Resources
A laboratory standard solution of technetium-99m (, ) is prepared with a concentration of . A technician must deliver an intravenous injection of exactly to a patient after preparation. Given , calculate the decay constant in , find the specific activity in at the time of injection, and determine the exact volume in milliliters () required for the patient dose.
Answer and steps
Final answer
; Specific activity ; Volume
Steps
Calculate the Decay Constant ()
Radioactive decay follows first-order kinetics. The relationship between the half-life () and the decay constant () is:
Substitute the given half-life of technetium-99m ():
Convert the Initial Concentration to
The initial activity concentration () is given in microcuries per milliliter (). Use the conversion factor (which means ):
Determine the Specific Activity at the Time of Injection ()
Using the first-order integrated rate law for radioactive decay:
Substitute , , and :
Common Pitfall: Rounding the decay constant too early can propagate error into subsequent steps. Always keep extra digits in intermediate calculations before rounding the final result to three significant figures.
Calculate the Required Injection Volume
The volume required to supply the target dose of is the total activity divided by the specific activity at the time of administration:
Typical errors
01 The student miscalculates the decay constant by using 1/t₁/₂ instead of ln(2)/t₁/₂, leading to an overestimated decay rate and an artificially large required volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Radioactive decay follows first-order kinetics, where half-life represents the time for the quantity to drop to of its initial value, meaning , or . Using corresponds to the reciprocal lifetime rather than the half-life decay constant.
- Step 2
- Step 3Correct
Your application of the integrated rate law and your arithmetic are completely sound, but the numerical result is lower than expected because it inherited the inflated decay constant from Step 1.
- Step 4Correct
You correctly divided the required dose activity by the specific activity at the time of injection, but your final volume reflects the carried-over error from Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the initial concentration from to .
You correctly selected and evaluated the first-order radioactive decay equation .
You correctly related the target administered activity and concentration to find the injection volume.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the relationship between half-life and decay constant () with the relationship between mean lifetime and decay constant (). Omitting the factor overstated the decay rate by roughly .
REASONING PATH
Your ACEpath teacher’s suggested approach- Half-Life vs. Mean Lifetime
For first-order decay, half-life is , whereas mean lifetime is .
Whenever a problem gives half-life , always include in the numerator: .
CORRECTED PATH
ACEpath Teacher's DemonstrationKeep from your correct Step 2.
; Specific activity ; Volume
02 The student confuses the microcurie prefix as 10⁻³ instead of 10⁻⁶, overestimating the initial activity concentration by a factor of 1000 and yielding an unrealistically tiny volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You converted using (milli) instead of (micro), making the initial concentration times too large.
- Step 3Correct
Your decay calculation followed the correct exponential law, but the numerical result inherited the factor from Step 2.
- Step 4Correct
Your dosage volume formula was set up correctly, but dividing by the inflated concentration produced instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the first-order decay relationship .
You set up the exponential decay law with the proper signs and values.
You correctly related total administered dose, concentration, and volume via .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted instead of when expanding the micro prefix ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusion between SI prefixes 'milli-' () and 'micro-' () during unit conversion from curies to becquerels.
REASONING PATH
Your ACEpath teacher’s suggested approach- SI Prefix Verification
The metric prefix micro- () represents , whereas milli- () represents .
Always write out the prefix power explicitly before converting composite units (e.g., ).
CORRECTED PATH
ACEpath Teacher's Demonstration; Specific activity ; Volume
03 The student forgets to apply radioactive decay over the 3.50 hours and calculates the volume directly using the initial concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You set the specific activity at the time of injection equal to the initial concentration, omitting the decay that takes place over the interval.
- Step 4Correct
Your volume formula is correct, but the result was affected by substituting the un-decayed initial concentration from Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the decay constant using .
You accurately converted units from to .
You used the correct relationship between dose, concentration, and volume ().
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou calculated the decay constant in part (a) but did not apply the first-order integrated decay law to find the specific activity remaining after elapsed time .
REASONING PATH
Your ACEpath teacher’s suggested approach- Account for Elapsed Time
Whenever an elapsed time is specified between preparation and administration, activity decreases according to or .
Always evaluate whether the concentration given represents or the administration time, and apply the decay equation before calculating dosage volumes.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the decayed specific activity at : .
Divide the required patient dose by the decayed specific activity: .
; Specific activity ; Volume
Lock it in
What is the exact mathematical relationship between the decay constant and the half-life for radioactive decay?
. Memory cue: decaying to half () brings the natural log of into the formula.
Similar question
A radiopharmaceutical sample of fluorine-18 () has a half-life of . Calculate its decay constant in and determine the fraction of activity remaining after .
Answer
. Since , the remaining fraction is (or ).
A solution of iodine-131 (, ) has an initial concentration of . Find its activity concentration after and state the volume required to administer a dose of .
Answer
. Concentration at : . Volume needed: .
A radioactive tracer has an initial activity of and decays to over . Determine the half-life of the isotope and its decay constant in .
Answer
Decay by a factor of () requires two half-lives: . The decay constant is .