Resources
In the gas phase, hydrogen chloride () possesses an equilibrium bond length of () and an experimentally measured permanent electric dipole moment of . (a) Convert the bond distance to meters and the dipole moment to SI units of coulomb-meters (), using the conversion factor . (b) Calculate the theoretical dipole moment assuming complete unit charge separation (). (c) Calculate the partial charge (in units of elementary charge ) residing on the hydrogen and chlorine atoms. (d) Calculate the percent ionic character of the bond and classify the overall molecular polarity.
Answer and steps
Final answer
(a) ; . (b) . (c) Partial charge ( on and on ). (d) Percent ionic character . Because , is a polar covalent diatomic molecule.
Steps
(a) Unit Conversions
- Bond Distance (): Using the metric prefix pico ():
- Dipole Moment (): Multiply the measured dipole moment in debyes () by the given conversion factor:
(b) Theoretical Dipole Moment for Complete Charge Separation ()
An idealized, ionic bond entails a full elementary charge () separated by distance :
Converting back to debyes:
(c) Partial Charge () on the Atoms
The actual dipole moment reflects a fractional transfer of charge, . Rearranging for :
Since chlorine is more electronegative than hydrogen, the electron density shifts toward chlorine:
- Hydrogen atom:
- Chlorine atom:
Pitfall to Avoid: Ensure both dipole moments are in identical units ( or ) before calculating the dimensionless ratio .
(d) Percent Ionic Character and Molecular Polarity
- Percent Ionic Character:
- Classification: Because and the percent ionic character is approximately , the bond is predominantly covalent with moderate polarity. Therefore, gaseous is classified as a polar covalent diatomic molecule.
Typical errors
01 The student inverts the picometer conversion factor as 10⁻⁹ m instead of 10⁻¹² m, propagating an incorrect bond length throughout subsequent calculations.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
and
You converted the dipole moment to accurately, but you used for picometers instead of (). As a result, your bond length was overestimated by three orders of magnitude.
- Step 2Correct
You correctly used the definition of theoretical ionic dipole moment , but your result is times too large because it inherited your incorrect bond distance from Step 1.
- Step 3Correct
Your reasoning to find and then divide by is conceptually sound and correctly assigns positive and negative signs to and . However, because in the denominator was times too large, your calculated partial charge is times too small.
- Step 4Correct
, and is polar covalent.
You correctly applied the ratio formula for percent ionic character and correctly concluded that the molecule is polar. Your numerical value of was affected solely by the carried-over error in .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the conversion factor between debyes and coulomb-meters.
You applied the correct physical definition for the theoretical ionic dipole moment.
You accurately identified that chlorine is more electronegative than hydrogen, assigning to and to .
You correctly classified the gaseous molecule as polar.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted instead of for the prefix pico ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the metric prefix 'pico-' with 'nano-', which shifted your length value by a factor of and propagated through all dependent electrostatic quantities.
REASONING PATH
Your ACEpath teacher’s suggested approach- Sub-atomic and Bond Distance Metric Prefixes
, , and .
Whenever bond distances are given in picometers (), immediately write before entering the number into calculator steps.
- Sanity Checking Molecular Bond Lengths
Typical chemical bond lengths fall between and ( to ).
Verify that your converted bond length is around . A value of () corresponds to the wavelength of ultraviolet light or the size of a virus, which is far too large for a single chemical bond.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert bond length properly: .
Recalculate .
Calculate the partial charge ratio: . Hence, carries and carries .
Compute percent ionic character: .
(a) , ; (b) ; (c) ( on , on ); (d) ionic character; polar covalent molecule.
02 The student inverts the ratio for percent ionic character by dividing the theoretical ionic dipole moment by the measured experimental dipole moment.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4
= 100% = 100% = 552%
Correct= 100% = 100% = 18.1%
You inverted the fraction by dividing the theoretical ionic dipole moment by the experimental dipole moment. Because the experimental dipole moment represents a fraction of the fully ionic limit, must be in the numerator and in the denominator.
- Step 5
WHAT YOU DID WELL
Compliments from Your TeacherYou converted the bond distance and dipole moment into correct SI units.
You calculated the theoretical dipole moment assuming full unit charge separation accurately.
You found the correct partial charges residing on each atom.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou reversed the numerator and denominator in the percent ionic character formula, confusing the theoretical maximum reference value (the denominator) with the observed fractional value (the numerator).
REASONING PATH
Your ACEpath teacher’s suggested approach- Define percent ionic character
Always place the actual measured dipole moment in the numerator and the theoretical ionic dipole moment in the denominator.
- Physical bounds check
For neutral neutral-ground-state covalent and ionic molecules, , so .
Whenever your calculated percentage exceeds , pause and verify whether you accidentally inverted the ratio.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the percent ionic character ratio with the measured experimental value in the numerator: .
Substitute the calculated dipole moments: .
Evaluate the quotient: .
ionic character; polar covalent molecule
03 The student calculates partial charge in coulombs but fails to divide by the elementary charge e to express it in units of e as requested.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
( on and on )
You calculated the charge magnitude correctly in coulombs (), but you did not divide by the elementary charge to express the partial charge in units of .
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou carried out the conversions from picometers to meters and debyes to coulomb-meters with correct precision.
You used the fundamental relation correctly to find the theoretical dipole moment.
You evaluated the percent ionic character and correctly concluded that the molecule is polar.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou calculated the partial charge value in coulombs but forgot to divide by to express it as a multiple of the elementary charge .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the absolute partial charge (measured in coulombs) with the dimensionless partial charge fraction expressed in units of elementary charge , where .
REASONING PATH
Your ACEpath teacher’s suggested approach- Partial charge representation
The partial charge parameter represents the fraction of a full elementary charge (), meaning , or .
Always check whether the problem asks for the charge in coulombs () or in units of the elementary charge (). If the latter, divide your charge in coulombs by .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert coulombs to units of elementary charge: .
Assign partial charges according to relative electronegativities: chlorine is more electronegative than hydrogen.
State the individual atomic charges: carries and carries .
Partial charge ( on and on )
Lock it in
What is the exact power-of-ten conversion factor for the picometer () in meters?
. Remember: nano is (nine), whereas pico is .
Similar question
Hydrogen fluoride () has an equilibrium bond length of . Convert this distance into meters () and calculate its theoretical ionic dipole moment in coulomb-meters ().
Answer
. Then .
The experimental dipole moment of is (). Given , calculate the partial charges and (in units of ) and the percent ionic character of the bond.
Answer
. Thus, carries and carries . Percent ionic character .
A diatomic molecule has a bond length of and a percent ionic character of . Find its observed dipole moment in debyes (). ().
Answer
First, . . Since , . Converting to debyes: .