Resources
A high-altitude meteorological research probe carries a rigid sealed canister containing of argon gas. At ground level, the internal pressure is . When the probe reaches the mesosphere, the internal temperature of the canister stabilizes at . Under these conditions, the argon exhibits slight non-ideality governed by the van der Waals equation: , where and . Use the universal gas constant and . Calculate the compressibility factor of the argon inside the canister at this mesospheric equilibrium state.
Answer and steps
Final answer
Steps
Identify the Relevant State Variables
The canister is rigid and sealed, which means both its volume () and the amount of substance () remain constant between ground level and the mesosphere:
- Volume:
- Amount of substance:
The ground-level pressure is extraneous information because the equilibrium state in the mesosphere is completely defined by the canister's volume, the moles of argon, and the mesospheric temperature.
Convert the mesospheric temperature to kelvins:
Calculate the Actual Pressure Using the van der Waals Equation
The van der Waals equation of state is:
Rearranging for the pressure :
a: Calculate the kinetic term
- Product :
- Effective volume :
- Quotient:
b: Calculate the attractive correction term
c: Determine the internal pressure
Compute the Compressibility Factor
The compressibility factor is defined as:
Substitute the calculated values:
(Note: A value of indicates that under these conditions, attractive intermolecular forces dominate slightly over the excluded volume effect, causing the real gas pressure to be marginally lower than that predicted by the ideal gas law.)
Typical errors
01 The student forgets to convert the Celsius temperature to Kelvin, substituting a negative Celsius value directly into the gas law.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You substituted directly into . Gas law calculations require absolute temperature in kelvins ().
- Step 2
- Step 3
- Step 4Correct
You correctly rearranged and applied the van der Waals formula for pressure, but the negative numerical result was carried over from your earlier temperature error.
- Step 5Correct
You used the correct definition for , but the downstream values from your temperature slip led to instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the relevant parameters and set up the van der Waals equation rearranged for pressure.
You calculated both the excluded volume term and the attraction correction term accurately.
You correctly applied the definition of the compressibility factor .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou forgot to convert the Celsius temperature to kelvins before evaluating .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisTreating Celsius directly as the thermodynamic temperature in gas law equations instead of converting to the absolute Kelvin scale (), which produces unphysical negative thermal energies and pressures.
REASONING PATH
Your ACEpath teacher’s suggested approach- Absolute Temperature Requirement
Every gas law (ideal or real) derived from kinetic molecular theory requires absolute temperature: .
Convert all temperatures to kelvins as your very first step before calculating .
- Sanity Check for Pressure
The absolute pressure of an enclosed gas must always be strictly positive ().
If you obtain a negative value for pressure, pause immediately and verify your temperature conversion.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the mesospheric temperature to kelvins: .
Recalculate the thermal energy term: .
Solve for the actual pressure using the correct : .
Calculate the compressibility factor: .
02 The student adds the molecular attraction term instead of subtracting it when rearranging the van der Waals equation for pressure.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
When isolating from , dividing by leaves . You must subtract from both sides, not add it.
- Step 4Correct
Your arithmetic in this step followed your rearranged formula correctly, but the resulting pressure was too high because of the earlier sign error.
- Step 5Correct
Because your calculated pressure was too high, your compressibility factor exceeded , incorrectly suggesting that repulsive forces dominate over attractive forces.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted temperature from degrees Celsius to kelvins.
You accurately identified that the canister volume and gas moles remain constant.
You calculated the numerical values of both the kinetic term and the attraction correction term with precision.
You applied the correct definition formula for the compressibility factor .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally wrote a plus sign instead of a minus sign when moving the attraction correction term to the other side of the equation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou may have remembered that the pressure factor inside the bracket contains a plus sign, , and carried that addition over when isolating , rather than performing the inverse algebraic operation (subtraction). Physically, real attractive forces pull molecules inward away from the walls, so measured real gas pressure is always lower than the kinetic ideal pressure.
REASONING PATH
Your ACEpath teacher’s suggested approach- Algebraic isolation checkpoint
If , then .
Always write the intermediate equation before isolating to guarantee subtracting the second term.
- Physical reasonableness check
Intermolecular attractions decrease the wall collisions, reducing pressure below the ideal kinetic term.
Verify that your calculated actual pressure is strictly smaller than the kinetic term .
CORRECTED PATH
ACEpath Teacher's DemonstrationIsolate correctly by subtracting the attraction term: .
Substitute the previously calculated values: .
Compute the compressibility factor: .
03 The student confuses the given ground-level pressure with the mesospheric pressure and assumes pressure remains constant in the canister.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You converted the initial ground-level pressure () and assumed pressure remained unchanged. Because the canister is sealed and rigid, volume and moles remain constant, but the significant temperature drop alters the internal pressure. You need to calculate the actual mesospheric pressure using the van der Waals equation of state.
- Step 3
- Step 4Correct
Your formula and substitution structure for were correct, but the calculated value was skewed by the incorrect pressure used from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the mesospheric temperature into absolute temperature in kelvins.
You accurately identified the definition of the compressibility factor as .
You correctly calculated the thermal energy term .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the pressure as an invariant state variable across different thermal environments, mistakenly carrying over the ground-level pressure rather than computing the new equilibrium pressure for a rigid, constant-volume system.
REASONING PATH
Your ACEpath teacher’s suggested approach- Rigid Sealed Containers Fix $V$ and $n$, Not $P$
In an isochoric closed system, volume and mole amount are fixed; internal pressure varies with temperature .
Always identify which state variables are constrained by the physical boundary (here, and ) before selecting which variable must be solved from the equation of state.
- Solving Pressure from the van der Waals Equation
Rearrange the van der Waals equation explicitly for when , , and are known.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the effective free volume: .
Calculate the kinetic pressure term: .
Calculate the intermolecular attraction term: .
Find the equilibrium pressure: .
Lock it in
Why must temperature always be expressed in kelvins rather than Celsius when using gas laws like or van der Waals?
Gas laws are based on kinetic theory where thermal energy is proportional to absolute temperature; zero kinetic energy occurs at , not .
Similar question
A weather balloon holds of helium in a flexible compartment at an altitude where the temperature is . Assuming ideal behavior, calculate the internal pressure of the gas in atmospheres. ()
Answer
. Steps: . Using .
A sample of of methane gas occupies at . The van der Waals constants for methane are and . Determine the pressure of the methane in atmospheres.
Answer
. Steps: . . . Kinetic term . Attraction term . .
A sample of carbon dioxide gas at in a rigid cylinder has a measured pressure of . Calculate the compressibility factor under these conditions and state whether attractive or repulsive forces dominate. ()
Answer
; attractive forces dominate. Steps: . . . . Because , attractive intermolecular forces dominate.