Resources
The industrial oxidation of sulfur dioxide over a vanadium pentoxide catalyst is governed by: , . A pilot plant operates a continuous-flow catalytic reactor at where the stream concentrations are measured in non-standard units: , , and . The thermodynamic equilibrium constant at this temperature is . (a) Convert all chemical concentrations into standard molarity (). (b) Calculate the reaction quotient in standard SI-derived units. (c) Compare to and predict the direction in which the system must shift to reach equilibrium.
Answer and steps
Final answer
(a) , , ; (b) ; (c) Since (), the reaction shifts left toward reactants (producing more and ).
Steps
Part (a): Convert Concentrations to Standard Molarity
Molarity is defined in moles per liter ( or ). Convert each concentration from millimoles per liter () using the conversion factor :
Part (b): Calculate the Reaction Quotient
For the balanced reversible reaction:
The expression for the reaction quotient follows the law of mass action, placing product concentrations raised to their stoichiometric coefficients in the numerator and reactant concentrations in the denominator:
Substitute the standard molar concentrations into the expression:
Simplification tip: Notice that . Therefore:
Part (c): Compare to and Predict Shift Direction
Compare the calculated value of with the given equilibrium constant :
- Reasoning: When , the ratio of products to reactants is currently greater than it is at dynamic equilibrium.
- Direction of shift: To reduce the numerator () and increase the denominator ( and ), the system shifts to the left (toward reactants, producing more and ) until .
Typical errors
01 The student inverts the reaction quotient expression by placing reactants over products, leading to a calculated Qc smaller than Kc and predicting a shift to the right.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You inverted the reaction quotient expression. By the law of mass action, products belong in the numerator and reactants belong in the denominator.
- Step 3
The system must shift to the right (toward products) to reach equilibrium.
CorrectThe system must shift to the left (toward reactants) to reach equilibrium.
Your reasoning following your calculated was logical, but because was inverted, the comparison and predicted shift direction were incorrect.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly divided millimolar concentrations by to obtain molarity in .
You correctly assigned stoichiometric coefficients as exponents for each chemical species.
You accurately evaluated the arithmetic for the expression you set up.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up the ratio as instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusion regarding the definition of the reaction quotient under the law of mass action, which always places the product activities or concentrations over the reactant concentrations.
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Orientation
Remember the mnemonic 'Products over Reactants' () whenever writing expressions for or .
- Predicting Equilibrium Shifts
If , products are in excess and the reaction shifts left; if , reactants are in excess and the reaction shifts right.
Compare the correctly oriented directly against on a number line to determine shift direction.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the reaction quotient with products over reactants: .
Substitute the standard molar concentrations: .
Compare to : , so .
Conclude the direction of shift: The system shifts left (toward reactants) to consume excess .
; since , the reaction shifts left toward reactants.
02 The student omits the stoichiometric exponents when writing the reaction quotient, yielding an incorrect Qc of 167 L/mol and incorrectly predicting a shift to the right.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You omitted the stoichiometric coefficients as powers in the law of mass action. For the reaction , both and must be squared in the expression for .
- Step 3Correct
Your comparison rule was applied consistently to your calculated value of , but because the correct is , . Therefore, the system actually contains an excess of products and must shift left toward reactants to reach equilibrium.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted millimoles per liter to standard molarity for every species.
You correctly placed products in the numerator and reactants in the denominator when formulating the reaction quotient.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the reaction quotient as a simple linear ratio of concentrations, forgetting that the law of mass action requires each concentration term to be raised to the power of its stoichiometric coefficient from the balanced equation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Apply Stoichiometric Exponents
In any equilibrium or reaction quotient expression for , .
Always write the balanced chemical equation directly above your or fraction and circle the stoichiometric coefficients before writing down any concentrations.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the law of mass action with stoichiometric coefficients as powers: .
Substitute the molar concentrations into the squared terms: .
Compare to : since , the system has an excess of products relative to equilibrium.
Conclude the shift direction: the reaction must shift to the left (toward reactants) to re-establish dynamic equilibrium.
(a) , , ; (b) ; (c) , so the reaction shifts left toward reactants.
03 The student uses the unconverted millimolar concentration values directly in the reaction quotient expression, arriving at Qc = 0.333 L/mol and predicting an incorrect forward shift.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You correctly set up the expression for , but you substituted the unconverted millimolar values (, , and ) rather than the standard molarities calculated in part (a). Because , the value of changes by a factor of when changing from to .
- Step 3Correct
Since , the reaction shifts to the left (toward reactants) to reach equilibrium.
Your logic connecting to a rightward shift is logically sound, but it was affected by your calculation error in part (b). With the correct value , , meaning the system must shift to the left.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted all three stream concentrations from millimoles per liter to standard molarity.
You formulated the correct stoichiometric expression for the reaction quotient .
You correctly recognized how to interpret the directional shift based on the inequality between and .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou calculated converted values in part (a) but grabbed the original numbers from the problem statement when plugging them into the formula.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked unit consistency across multi-part calculations, substituting numerical values in millimolar units into an equilibrium quotient expression whose equilibrium constant is given in standard molar units ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Match Calculation Units to Equilibrium Constant Units
The concentrations entered into must have the exact same unit base as specified by (here, ).
Before evaluating an equilibrium quotient, cross-check that every numerical value plugged into the formula matches the units of .
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the standard molarity values into the reaction quotient expression:
Simplify the ratio :
Compare to :
Conclude the direction of shift: because products are in excess relative to equilibrium, the reaction shifts left toward reactants.
(a) , , ; (b) ; (c) Since (), the system shifts to the left toward reactants.
Lock it in
How are reactants and products arranged in the expression for the reaction quotient or equilibrium constant ?
Products are always placed in the numerator and reactants in the denominator: , with each raised to its stoichiometric coefficient.
Similar question
For the decomposition reaction at , a container holds , , and . If , calculate and determine the direction of the shift.
Answer
. Since , the system shifts left (toward reactants).
Consider the Haber-Bosch synthesis: with at . A reaction vessel contains , , and . Calculate and predict whether more ammonia or more reactants will form.
Answer
. Since , the system shifts left, forming more reactants.
Methane reacts with steam via (). An engineer measures stream concentrations: , , , and . Calculate , compare it to , and state whether the forward or reverse rate is momentarily greater.
Answer
. Since , the system shifts right, meaning the forward rate is momentarily greater than the reverse rate.