Resources
An environmental water quality laboratory evaluates an industrial wastewater sample. The sample contains fluoride ions at a concentration of (assume solution density , with , and molar mass of fluoride ). To a aliquot of this wastewater, a technician adds of solid calcium chloride, (), assuming dissolution occurs without volume expansion. If for at , convert all concentrations to molarity, calculate the reaction quotient , and determine whether precipitates.
Answer and steps
Final answer
Converted initial concentrations: , ; ; since (), precipitates.
Steps
Calculate the Molarity of Fluoride Ions ()
The wastewater contains of fluoride ions. With a solution density of , :
Using the molar mass of fluoride (), find the molarity:
Calculate the Molarity of Calcium Ions ()
Solid calcium chloride dissolves completely according to:
- Find the amount of added:
- Because each mole of yields one mole of :
- Calculate the concentration in the () solution:
Write the Expression for the Reaction Quotient ()
The dissolution equilibrium for calcium fluoride is:
The reaction quotient expression matches the form of the solubility product expression:
Common Pitfall: Do not multiply by inside the bracket. The stoichiometric coefficient of appears solely as an exponent in the expression for because is already the actual existing molar concentration of fluoride ions in the beaker.
Calculate and Compare with
Substitute the calculated molarities into the reaction quotient:
Now compare the value of with :
Because , the ion product exceeds the solubility limit of the salt, meaning the solution is supersaturated and a precipitate of will form.
Typical errors
01 The student forgets to square the fluoride ion concentration in the solubility product reaction quotient expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
In the dissolution equilibrium , each formula unit releases two fluoride ions. Therefore, the stoichiometric coefficient of must appear as an exponent on in the reaction quotient expression.
- Step 4Correct
Your precipitation logic () and final conclusion are correct, but your comparison used the incorrect numerical value of calculated in Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou converted of fluoride into molarity with accurate unit analysis.
You calculated the molarity of correctly from the mass of solid and the volume of solution.
You correctly stated the decision criterion that a precipitate forms whenever .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up as a simple product of linear concentrations without raising to the power of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked that the stoichiometric coefficient of an ion in the balanced dissolution equation must become an exponent in the equilibrium expression and reaction quotient ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Write the Balanced Dissociation Reaction First
For a salt , the reaction quotient is .
Always write down the balanced dissociation equation and explicitly verify that every stoichiometric coefficient matches the power of its corresponding ion.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the balanced dissolution equation: .
Set up the reaction quotient with the stoichiometric exponent: .
Substitute the initial molarities: .
Compare to : since , .
Converted initial concentrations: , ; ; since (), precipitates.
02 The student forgets to divide the moles of CaCl₂ by the solution volume (0.5000 L) when calculating the molarity of Ca²⁺.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You set the molar concentration equal to the number of moles. Because the aliquot volume is (), you need to divide moles by volume ().
- Step 4Correct
You set up the correct equilibrium quotient expression, but substituting the uncorrected halved your final numerical value for .
- Step 5Correct
Your comparison logic and final qualitative conclusion are valid, although the numerical value of should be .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the concentration of fluoride from parts per million to molarity.
You correctly converted the mass of calcium chloride into moles of calcium ions.
You used the proper mathematical expression for the reaction quotient without doubling the concentration inside the brackets.
You correctly compared to to deduce that precipitation occurs when .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated moles () as identical to molarity (), missing the division by the solution volume.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisThe mistake stems from bypassing the definition of molarity () when adding a solute to a volume other than . Whenever an amount in moles is calculated, always divide by the total solution volume in liters before substituting into an equilibrium or reaction quotient expression.
REASONING PATH
Your ACEpath teacher’s suggested approach- Molarity Definition
Always check whether the problem specifies a volume different from before writing concentration brackets .
- Ion Product Substitution
Terms inside and brackets must strictly represent molar concentrations (), never raw mole quantities.
Verify units of every term substituted into : ensure each number is in rather than .
CORRECTED PATH
ACEpath Teacher's DemonstrationDivide the calculated moles of by the solution volume: .
Substitute the corrected concentrations into the reaction quotient expression: .
Compare the updated to : since , .
Converted concentrations: , ; ; because , precipitates.
03 The student misinterprets the precipitation condition as requiring Q < Ksp rather than Q > Ksp, erroneously concluding that no precipitate forms.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
Since , precipitates.
Although your inequality comparison is correct, you drew the wrong physical conclusion. When the reaction quotient exceeds the solubility product , the solution contains more dissolved ions than it can hold at equilibrium, so the system shifts toward solid reactant and a precipitate forms.
WHAT YOU DID WELL
Compliments from Your TeacherYou converted the mass-based concentration of fluoride ions into molarity accurately.
You correctly converted the mass of added to find the molar concentration of calcium ions.
You applied the correct reaction quotient expression and evaluated it properly.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeReversing the physical meaning of by concluding that no precipitation occurs.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the direction of shift for solubility equilibrium: the dissolution equation is written as , so when , the product ion concentration is too high and Le Chatelier's principle drives the reverse reaction to precipitate the solid.
REASONING PATH
Your ACEpath teacher’s suggested approach- Relate $Q$ to Equilibrium Direction
For , . If , products exceed equilibrium levels, shifting left toward solid precipitate.
Always picture the equilibrium arrow: when is greater than , think 'too many ions in solution excess ions must combine and precipitate out'.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the calculated value with : and , so .
Because , the ion product exceeds the equilibrium solubility limit (the solution is supersaturated).
Conclude that equilibrium shifts to the left, causing to precipitate.
Converted initial concentrations: , ; ; since (), precipitates.
Lock it in
For the dissolution equilibrium , what is the general expression for the reaction quotient ?
. Stoichiometric coefficients in the balanced chemical equation always become exponents in the and expressions.
Similar question
A solution is prepared with and . Given for , write the expression, calculate its value, and determine whether precipitation will occur.
Answer
. Since (), will precipitate.
An analyst mixes of with of . If for at , calculate the diluted ion concentrations, determine , and state whether precipitates.
Answer
Upon doubling volume, and . . Since (), no precipitate forms.
A wastewater stream at contains zinc ions at a concentration of (). If for , calculate and , determine , and state whether zinc hydroxide precipitates.
Answer
. At , . . Since (), precipitates.