Resources
Students often intuitively assume that because ethanol (, molar mass ) and water (, molar mass ) both form hydrogen bonds, ethanol should have a higher boiling point because it has over twice the molar mass and greater dispersion forces. In reality, the normal boiling point of pure water is , whereas the normal boiling point of ethanol is only . (a) Calculate the difference in boiling points in Kelvin. (b) Resolve this counter-intuitive result by detailing the structural hydrogen-bonding capacity per molecule (number of donor protons vs. acceptor lone pairs) in water compared to ethanol.
Answer and steps
Final answer
(a) ; (b) Water has two hydrogen-bond donor hydrogen atoms and two acceptor lone pairs on the oxygen atom, allowing each molecule to participate in up to four hydrogen bonds in an extensive three-dimensional tetrahedral network. In contrast, ethanol has only one donor hydrogen atom on its group, limiting it to an average of two hydrogen bonds per molecule in linear/branched chains, meaning the cohesive intermolecular network in water is significantly stronger despite its lower molar mass.
Steps
Part (a): Calculating the Boiling Point Difference in Kelvin
- Calculate the temperature difference in Celsius:
-
Convert the difference to Kelvin: Because the magnitude of one degree Celsius is identical to one Kelvin (), any temperature difference has the exact same numerical value in Kelvin:
Common Pitfall: Do not add to the temperature difference. The conversion factor applies only when converting absolute temperatures, not temperature intervals ().
Part (b): Hydrogen-Bonding Capacity and Structural Network Comparison
Although ethanol has a larger molar mass () than water () and thus exhibits greater London dispersion forces, the strength and dimensionality of hydrogen-bonding networks dominate their boiling points:
-
Water ():
- Donors: The oxygen atom is bonded to two highly polarized hydrogen atoms ( protons).
- Acceptors: The central oxygen atom carries two non-bonding lone pairs.
- Network Formation: Because the number of donors equals the number of acceptors (a ratio, with donors and acceptors per molecule), each water molecule can form up to four hydrogen bonds. This enables water to form an extensive, highly cohesive, three-dimensional tetrahedral network.
-
Ethanol ():
- Donors: Only the single hydrogen atom on the hydroxyl () group can act as a hydrogen-bond donor; the five hydrogens bonded to carbon () are nonpolar and cannot participate in hydrogen bonding.
- Acceptors: The oxygen atom still possesses two lone pairs.
- Network Limitation: Because there is only one donor proton per molecule, ethanol is donor-limited. On average, each molecule can form only about two hydrogen bonds, restricting the intermolecular interactions to linear or branched chains rather than a rigid 3D lattice.
Conclusion: Water's perfectly balanced -donor/-acceptor capacity creates a dense, three-dimensional network of four hydrogen bonds per molecule, requiring far more thermal energy to break apart than ethanol's donor-limited, chain-like network.
Typical errors
01 A student mistakenly adds 273.15 to the temperature difference rather than recognizing that temperature differences have identical numerical values in Celsius and Kelvin.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You added to the temperature difference. A degree Celsius and a Kelvin represent intervals of identical size (), so temperature differences have the exact same numerical value without adding .
- Step 3
b) has 2 H-bond donor protons and 2 lone pair acceptors, forming up to 4 hydrogen bonds per molecule. ⟹ c) has only 1 H-bond donor proton and 2 lone pairs on oxygen, limiting it to an average of 2 hydrogen bonds per molecule. ⟹ d) Water has a higher boiling point because its extensive 3D hydrogen-bonding network provides more bonding per molecule than ethanol.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the numerical boiling point difference in degrees Celsius.
You correctly identified that water has two donor protons and two lone-pair acceptors, allowing up to four hydrogen bonds per molecule.
You correctly explained that ethanol is donor-limited with only one donor proton, resulting in an average of two hydrogen bonds per molecule.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeAdding to a temperature change () instead of recognizing that of change equals of change.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating absolute temperature conversion () with temperature interval conversion ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Temperature Interval Invariance
because both scales use the same degree increment size.
Check whether the problem asks for an absolute temperature or a temperature change before applying .
CORRECTED PATH
ACEpath Teacher's DemonstrationRecognize that .
Express both temperatures in Kelvin: and .
Subtract the two values: .
Substitute the calculated value: .
