Resources
An aqueous dynamic equilibrium system involves the formation of the complex ion iron(III) thiocyanate: , with an equilibrium constant of at . A stock solution is prepared containing initially of and of potassium thiocyanate (, molar mass ) dissolved in water to make exactly of solution. Calculate the equilibrium concentration of the deep-red complex in .
Answer and steps
Final answer
Steps
Calculate the initial concentrations of the reactants
- Initial concentration of :
-
Initial concentration of : First, find the amount of substance of potassium thiocyanate ():
Since dissociates completely in water (), the moles of equal the moles of . Dividing by the total solution volume ():
Construct the ICE table
Let represent the equilibrium concentration of the iron(III) thiocyanate complex, , in units of .
Express and solve the equilibrium constant expression
The reaction quotient at equilibrium equals the equilibrium constant:
Convert to consistent units of :
Substitute the equilibrium concentrations into the expression:
Rearrange to standard quadratic form:
Apply the quadratic formula :
This yields two roots:
Common Pitfall: A change of is physically impossible because it exceeds the initial concentration of the limiting reactant (), which would result in negative reactant concentrations. Therefore, only the smaller root is valid.
Thus, the equilibrium concentration of the deep-red complex is:
Typical errors
01 The student forgets to divide the amount of KSCN by the solution volume (250.0 mL), mistakenly treating the total moles in 250 mL as the molar concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You equated molarity directly to the number of moles without dividing by the solution volume ().
- Step 3Correct
Your equilibrium expression correctly followed the law of mass action, but it carried forward the incorrect initial value for .
- Step 4Correct
You expanded and solved the quadratic equation algebraically correctly based on your substituted numbers.
- Step 5Correct
This final concentration is affected by the early volume omission in Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the mass of potassium thiocyanate to moles using its molar mass.
You set up the mass-action equilibrium ratio for the formation of the complex ion with the correct stoichiometry.
You carefully solved the quadratic equation and selected the physically meaningful root.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the absolute mole quantity () directly as the molar concentration ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating amount of substance (moles, ) with molar concentration (molarity, ) when solute is dissolved in a non-liter volume.
REASONING PATH
Your ACEpath teacher’s suggested approach- Molarity Definition Check
where must be in liters ().
Always divide calculated moles by the total solution volume before placing concentrations into an ICE table.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the correct initial thiocyanate concentration: .
Substitute into the equilibrium constant expression in : .
Expand to standard quadratic form: .
Apply the quadratic formula to find , giving (since ).
02 The student assumes the small-x approximation is valid despite a moderately large Kc and small initial reactant concentrations, omitting x from the denominator terms.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
With , the forward reaction proceeds significantly toward products, so is not negligible compared to the initial concentrations. Omitting from the denominator terms produces an invalid quadratic simplification.
- Step 3Correct
Because of the invalid small- approximation, your calculated exceeds the initial amount of limiting reactant (), which is physically impossible.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the initial molarity of thiocyanate from mass and volume.
You correctly wrote the equilibrium constant expression in terms of products over reactants.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou dropped from the reactant concentrations assuming it was negligible, even though is moderately large.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisApplying the small- approximation routinely without verifying whether is small relative to initial concentrations ( or ). When or initial concentrations are tiny, the equilibrium change represents a large fraction of the reactants.
REASONING PATH
Your ACEpath teacher’s suggested approach- Rule of 400/500 for small-x
The small- approximation is only valid when the initial reactant concentration divided by is greater than approximately to (or when percent dissociation is ).
Always check before omitting , or solve the full quadratic equation.
- Physical feasibility check
The equilibrium change can never exceed the initial concentration of any reactant.
Whenever you compute , immediately check if .
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the equilibrium terms into : .
Work in consistent units where : .
Expand and rearrange into standard form: .
Solve using the quadratic formula: .
03 The student confuses millimolar with molar concentrations and substitutes 4.00 M and 1.03 M directly into the equilibrium expression without converting mmol/L to mol/L.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You calculated , but because the mass was in milligrams, the resulting concentration is (), not . Similarly, the given initial concentration of was , not .
- Step 2Correct
(or using molarity with and in )
Your algebraic expansion and formation of the quadratic equation were executed properly, but the equation inherited the inflated initial concentrations from Step 1.
- Step 3Correct
You correctly solved your quadratic equation for the physically plausible root below the limiting reactant concentration, but the value is incorrect due to the upstream unit error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly set up the mass-action quotient for the formation of the iron(III) thiocyanate complex.
You accurately expanded the quadratic expression and applied the quadratic formula to find the physically meaningful root.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou omitted the factor when calculating molarity from milligrams and when interpreting the given millimolar concentration of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused millimolar () and milligrams () with molarity () and grams (), substituting numbers without matching the units of the equilibrium constant .
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Alignment with $K_c$
The concentrations entered into an equilibrium constant expression must match the concentration units embedded in . If is in (), all species concentrations must be expressed in (or must be converted to ).
Before filling in an ICE table, explicitly convert all concentrations to or verify the unit conversion factor of .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert both initial concentrations to consistent units: and .
Convert to millimolar units if working in : .
Substitute into the equilibrium expression: , yielding .
Solve using the quadratic formula: . Reject because it exceeds .
Lock it in
What is the fundamental mathematical relationship between moles of solute (), solution volume (), and molarity ()?
. Moles represent an absolute quantity, whereas molarity represents moles per liter of solution.
Similar question
A student dissolves of (molar mass ) in water to form exactly of solution. What is the initial concentration of in ?
Answer
. Moles of . Molarity .
In the equilibrium reaction with , of and of are dissolved together in water to make of solution. Calculate the equilibrium concentration of in .
Answer
. Initial concentrations: . Equilibrium equation: . Solving via the quadratic formula yields (rejecting as it exceeds initial amounts).
A solution is prepared by mixing of with of . For the reaction with , find in .
Answer
. Due to dilution by mixing equal volumes, and . With , . Solving gives .