Resources
A laboratory gas syringe is initially filled with of carbon dioxide gas at a pressure of and a temperature of . The syringe is compressed isothermally until the pressure inside reads . Calculate the final volume of the gas in cubic centimeters ().
Answer and steps
Final answer
Steps
Identify the applicable gas law
The problem states that the gas is compressed isothermally, meaning the temperature remains constant (). The amount of gas inside the sealed syringe is also constant.
Under constant temperature and quantity of gas, the pressure and volume are inversely proportional according to Boyle's Law:
Harmonize units of measurement
Before applying Boyle's Law, the pressure values must be in the same units, and the volume units must align with the required answer:
- Initial volume: (since ).
- Initial pressure:
- Final pressure:
Convert from to using the standard equivalence :
(Alternatively, converting to gives .)
Common Pitfall: Never substitute pressures into gas law equations with mismatched units (e.g., using for and for ). Units must cancel out completely.
Solve for the final volume ()
Rearrange Boyle's Law to isolate :
Substitute the known values:
Rounding to three significant figures (matching the given value ):
Typical errors
01 The student forgets to convert the two pressures into the same unit and substitutes 101.3 kPa and 1850 mmHg directly into Boyle's Law, yielding an unphysically small volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted and directly into the equation. Because the two pressures are expressed in different units, their units do not cancel out. You must convert both pressures to the same unit before substituting.
- Step 3Correct
Your arithmetic evaluation was performed correctly, but the resulting numerical value and units are invalid because of the pressure unit mismatch in the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified Boyle's Law as the governing relationship under isothermal conditions.
You manipulated the algebraic equation accurately to isolate the unknown variable .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the raw numerical values directly into the algebraic expression without checking whether the pressure units matched.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking unit consistency requirements in ratio-based gas laws; pressure values must share identical units so that the dimensional units cancel cleanly.
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Harmonization Check
In , and must have the exact same unit so that becomes a dimensionless ratio.
Always write down the units alongside each numerical quantity and perform unit conversions before substituting them into the equation.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert from to : .
Substitute the harmonized values into Boyle's Law: .
Calculate the quotient: .
02 The student treats pressure and volume as directly proportional rather than inversely proportional (using P1 / V1 = P2 / V2), resulting in an increased volume during compression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
At constant temperature, pressure and volume are inversely proportional according to Boyle's Law (), not directly proportional.
- Step 3Correct
Your numerical substitution and arithmetic followed your rearranged formula correctly, but the formula itself was inverted.
- Step 4Correct
Because of the inverted relationship in Step 2, the final volume increased to rather than compressing to .
WHAT YOU DID WELL
Compliments from Your TeacherYou recognized the need to harmonize pressure units before calculating and correctly equated to .
You performed accurate algebraic rearrangement and arithmetic based on your written formula.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated pressure and volume as directly proportional () rather than inversely proportional (). When gas in a closed container is compressed to a higher pressure, its volume must decrease.
REASONING PATH
Your ACEpath teacher’s suggested approach- Physical Reality Check
Compressing a closed gas syringe always forces the gas into a smaller volume ().
Check if your final volume makes physical sense: here increased from to , so must become smaller than .
- Boyle's Law Form
For an isothermal process with constant moles of gas, .
Isolate the unknown as rather than setting up a quotient ratio.
CORRECTED PATH
ACEpath Teacher's DemonstrationRearrange Boyle's Law to isolate :
Substitute the known values with matched units:
Calculate:
Round to three significant figures to match the given pressure:
03 The student uses the wrong conversion factor between mmHg and kPa by multiplying by 760 instead of dividing, arriving at an erroneously high initial pressure in mmHg.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You multiplied directly by instead of setting up a dimensional analysis ratio. Because , is approximately , not .
- Step 2
- Step 3Correct
Your algebra and substitution followed consistently from your earlier pressure value, but the calculation propagated the incorrect .
WHAT YOU DID WELL
Compliments from Your TeacherYou identified that the constant-temperature condition requires Boyle's Law.
You rearranged the gas law formula algebraically to solve for the target variable .
You recognized that when stating your volume units.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated as if it were in atmospheres, multiplying directly by without dividing by .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIncomplete dimensional analysis: applying a bare numerical factor () without setting up explicit numerator and denominator units to cancel out .
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Analysis
Every conversion factor must have cancelling units: .
Always write the target unit in the numerator and the starting unit in the denominator, using standard atmospheric values ().
- Physical Reality Check
When a gas is compressed ( increases), volume must decrease ().
Compare your final volume to the initial volume: the pressure increased from to , so the volume must decrease below , making an answer like an immediate red flag.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert from to : .
Substitute the matched pressure units into Boyle's Law: .
Evaluate the arithmetic: .
Round to three significant figures to match : .
Lock it in
Why must and have identical units when using Boyle's Law ()?
Because pressure units must cancel out in the ratio , leaving the volume in the correct original volume units.
Similar question
A sample of neon gas occupies at a pressure of . If the gas is compressed isothermally until its pressure reaches , what is its final volume in milliliters? ()
Answer
. Key steps: Convert to atmospheres: . Apply Boyle's Law: .
A weather balloon holds of helium at sea level where the pressure is . It rises to an altitude where the pressure drops to at constant temperature. What is the balloon's new volume in cubic meters? ()
Answer
. Key steps: Convert to kilopascals: . Apply Boyle's Law: .
A rigid cylinder containing argon gas at is connected via a stopcock to an evacuated cylinder of volume . When the valve opens at constant temperature, the gas expands into both cylinders, and the final uniform pressure is . Find the initial volume of the argon gas in cubic centimeters. ( and )
Answer
. Key steps: Convert pressures to a common unit: (since ). The total final volume is . Set up Boyle's Law: . Solve for : .