant for formation (). To test for precipitation, compare directly against for the dissolution equilibrium .
REASONING PATH
Your ACEpath teacher’s suggested approach- Match Quotients to Equilibrium Equations
For a dissolution equilibrium , is compared directly to .
Always verify that the reaction quotient expression and the equilibrium constant belong to the exact same balanced chemical equation.
- Precipitation Criterion
When , the solution is supersaturated and solid precipitates until .
Compare to : if , conclude that precipitation occurs.
CORRECTED PATH
ACEpath Teacher's DemonstrationRecall the dissolution equilibrium: , with .
Compare the ion product quotient to the solubility product constant : and .
Since (), excess ions precipitate out of solution.
Precipitation of will occur.
03 The student divides the moles by the volume of titrant added (150.0 mL) rather than the combined total volume (200.0 mL) when calculating mixed concentrations.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You divided by the added titrant volume () instead of the total final volume ().
- Step 2Correct
You used the stock concentration of without accounting for dilution in the combined solution.
- Step 3Correct
Your formula and arithmetic were executed correctly, but the resulting numerical value was affected by the earlier dilution errors.
- Step 4Correct
Because , the solution is supersaturated and precipitation of will occur.
Your reasoning that a precipitate forms when is completely sound, though the comparison values reflect your earlier steps.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the equilibrium expression for the reaction quotient .
You accurately stated that precipitation takes place when .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided by the titrant volume alone rather than adding the two solution volumes together, and you omitted dilution for the second reagent.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated dilution as a single-volume division rather than first establishing for both species when two solutions are mixed.
REASONING PATH
Your ACEpath teacher’s suggested approach- Always sum volumes first
When mixing two solutions of volumes and , the new volume is .
Write down as your very first calculation before finding any mixed concentrations.
- Dilute every dissolved species
applies to both the analyte and the titrant upon mixing.
Check that each ion's final concentration is smaller than its stock concentration.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate total volume: .
Calculate .
Calculate .
Calculate .
Compare: .
(a) , ; (b) ; (c) Precipitation will occur because .
Lock it in
Why must you recalculate concentrations before computing when two solutions are poured together?
Mixing adds liquid volumes together (), diluting both solutes according to .
Similar question
A student mixes of with of . Calculate the initial concentrations and immediately upon mixing.
Answer
. Diluting each ion: , and .
For lead(II) chloride, with . If and , calculate and state whether will precipitate.
Answer
. Since , the solution is unsaturated and no precipitate forms.
A chemist mixes of with of . For , . Determine whether a precipitate forms upon mixing.
Answer
. Diluted concentrations: , . . Because , no precipitate forms.