(a) ; (b) Water possesses hydrogen-bond donor protons and lone-pair acceptors per molecule, forming up to hydrogen bonds in a robust 3D tetrahedral network. Ethanol has only donor proton on its group, limiting it to an average of hydrogen bonds per molecule in linear/branched chains, resulting in lower cohesion despite its greater molar mass.
02 A student counts all hydrogen atoms in ethanol as potential hydrogen-bond donors, failing to recognize that only hydrogen atoms bonded to highly electronegative atoms (O) participate in hydrogen bonding.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
has donor protons and lone pairs on oxygen, forming hydrogen bonds per molecule.
- Step 3
has donor protons from its atoms and lone pairs on oxygen.
Correcthas donor proton from its group and lone pairs on oxygen.
Only hydrogen atoms covalently bonded to small, highly electronegative atoms (, , or ) act as hydrogen-bond donors. The five hydrogen atoms in the ethyl group are bonded to carbon () with negligible polarity, so they cannot act as donors.
- Step 4
Because lone pairs are the limiting factor, both water and ethanol form the same maximum number of hydrogen bonds per molecule.
CorrectBecause ethanol has only donor proton, it is donor-limited and participates on average in only hydrogen bonds per molecule in linear/branched chains, compared to water's hydrogen bonds in a dense 3D network.
Propagating your donor count error led you to conclude that both molecules form the same number of hydrogen bonds, leaving the boiling point difference unexplained.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the boiling point interval in Kelvin without erroneously adding .
You accurately identified the donor and acceptor counts for water and noted its ability to form four hydrogen bonds per molecule.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeWHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated all hydrogen atoms in an organic formula as hydrogen-bond donors, failing to distinguish polar O-H bonds from nonpolar C-H bonds. A hydrogen atom must be attached to N, O, or F to develop the strong partial positive charge required for hydrogen bonding.
REASONING PATH
Your ACEpath teacher’s suggested approach- Criteria for H-Bond Donors
A hydrogen atom is an H-bond donor only if it is covalently bonded to , , or . Hydrogens attached to carbon () are essentially nonpolar and cannot donate hydrogen bonds.
Inspect the structural formula and count only the hydrogens bonded directly to , , or .
- Stoichiometry of H-Bonding Networks
In pure bulk liquids, each hydrogen bond requires one donor and one acceptor. The maximum average number of hydrogen bonds per molecule is limited to .
Identify whether the molecule is donor-limited or acceptor-limited to determine the average number and dimensionality (chain vs. 3D network) of hydrogen bonds.
CORRECTED PATH
ACEpath Teacher's DemonstrationCount donors in ethanol: only the group has a hydrogen bonded to oxygen, giving donor proton. The hydrogens on the ethyl group () cannot donate.
Count acceptors in ethanol: the oxygen atom has lone pairs, giving acceptors.
Determine network limit: with donor and acceptors, ethanol is donor-limited. In bulk liquid, each donor pairs with an available acceptor, giving an average of hydrogen bonds per molecule (one as donor, one as acceptor).
Compare network dimensionality: water forms an extensive 3D tetrahedral network of hydrogen bonds per molecule, whereas ethanol forms weaker, lower-dimensional chains of hydrogen bonds per molecule, explaining why water boils at a higher temperature despite its lower molar mass.
(a) ; (b) Water has donor protons and acceptor lone pairs, allowing each molecule to form up to hydrogen bonds in a robust 3D tetrahedral network. Ethanol has only donor proton () and acceptor lone pairs, limiting it to an average of hydrogen bonds per molecule in linear/branched chains. Thus, water's intermolecular network is significantly stronger.
03 A student incorrectly assumes hydrogen-bonding capacity is determined solely by the number of donor protons, concluding ethanol forms 1 hydrogen bond and water forms 2.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
has bonds, so each water molecule forms hydrogen bonds in total.
Correcthas donor protons and lone pairs on oxygen, allowing each molecule to participate in up to hydrogen bonds in an extensive 3D tetrahedral network.
You counted only the hydrogen bond donors. Hydrogen bonding involves both donors and lone-pair acceptors; with bonds and lone pairs on oxygen, each water molecule participates in up to hydrogen bonds.
- Step 3
Ethanol has bond, so each ethanol molecule forms only hydrogen bond in total.
