Resources
In an analytical chemistry laboratory, a student monitors the dynamic equilibrium of the heterogeneous esterification reaction: . Initially, of acetic acid and of ethanol are combined in a sealed vial with an acid catalyst (total volume negligible change). After stirring at until dynamic equilibrium is established, the reaction mixture is quenched in ice water and titrated against a standardized solution using phenolphthalein indicator. The unreacted acetic acid requires exactly of the titrant to reach the endpoint. Determine the dimensionless equilibrium constant for this reversible esterification reaction at .
Answer and steps
Final answer
Steps
Equilibrium Amount of Acetic Acid from Titration
To find the equilibrium constant for this reversible esterification, we determine the equilibrium amounts of all reactants and products using stoichiometry and the titration data.
The unreacted acetic acid () is neutralized by sodium hydroxide () in a stoichiometric ratio:
Using the concentration and volume of the solution:
Stoichiometric Table (ICE Table)
The balanced chemical equation is:
Since all coefficients are , the amount of acetic acid consumed is equal to the amount of ethanol consumed, as well as the amounts of ethyl acetate and water produced:
Summarizing the mole quantities at dynamic equilibrium:
Common Pitfall: In dilute aqueous systems, the concentration of water is taken as constant and omitted from the equilibrium expression. However, in this liquid organic esterification reaction, water is formed in a stoichiometric amount comparable to the other species and is not the bulk solvent, so its concentration must be explicitly included.
Calculating the Equilibrium Constant
Let represent the total volume of the reaction mixture. The concentration of each component is .
The equilibrium expression is:
Because the number of moles of gaseous/liquid reactants equals the number of moles of products (), the volume terms cancel out completely:
Substitute the equilibrium mole values:
Typical errors
01 The student omits water from the equilibrium constant expression by incorrectly assuming water is a pure solvent with an activity of 1, resulting in Kc ≈ 30.0.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Water is a stoichiometric product formed in comparable concentration in this liquid-phase organic mixture, not a dilute aqueous solvent. Therefore, must be included in the equilibrium constant expression.
- Step 4Correct
Because was omitted from the numerator, the volume terms did not cancel and the calculation evaluated to instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the titration concentration and volume to find the equilibrium moles of acetic acid.
You set up the mole balance correctly to determine the reacted amount and remaining ethanol.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNone. Your arithmetic and titration stoichiometric reasoning were completely accurate.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou likely transferred the conventional rule for dilute aqueous solutions—where water acts as the bulk solvent and is assigned an activity of 1—to an organic liquid-phase reaction where water is a co-product whose concentration varies significantly.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify the Role of Water
In dilute aqueous solutions, water is the bulk solvent and its concentration is nearly constant, so it is omitted from . In neat organic reactions or gas-phase reactions where water is produced or consumed, water is an active reactant or product and must be included.
Check whether water is the solvent or one of the stoichiometric participants in a non-aqueous mixture before writing the expression.
- Dimensional Consistency and Volume Cancellation
For a dimensionless , the sum of stoichiometric coefficients of products must equal the sum of stoichiometric coefficients of reactants ().
Verify that the powers of concentration units in the numerator and denominator match the expected dimension of the equilibrium constant.
CORRECTED PATH
ACEpath Teacher's DemonstrationInclude in the numerator of the equilibrium constant expression: .
Recognize that since the reaction starts with zero water, .
Substitute the equilibrium moles into the expression, noting that the volume cancels out: .
Compute the final quotient: .
02 The student confuses the unreacted amount of acetic acid found by titration with the amount reacted, setting the product amounts equal to 0.066625 mol and calculating an inverted Kc of 0.250.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You calculated the moles of correctly, but the titrant reacts with the remaining unreacted acetic acid in the quenched mixture, so is , not the reacted amount.
- Step 2Correct
Your stoichiometric reasoning correctly applied the reaction ratios, but because the initial titration value was misidentified, the amounts of equilibrium reactants and products were reversed.
- Step 3Correct
You set up the equilibrium constant expression correctly, but substituting the inverted amounts yielded the reciprocal value .
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the stoichiometric moles of sodium hydroxide accurately using .
You maintained consistent mole conservation when subtracting the consumed reactant from the initial amount.
You correctly recognized that the reaction volume cancels out in the equilibrium constant expression because .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing titration of remaining unreacted reagent with direct measurement of reacted extent, leading to an inverted quotient for the equilibrium constant.
REASONING PATH
Your ACEpath teacher’s suggested approach- Titration Target in Quenched Equilibrium
Titration of an equilibrium mixture quantifies the active species currently present in the flask (the unreacted equilibrium amount, ), never the amount already consumed.
Always assign the titration result directly to the equilibrium line () of your ICE table: .
- Determining Change from Initial and Equilibrium
For a reactant, .
Calculate the amount reacted by subtracting the titrated equilibrium moles from the initial moles: .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet .
Find the reacted amount: .
Calculate the remaining ethanol: .
Calculate the products formed: .
Substitute into the equilibrium expression: .
03 The student writes the equilibrium constant expression as reactants over products instead of products over reactants, yielding the reciprocal value Kc ≈ 0.250.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the equilibrium constant expression. By definition, the law of mass action requires the equilibrium concentrations of the products in the numerator and the reactants in the denominator.
- Step 4Correct
Because the equilibrium expression was inverted, your final calculation yielded the reciprocal value of the true equilibrium constant.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the neutralization titration data to find the equilibrium quantity of acetic acid.
You accurately tracked the stoichiometric changes to find the equilibrium amounts of all four reaction components.
You correctly included water in the homogeneous liquid esterification equilibrium expression.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up the equilibrium constant expression as reactants over products rather than products over reactants.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflation of the numerator and denominator positions in the law of mass action ratio, leading to calculating instead of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Definition
For a general reversible reaction , the equilibrium constant is defined as .
Always verify that the species on the right-hand side (products) are in the numerator and the species on the left-hand side (reactants) are in the denominator.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the equilibrium expression with products over reactants: .
Substitute the equilibrium molar amounts: .
Compute the numerical value: .
Lock it in
When is water included in an equilibrium constant expression ?
Include when it is a reactant or product in non-aqueous or gaseous reactions; omit it only when it acts as the bulk solvent in dilute aqueous solutions.
Similar question
A mixture of of pure formic acid () and of methanol () is allowed to reach equilibrium in a sealed flask: . At equilibrium, of methyl formate is present. Calculate .
Answer
Key steps: At equilibrium, , and . .
In an esterification reaction, of acetic acid and of ethanol are mixed with of water initially added. At dynamic equilibrium, of ethyl acetate is formed. Calculate the equilibrium constant at this temperature.
Answer
Key steps: . Equilibrium moles: , , , . .
For the reaction , . If of acetic acid is mixed with of ethanol with no initial products, find the number of moles of ethyl acetate formed at equilibrium.
Answer
Key steps: Let be moles of ester formed. At equilibrium, , , , . . Solving the quadratic gives .