CorrectEthanol has donor proton and lone pairs on oxygen, so each molecule forms an average of hydrogen bonds (donating and accepting ), forming linear or branched chains.
You counted only the single donor proton. Because each ethanol molecule also possesses lone pairs on oxygen to accept hydrogen bonds from neighboring molecules, bulk ethanol participates in an average of hydrogen bonds per molecule.
- Step 4
Water has a higher boiling point because each molecule forms hydrogen bonds compared to only in ethanol.
CorrectWater has a higher boiling point because its hydrogen bonds per molecule form a dense, three-dimensional tetrahedral network that requires far more energy to disrupt than the donor-limited -hydrogen-bond chain network of ethanol.
Your conclusion follows the right qualitative trend, but it rests on the incorrect counts of versus bonds instead of bonds in a 3D network versus bonds in linear chains.
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the temperature interval in Kelvin accurately without incorrectly adding .
You correctly identified the number of polar donor bonds present in both water and ethanol molecules.
You recognized that hydrogen-bonding capacity is the key factor that overrides the greater London dispersion forces of ethanol.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated the total number of hydrogen bonds a molecule can form solely to its number of donor protons.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated hydrogen bonding as a one-way bond that a molecule 'gives' rather than a two-way intermolecular interaction requiring both a donor hydrogen atom and an acceptor lone pair. Consequently, you omitted the lone pairs on the oxygen atoms of both water and ethanol.
REASONING PATH
Your ACEpath teacher’s suggested approach- Count both donors and acceptors
Total hydrogen-bonding capacity per molecule equals when donors and acceptors are balanced (as in : ). In bulk liquid, the average number of bonds per molecule is .
Always identify two features for any molecule: (1) polar atoms attached to , , or (donors), and (2) non-bonding lone pairs on , , or (acceptors).
- Evaluate network dimensionality
A -bond system (like water) builds a rigid three-dimensional tetrahedral lattice, whereas a -bond system (like ethanol) is restricted to chain-like oligomers.
When explaining physical properties, connect the bond count to the structural dimensionality of the resulting intermolecular network.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify water's hydrogen-bonding capacity: Water has donor protons (the two bonds) and lone pairs on oxygen, giving each molecule the capacity to participate in up to hydrogen bonds ( donated, accepted).
Identify ethanol's hydrogen-bonding capacity: Ethanol has donor proton (the single group) and lone pairs on oxygen. Because the network is donor-limited, each ethanol molecule forms on average hydrogen bonds ( donated, accepted).
Compare the resulting networks: Water forms a dense, continuous three-dimensional tetrahedral network requiring substantial thermal energy to disrupt, whereas ethanol forms lower-dimensional linear or branched chains, explaining water's higher boiling point.
(a) ; (b) Each water molecule has donor protons and lone pairs, allowing it to participate in up to hydrogen bonds in an extensive 3D tetrahedral network. Each ethanol molecule has only donor proton and lone pairs, limiting it to an average of hydrogen bonds in linear chains, which accounts for water's higher boiling point despite its lower molar mass.
Lock it in
How does a temperature difference in degrees Celsius () convert to a temperature difference in Kelvin ()?
. A temperature interval has the exact same numerical value on both scales because and have identical step sizes.
Similar question
A liquid sample is heated from to its boiling point of . Calculate the temperature increase in Kelvin.
Answer
.
Methanol () has a normal boiling point of , while ethylene glycol () boils at . (a) Calculate the difference in boiling points in Kelvin. (b) Explain the difference in boiling points using hydrogen-bonding donor and acceptor capacities per molecule.
Answer
(a) . (b) Methanol has only one group ( donor proton, acceptor lone pairs), limiting it to an average of hydrogen bonds per molecule in chain-like aggregates. Ethylene glycol has two groups ( donor protons, acceptor lone pairs), enabling up to hydrogen bonds per molecule in an extensive, branched 3D network requiring much more thermal energy to disrupt.
An engineer calculates the heat required to warm of water using , where . The water warms from to . A trainee suggests converting the initial and final temperatures to Kelvin first to avoid an error. Evaluate the trainee's claim and calculate in kilojoules.
Answer
The trainee's claim is technically correct in principle but unnecessary in practice: converting both temperatures to Kelvin ( and ) yields , which is identical to . Calculating heat: .